An RL series circuit is connected to a 240 volt, 60 Hz line. The capacitor has a current of 1.25 amperes flowing though it. The XC of the inductor is 22 Ω. The resistor has a resistance of 16 Ω. How much voltage is dropped across the resistor?

An RL series circuit is connected to a 240 volt, 60 Hz line. The capacitor has a current of 1.25 amperes flowing though it. The XC of the inductor is 22 Ω. The resistor has a resistance of 16 Ω. How much voltage is dropped across the resistor?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 7RQ: An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a...

See similar textbooks

Related questions

Q: 7.4 The switch in the circuit shown has been closed for a long timebefore being opened at t=0.1. a) ...

A: At t = 0- , the circuit reduces as follows: Thus voltages across capacitors are calculated by...

Q: 31 The circuit shown in Figure P10.31 is a common-emitter amplifier stage. Determine the Thévenin eq...

A: The equivalent Thevenin's diagram after modification is given as hence the Thevenin's voltage is g...

Q: A dc voltage equal to Vdc V is applied to a resistor of R Ω. Asinusoidal voltage equal to vs V is al...

A: Calculating energy delivered to the resistor due to DC voltage source is VDC = Vmax. E=P×tE=V2DCR×tE...

Q: Electrons and holes are moving in a uniform, onedimensional electric ﬁeld E = −2000 V/cm. The el...

A: Given E=-2000 V/cmμn=700 cm2/V.sμP=250 cm2/V.sn=1017 /cm3p=103 /cm3 Calculating velocity of the elec...

Q: The transistors in the differential amplifier as shown have mismatched transconductances. Calculate ...

A: Differential mode input voltage vOD=-vId2-vegm+∆gm2R+-vid2-vegm+∆gm2RvOD=-gmRvid+∆gmRve At the emitt...

Q: 9.4 A 35HP, 225.35 volts DC shunt motor draws 135 amperes at full load and operates at 1893 rpm. The...

A: Given that Vt=225.35 VoltIfl=135 AN1=1893 rpmRf=300 ohmRa=0.3 ohmτ1=90 lbs-ft . ...

Q: 1. Floating Point Numbersa. Show the difference between IEEE 16, 32, 64, 128-bit floating-point numb...

A: Hello. Since your question has multiple parts, we will solve the first question for you. If you want...

Q: 2. A DC motor has the angular displacement-to-applied armature voltage transfer function: Om (s) 1 E...

Q: If the three inductors in Question 5 were connected in series, what would be the inductive reactance...

A: As given three inductors are in series, then their equivalent will be sum of all the inductances:

Q: Find Vo in the circuit below using the nodal analysis. Choose the correct answer (Hint: First find V...

A: To find the output voltage across the 6kohm resistor by applying the nodal analysis. Now, apply KCL ...

Q: How much resistance must be put in series with a 40-microfarad-capacitor connected to a 110 volt, 12...

Q: Circuits for • Solve the folbwing quanti ties listed./ RI R2 R2 R4 Given E= 150 VDC RI = 2.7 KA R2=3...

A: Solution: Given, R1=2.7 kΩ=2700 ΩR2=3.3 KΩ=3300 ΩR3=6000 ΩR4=3000 Ωand, E=150 V from the circuit,...

Q: a- Draw the block diagram of a load frequency control of a single area power system

A: Load-frequency control (LFC) : For large scale electric power systems with interconnected areas, Loa...

Q: How many armature conductors are there in a duplex lap-wound generator given the following informati...

Q: PrODien 3-12. Represent the signal x(1) = e d over the interval (-1, 1) using: (a) The exponential F...

Q: What are the switching thresholds and hysteresisfor the Schmitt-trigger circuit ?

A: Given a Schmitt trigger with Zener diodes connected at output Generally the output voltage of Schmit...

Q: The resistance and reactance per phase of the rotor of a 3-phase induction motor are 0.6 ohm and 5 o...

A: Given values, Rotor Resistance, R= 0.6 ohm Rotor Reactance, X= 5 ohm Induced EMF between slipring at...

Q: A 1-phase transformer is supplied at 1,600 V on the h.v. side and has a turn ratio of 8:1. The trans...

Q: Draw the circuit diagram of a simple voltage regulator.

A: Given: To draw the circuit diagram of a simple voltage regulator is shown as:

Q: as Guiven, mit) = Sin 4000ut, Ky = (4x105), kp= 20, ) Estimate BW g Pemito & Penlt). i) Wite ego q P...

A: Given: Modulating signal m(t)=sin4000πt, Am=1, fm=2000. Frequency deviation constants kf=4×105π, kp=...

Q: The current in the 4 ohms resistor in Fig.1 is ________A.

Q: A 4-pole, 3-phase, 50 Hz induction motor has a voltage between slip-rings on open-circuit of 520 V. ...

A: Given data: P=4f=50 HzX2=2.0 ΩR2=0.4 Ω The expression for the synchronous speed is given as, Ns=120×...

Q: A round underwater transmission cable consists of a core ofcopper wires surrounded by nonconducting ...

A: From the question we depicted the given data ; -Here x denotes the ratio of the radius of the core r...

