y MB Mc B C D A b a a D, Ay

Q: Two sides of a triangle measure 8 m and 12 m and the angle opposite the 8-m side is 30°, determine t...

A: Given  AB = 8m  AC = 12m  Angle C = 30⁰;

Q: The 5th and 8th term of a geometric progression is 16 and 128 respectively. Determine the first term...

A: To determine the first term of a geometric progression (GP) with given terms.   Given, 5th term = 16...

Q: by: 40 -60 MPa 0 -60 40 50 Determine the uni-axial tensile yield strength of the material according ...

A: 4.5) Given, Load = 450 N Length =0.25 m The width of the cantilever is t and height is 2t Tensile an...

Q: The volume of ocean water is 1338x10° km³. The runoff from rivers is 44.7 x10³ km³/year and the runo...

A: Hello dear this is the solution of your problem The answer is found to be Residence time =2646 years...

Q: 4m seawater (SG=1.031) A 60 2m

A:

Q: 9.) From a speed of 75kph, a car decelerates at a rate of 500 m/min along a straight path. How far i...

A:

Q: What is the acceleration of a body that increases in velocity from 20m/s to 40m/s in 3 seconds?(in m...

A: Step: 1           Velocity: - The rate at which body moves from one place to other place in a spec...

Q: Determine the cracking moments for the section shown if f. 27 MPа. C

A:

Q: Determine the forces and moment in each member of the multistory by portal method.

A: Given data in question  Dimensions  Loading  To find out  Forces and moments using portal method.

Q: indicated operation: (5+2i)+(7+4i)

A: Solution: (5+2i)+(7+4i) 5 + 7 = 12  (real part) 2i + 4i = 6i   (imaginary part) Thus,  Ans: 12 + 6i ...

Q: A 50 m tape of standard length has a weight of 0.05 kg/m, with a cross b) sectional area of 0.04 cm2...

A:

Q: 1. Draw the shear and moment Diagram of the beam. 45KN /m (10kn-m I1OKN- m ↑ 135KN 270KN 135KN 6m.

A:

Q: 1. If a cup of cream with a density of 1008 kg/m3 is turned into 3 cups of whipped cream, determine ...

A:

Q: 3. For the dam retaining water as shown in the figure, the foundation soil is permeable; assume hydr...

A: The unit weight of the concrete is γ=23.5 kN/m3.  

Q: A 1.60-m-tall person lifts a 1.65-kg book off the ground so it is 2.20 m above the ground. What is t...

A:

Q: WgvFANO PROBLEM 6:A gasoline line is connected to a pressure gage through a double-U manometer, as s...

A:

Q: A proposed road is to be built along a 15km stretch. The figures below show the profile and sections...

A:

Q: The cross-section of the two wooden members is a rectangle with a = 120 mm and b= 60. They are joine...

A: The given values are as follows,a=120mmb=60P=9kN(a) α=30°(b)α=45°To Determine,The normal and shear s...

Q: Example 18.9: A two hinged parabolic arch has a span 30 m and a rise of 7.5 m. The M.I. of arch sect...

A: The values given in the question are as follows The span of the arch(L)=30 m Rise of the arch(h)=7.5...

Q: 98 KN 42 KN 30 KN D 28 KN B Av = 2.65 m Ah = A E 1.10 m RG = 1.25 m 1.55 m AB = EG = BE= %3D BD = СЕ...

A:

Q: The height of an upright cone is h. It contains water to a depth of 1/3 h. What is the ratio of the ...

A:

Q: Explain the rationale or basis behind the provisions stated in Section 505.3 of 2015 NSCP Vol. 1 for...

A:

Q: expenses. This percentage is based on the ratio of the office’s area to the area of the home. A taxp...

A: Given, percentage deductible = office area / home area. Office area = 22 × 24 = 528 square foot. Hom...

Q: Find the total distance (m) traveled by a car from the time he saw a hazard until he applied the bra...

