XSC1 ХВР1 Tektr IN OUT R4 12kQ 12V U1 C1 C2 5nF 5nF 741 V1 VEE R3 1Vpk 500HZ 0° 12kQ -12V RA 31KQ RB 135KQ +o

Q: 14. Given the shear modulus (G) for aluminum as 2.4e+10 N/m2 and the shear strain is given as 6e-5. ...

A:

Q: 1. Determine the output voltage for the circuit for each input voltage in (b). (c), and (d). The cir...

A:

Q: Draw the diagram of a halfwave power supply circuit and a fullwave  supply circuit. Aside from  the ...

A:

Q: Prof.of Material Sclance ( polymers] 100 Q Problem 1: Determine IB, IE, I10 k, VB, VC, and VE in the...

A: Given circuit shown    

Q: ww 20 =:45 Problem 5. Determine the value of Vo www Vo$50

A:

Q: Problem 4 A single-phase, 10KVA, 2200/220V transformer has the following parameters: R1=4.0 N, R2=0....

A: GIVEN:              KVA rating=10kVAV1V2=2200220VR1=4.0ΩR2=0.04ΩX1=5.0ΩX2=0.05ΩRc1=35kΩXm1=4.0kΩlagg...

Q: A boost converter with an input voltage of 5 V dc and an output voltage of 8 V dc will have a duty c...

A: Given a boost converter with, Input voltage, Vs=5 V Output voltage, Vo=8 V Duty cycle, α=?

Q: Ex (6):-. A television signal (video and audio) has a bandwidth of 4.5 MHz. This signal is sampled, ...

A: Given, Bandwidth of a television signal (fm) = 4.5 MHz Number of voltage levels (L) = 1024 Sampling ...

Q: 20x ix 10 2 8 A 12 8Ω VB Vc VA 1 )1A 5Ω. + +

A:

Q: After being open for a long time, the switch on the figure below is closed at t = 0. For t > 0 s, fi...

A:

Q: 7. If the base resistor of Fig. 4.118 is increased to 910 kῼ, find the new Q -point and resulting va...

A:

Q: T or F, modify the wrong part if False, please underline twice your answer if True or False.  Synch...

A: In this question we will write whether synchronous motor runs at constant speed or not at variable l...

Q: Question 12 Find Vod in the network in the figure. b 3k2 1 kn 18 v (+ 5 V Vpd V +1

A: Given,  

Q: with switch SW1 closed, current I, = 2A. With switch SW1 open, what is the Norton equivalent circuit...

A:

Q: R1 2 1k2 V1 +] 10V Si Vo 1kHz 0° Circuit A V5 1,

A:

Q: EX:(7):- Suppose that the spectrum of a channel is between 10 MHz and 12 MHz, and an intende capacit...

A: Capacity, C = 8 Mbps Bandwidth, BW= 12 MHz - 10 MHz = 2 MHz  

Q: Consider a 7-bit ADC and full scale voltage measurement range of (0-45).The Resolution will be O 0.3...

A: Given , Full scale voltage measurement range = (0-45) V Number of bits represents to each voltage le...

Q: rent with a frequency of 60HZ reaches its positive maximum of 20A at time 2ms. Write down the equati...

A:

Q: 20x ix 10 Ω 8 A VB 82 12 VA Vc Vx f 1A assume the following node voltages were obtained for the circ...

A:

Q: i̟ = Avin + Bv, What is the expression for A? What should be the condition for R,, R,, R3, and R4, s...

A: Use virtual ground concept.

Q: From Figure 3, write node-voltage equations: one for each input terminal of the op amp. o. The expre...

A:

Q: A zener regulator has an input voltage Vi of 50 V and the voltage across the load Vi is to be mainta...

A:

Q: R4 R3 Vo OA1 + R2 R1 RL VL + Vin

A: Use virtual ground concept.

Q: A thermocouple has an output e.m.f. as shown in the following table when its hot (measuring) junctio...

A: Given: A thermocouple has an output emf and temperature change are shown in table Temperature ( o...

Q: 3. A 0.20-m-long metal rod has a radius of 1.0 cm and a resistance of 3.2 x 102 What is the resistiv...

A:

Q: -5V 1.2 ka Si 2.2 kn 4.7 k2 Si -6 V (a) (b) FIG. 2.156 Problems 6 and 49.