Q: 1. For the circuit , find the steady-stateexpression for vo if ig=25 cos 50,000t mA.2. By how many ...

A: The inductive reactance is given by XL=jωL Put ω=50000 and L=4×10-3 H XL=j×50000×4×10-3=j200 Ω The c...

Q: Q4 Per given cignal, P(0 = jo Cos (wet + 0.5 Sin 2mt), ニ Colculate, i) (! ") freg. duiation, of in) ...

Q: Problem 75 An input voltage can be differentiated in time by the R following op amp differentiator c...

A: Note: We’ll answer the first question since the exact one wasn’t specified and data is also missing ...

Q: A high-speed CMOS microprocessor has a 64-bitaddress bus and performs a memory access every2 ns. Ass...

A: Given data: T=2 nsVDD=2.5 V a) The expression for the total capacitance is given as, C=Total numbers...

Q: Design a defferenbator for gren input signul and find out the olp Voltage.

Q: The current in and the voltage across a 5 H inductor are known to be zero for t≤0. The voltage acros...

A: a) The given data from the question is depicted below: 0≤t≤1s v=-100t1s≤t≤3s v=100t-20...

Q: In the circuit shown in , the initial currents in inductors L1 and L2have been established by source...

A: The initial current through the inductors is given as: i1=-8 Ai2=-4 A Inductors do not allow change ...

Q: An RBM potential relay with the number 128-122-2324K would have a continuous coil voltage of________...

Q: . During open-heart surgery, a defibrillator can be used to bring a patient out of cardiac arrest. T...

A: given that Path resistance R = 500Ω current I = 10 mA we need find out voltage applied V

Q: Question 5: A 3-phase thyristor ac regulator with an R load is changed form a Y connected load to a ...

A: Given that maximum load power is same for both star connected load and delta connected load. Load po...

Q: Draw the DC Machine and label its parts

Q: Use Thévenin's theorem to determine the voltage across the "RL". Draw the equivalent circuit diagram...

Q: Find the Z transform of the shifted unit step function u(n-5).

A: Solution: Let x(n)=u(n) From the definition of the Z transform, X(z)=∑-∞+∞ x(n)z-nso, X(z)=∑-∞+∞ u(n...

Q: Suppose that f(t)=f1(t)f2(t), where f1(t)=cosω0t,f2(t)=1,−τ/2<t<τ/2;f2(t)=0,elsewhere. Use con...

A: Given f1t=cosω0tf2t={1, -τ2<t<τ2,f2t=0, elsewhere Calculating Fourier transform of f(t) = f...

Q: A car lot uses incandescent lamps to supply outside lighting during the night. There are three strin...

Q: Find out the Z transform of the shifted unit step function u(n-10).

A: The shifted unit step function un-10 is defined as un-10=1 for n≥100 for n<10--->(1) The Z tra...

Q: In the circuit shown in Fig.1, the transistor has B=50. Find the values of VB, VE and Vc. If RB is r...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: What is the value of Rmin for the Zener voltage regulator circuit shown in 3.39 and 3.40? What is th...

A: According to question: E=20VVz=5VR=5kΩ∵ (RL)min=RVzE-Vz ∴(RL)min=5000×520-5=1.66kΩNow V=ERLRL+RWhe...

Q: Refer to screenshot

A: A)Small signal modelling

Q: What is the relation between the critical frequency and the maximum electron density?

A: The critical frequency (fc) of the ionosphere depends on the maximum electron density of the ionosph...

Q: A 10 kVA, 2000/400 V, single-phase transformer has resistances and leakage reactance as; R1 = 5.2 Ω,...

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
Two capacitors having values of 80 F and 60 F are connected in series. What is the total capacitance?
The circuit in Figure 24-2 is connected to a 120-V, 60-Hz line. The resistor has a resistance of 36 , the inductor has an inductive reactance of 40 , and the capacitor has a capacitive reactance of 50 . ET120VITZVAPFERIRR36PELILXL40VARsLLECICXC50VARsCC
Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
An R-L series circuit contains two resistors and two inductors. The resistors dissipate powers of 96 watts and 125 watts. The inductors have reactive powers of 100 VARs and 78 VARs. What is the power factor?
A pure capacitive circuit is connected to a 480-volt, 60-Hz power source. An ammeter indicates a current flow of 24 amperes. The circuit current must be reduced to 16 amperes by connecting a second capacitor in series with the first. What is the value of the existing capacitor? What value capacitor should be connected in series with the original capacitor to limit the circuit current to 16 amperes?
7. The resistor in an R-L series circuit has a voltage drop of 53 V, and the inductor has a voltage drop of 28 V. What is the applied voltage of the circuit?
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
What is the minimum AC voltage rating of each capacitor in Question 11?
A 22.5 ohm resistor and 5 mF capacitor are connected in series with a voltage source. If the capacitor is getting charged, what will be the time constant of the cirucit?
An RL series circuit is connected to a 240 volt 60 hz line the capacitor has current of 1.25 amperes flowling though it. the Xc of the inductor is 22 ohms. the resistor has a resistance of 16ohms. how much voltage is dropped across the resistor?