A:

Q: 12" Gage B Oil SG=0.92 Water 8" Gage A H Hg SG=13.6

A:

Q: Coefficient Permeability of Soil A falling head permeability test is conducted on silty soil. The s...

A:

Q: A circular pile is to be driven upto a depth of 10 m at a construction site. The average surface are...

A:

Q: 2. Suggest the alternatives for synthetic polymers which can have minimal impact to the environment ...

A: Biodegradable polymers are the best substitute for synthetic polymers. Biodegradable polymers are su...

Q: . The lateral area of a regular pyramid with a square base is 1120 cm2 and altitude of 20 cm. Comput...

A:

Q: What are your insights about The process of precipitation in hydrology? comments, and recommendation

A: Precipitation  It the rainfall in form of water, snow or hails etc. Hydrology is actually  based upo...

Q: 3. An ASTM A36 structural steel beam 5.00 m long is placed between two rigid supports. When the temp...

A:

Q: 14.  From a point on level ground 199 feet from the base of a tower, the angle of elevation of the t...

A:

Q: Solve the following problems. Provide complete solutions and summary of answers. The water table in ...

A:

Q: A sandy soil has a drained angle of friction of 32°. The deviation stress at failure is 400 kPa. 13...

A:

Q: ood post 12 in. by 12 in. is braced by four steel angles. The wood post and the pieces of angles are...

A:

Q: A ball is being pushed by a rod to move along the slot. It starts from 0 = 0°. If the rod moves at a...

A:

Q: Calculate the magnitude of the resultant force, FRin N, to the nearest 10th. Fluid: Oil with sg = 0....

A: To determine the magnitude of the resultant force on the window.   Given, Specific gravity of the oi...

Q: PROBLEM 1: A closed tank whose bottom is 18 inches in diameter is filled with three liquids: 4 inche...

A:

Q: A circular pile is to be driven upto a depth of 10 m at a construction site. The average surface are...

A: Given data, Length of pile =10 m Average surface area of the pile=2m2 per meter length Friction angl...

Q: determine

A:

Q: Question 5) A city population in years 1990 and 2000 is 120000 and 190000, respectively. Water deman...

A:

Q: ADJUSTED LATITUDE ADJUSTED DEPARTURE LINE +N +E -W AB 715.20 1200.53 414.29 1735.58 401.78 BC CD DE ...

A:

Q: A square footing of size 3 m x 3 m is located at 1.5 m below the ground level. The footing has net u...

A:

Q: 5. OMITTED Figures 3 and 4 are those o£ two closed traverses in the bearings of two adjoining sides ...

A: A closed traverse is a progression of associated lines whose lengths and direction are marked off th...

Q: 2. A simply supported rectangular beam, 2 in wide by 4 in deep, carries a uniformly distributed load...

A: Given data  Width of beam = 2 inch Depth = 4 inch Uniformly distributed load = 80 lb/ft Flexure stre...

Q: QUESTION: Based on the provided differential-type manometer, calculate the difference in the pressur...

A:

Q: 24 kN 36 kN 4 m 4 m 4 m 4 m 3 m 6 m Figure P-432

A:

Q: The velocity of water in a 2-cm-dia pipe is 20 m/s. If the pipe enlarges to 5-cm-dia, the velocity, ...

A:

Q: pump with a capacity of 100 gpm is needed to transport water to an elevated tank. Tank is designed w...

A:

Q: You are assigned to carry out a closed traverse survey on a piece of paddy field land filled with ba...

A: Given: A land area of approximately 70m X 80m Client has budget restraints and high accuracy is not ...

Matrix Algebra for Structural analysis

Structural analysis is a process in which the effects of different loads and internal forces, acting on structures and their elements are determined. This method of analysis is effective in detecting the failure loads of the structural elements and the design can be altered before commencing the construction process, which ensures proper strength and safety of the structures.