A:

Q: Problem 3. Determine the total resistance across ab. R a R R, R R R min

A:

Q: Q2 Solve using Mason's gain formen 3 St3 -4 ReS) 1. St2 3.

A:   now let's move on to solve the problem with the above basics

Q: In Figure 2.1, with switch SW1 closed, current I, = 2A. With switch SW1 open, what is the Norton equ...

A: The solution is given below 

Q: 2 Determine Vo and Ip for the network si Ź2.5K 10MA そiSK2

A: Silicon diode is turns on when anode voltage  is greater than cathode voltage by 0.7 volts.  So repl...

Q: 5. Draw the logic circuit for the function f = y'z' + x'y' + x'y'z'

A: Given, f=y'z'+x'y'+x'y'z'  

Q: c). write the current equation for the circuit below 60 mA 20 mA Is 40 mA 30 mA Determine the missin...

A: Given: Circuit diagram

Q: 20x + ix 10 Ω 8 A VB 12 VA Vc 2Ω. 1 )1A Vx Figure 1 a. For the circuit shown, write out the equation...

A:

Q: Take a look at Figure 3. Please find the current through the segment of the bottom wire between the ...

A: Given circuit,

Q: 3. What is the maximum acceptable distance that a 14 AWG wire can safely carry a current of 15A from...

A: for 14 AWG copper wire, we need to find allowablr voltage drop and corresponding resistance. After t...

Q: (b) 2 4 R(s) C(s) -/-

A: In this question,  Reduce the given signal, and find the transfer function C/R?  We know closed loop...

Q: 2. A commonly used form of the one-dimensional discrete cosine transform is as follows: cos In this ...

A: Given, x = [0.5,0.2,0.7,-0.6,0.4,-0.2,1.0,-0.3]  

Q: Find the response i(t) of the RLC series circuit for t>0 R L t = 0 ll + V. C= v

A: Given RLC series circuit shown   

Q: In a DC motor, why forces are generated for parts of the loop and not for other parts of the loop. T...

A: Answer -  

Q: Note: All question solutions should be based on Ohm's Law and/or Kirchhoff's laws. A: Determine vo a...

A: Given:  

Q: Suppose a thyristor is triggered with a suitable value of gate current. The thyristor conduction is ...

A: In this question we will write why thyristor conduction maintained even the gate current is removed....

Q: II. FIND THE RECTANGULAR FORM OF THE FF: 4. 15ei25° 5. бе

A: Polar form is in the form of re^theta and reactangular form is rcos(theta)+jrsin(theta).

Q: R1 R2 Vo a) Use the impedance method to obtain the transfer function, Vols) / Vs(s), for the circuit...

A: Since you have asked multiple questions in a single request, we will be answering only the first thr...

Q: Define the Signum function.

A: In this case, the signum function is to be defined. 

Q: Design a bridge rectifier circuit to provide an output of 100 VDC. Calculate the diodes PIV rating a...

A: For full wave rectifier peak inverse voltage is Vm , peak value of secondary supply voltage. DC volt...

Q: T or F, modify the wrong part if False, please underline twice your answer if True or False.  A ser...

A: In DC series motor series field winding Carrie's current of armature. Series field flux is proportio...

Q: The electrons in the outermost orbital determine the physical and chemical properties of the element...

A: Yes outermost electrons of the atom will decide physical and chemical properties of the atoms 

Q: The electrons in the outermost orbital determine the physical and chemical properties of the element...

A: The electrons in an atom are distribute in different orbits. The electrons in the outermost orbit is...

Q: Draw a suitable circuit, which has the following Maxwell s loop equations. 121,-41-315 10 -41,+141-6...

A: We can use stnadard matrix form for the equation  There we can seperate self and mutual resistances ...

Q: A current of 5 A flows through a series circuit consisting

A:

Filter

A filter is a device or process which removes some of the unwanted features or components like frequencies from a signal in signal processing. The feature of filters is the complete or partial suppression of some part of the signal, and filtering is a class of signal processing. This most often means removing some frequency bands or some frequencies. In the frequency domain, the filters do not exclusively act, especially in the image processing field many other targets for filtering exist. Without having to act in the frequency domain, the correlations can be removed for certain frequency components and not for others. The filters are widely used in electronics and telecommunication, in television, radio, radar, audio recording, music synthesis, control systems, computer graphics, and image processing.