Material with uniform resistivity p is formed into a wedge asshown in Figure P26.50. Show that the resistance betweenface A and face B of this wedge isLR= pInw(y2 – y,)Face AFace BFigure P26.50

Answered: Image /qna-images/answer/b37dc05c-dc31-4fe1-9b2e-ee83ce0af332.jpg

Answered: Material with uniform resistivity p is…

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 25P: A 12.0-V emf automobile battery has a terminal voltage of 16.0 V when being charged by a current of...

See similar textbooks

Similar questions

Two conductors are made of the same material and have the same length. Con- ductor A is a solid wire of diameter 1.0 mm. Conductor B is a hollow tube of outside diameter 2.0 mm and inside diameter 1.0 mm. What is the resistance ratio RA/RB, mea- sured between their ends?
Answer my physics question plz. A copper wire has a resistance of 50 ohms at 25°C (room temperature). The temperature coefficient of resistance for copper is approximately 0.0039 per °C. Calculate the new resistance of the wire when it is heated to 100°C.
A conductor of radius r, calligraphic length l, and resistivity rho has a resistance R. It is fused and formed into a new cylindrical conductor, one quarter the length of the original conductor. The resistance of the new conductor is
A 5-meter-long conductor wth the diameter of 5mm is connected to a source and an external resistance. The temperature of the conductor changes from 25 degrees to 35 degrees. Determine the resistivities and resistances at each temperature. Thermal coefficient of the conductor is 40 x 10-3 and the conductivity at 20°C is 2.5465 x 104 per ohm-meter.
A cylindrical copper cable 1.50 km long is connected acrossa 220.0 V potential difference. What should be its diameter so thatit produces heat at a rate of 90.0 W?
A wire of length L and cross-sectional area A has resistance R. What will be the resistance Rstretched of the wire if it is stretched to twice its original length? Assume that the density and resistivity of the material do not change when the wire is stretched.
An Iron wire at 0 Celcius has resistivity Ro. At which temperature the resistiv- ity of this wire will be 1.2R9. You can find the value temperature coefficients of resistivity from Table 25.2 from your book. Explain the physical mechanism of rising resistivity by the rising temperature.
What is the maximum power deliverable by a stack of 100 10YSZ cells to an optimum resistive load? Given each cell has open circuit voltage of 1.1V in series and the resistance is 17.78 ohms. The dimensions of the 10YSZ electrolyte are 0.1m x 0.1m x .0002m.
The next five questions use this description. Dry air is a pretty decent insulator; it has a very high resistivity of 3 × 10³ Q · m . Consider a capacitor that has square plates 15 cm on a side, separated by 0.8 mm of dry air. The capacitor is charged such that it has a potential of 320 V between the plates. First, what is the resistance of the volume of air between the plates in G2 (to 3 significant digits)?
Whale and Kanmuro are two islands located in the Chimera archipelago. These two are separated by a distance of 20 miles. A power link is to be established between them. The power link delivers a maximum power of 600 MW at full capacity with an operating voltage of 500 kV. Solve for the resistivity of the cable, assuming a conductor diameter of 1.5 cm. Express your answer in p0-m.
A conductor bar (o=5.8*107 S/m) of square cross section (DxD) has a circular bored along its length of L (m). Side length of square is D and diameter of circular hole is d. Find the resistance (R) in nano ohms between square ends for d=0.7 cm, D=4.9 cm and L=5.3 m. O a. 40612.76 O b. 30943.06 O c. 38678.82 O d. 34810.94 O e. 42546.70
e 9:06 52% *ll aO O DI 口 اختبار المد فيزياء عام. . . Imssb1.mutah.edu.jo A conductor has a cross- sectional area of 2.3x106 m2 and the number of free electrons per unit volume is 8.5x1028 electron/m3. When the current is 9 A, find the drift speed (in mm/s) of the electrons. Use the charge of the electron to be 1.6x1019 C. Select one: А. О.29 B. 28.77 C. 0.38 D. 37.77 E. 0.20 O

SEE MORE QUESTIONS

Recommended textbooks for you

University Physics Volume 2

Physics

ISBN:

9781938168161

Author:

OpenStax

Publisher:

OpenStax

Principles of Physics: A Calculus-Based Text

Physics

ISBN:

9781133104261

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

University Physics Volume 2

Physics

ISBN:

9781938168161

Author:

OpenStax

Publisher:

OpenStax

Principles of Physics: A Calculus-Based Text

Physics

ISBN:

9781133104261

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

Material with uniform resistivity p is formed into a wedge as shown in Figure P26.50. Show that the resistance between face A and face B of this wedge is L R= p In w(y2 – y,) Face A Face B Figure P26.50