Answered: Write shortly about the instrumentation…

Write shortly about the instrumentation of FT-IR? Please shortly answer at your own words. Answer should be to the point.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 4. A 107.6 MHz carrier is frequency modulate by a 7-KHz sine wave. The resultant FM signal has a…

A: We need to analyse the given frequency modulated signal .

Q: modulation is used. Calculate (a) the frequency of the carrier crystal oscillator and (b) the phase…

A: A transmitter must operate at a frequency of 160 MHz with a deviation of ± 4 kHz.It uses two…

Q: Q2] Describe the image station problem in the supper-heterodyne receivers. How can we overcome it?

Q: GROUP (A) Q1/ An AM wave displayed on an oscilloscope has values of Vmax 8.6 and Vmin 2.5 as read…

A: Modulation The method of superimposing a low-frequency signal on a high-frequency carrier signal is…

Q: 7. The signal to be digitized could occupy the range of 70 ± 10 MHz or from 60 to 80 MHz. Calculate…

A: Given Fmax= 80Mhz Fmin =60Mhz Bandwidth (B.w) = ? Sampling rate(Fs) =?

Q: Explain Hartley configuration?

A: The circuit diagram of a Hartley oscillator is given as:

Q: discuss how the information signal is recovered from an FM signal using slope detector

A: Slope detector is a demodulation of frequency modulated signal. Frequency modulation is a angle…

Q: Choose the letter of the best answer in each question. The generated pulse of the transmitted…

A: a) make the returned echoes to distinguish from noise it is the wrong statement in the given…

Q: q4- In spread spectrum communications, a pseudo-noise (PN) sequence converts _______ signal to…

A: spread spectrum communications : Spread Spectrum refers to a system originally developed for…

Q: Estimate the real photoresistor range.

A: A photoresistor, also known as a light-dependent resistor (LDR), is a type of resistor whose…

Q: The primary benefit of PAL is having a programmable AND array and fixed OR array, that it was…

A: For the above given statement we need to justify it's correctness for the given concept PAL.

Q: Draw a block diagram of a detector for amplitude modulated signal.

A: Amplitude modulation: It is a system in which the peak amplitude value of the carrier signal is made…

Q: FM DEMODULATION Why is it necessary to recover the original information signal from the carrier?

A: By using modulation we sent our original signal from transmitter to receiver with the help of…

Q: What information can be obtained by result and analysis of "Enhance AM radio signal broadcasting"

A: AM broadcasting is radio broadcasting using amplitude modulation (AM) transmission . It was the…

Q: Q/ consider the amplitude modulation wave shown in figure below with a triangular envelope. 1. What…

Q: 1. Describe a Spectrum analyser? How does it work. What are its different ways by which we can…

A: working of the spectrum analyzer is explained as shown below

Q: 32. A high power microwave pulse of the order of megawatts can be generated by: a. Magnetron b.…

A: 32) A High power microwave Pulse can be generated by Magnetron. hence, option "a" is correct. a)…

Q: Q\ Compare between the method used to detect the FM signal (frequency Discriminator) and…

A: initially all three methods are explained individually . comparision sare done at the end.

Q: Calculate the Vp-p with a given 4div vertical deflection reading, 0.5volts/div and 10 probe…

Q: Phase shift due to finite length of circuit conductors. On a particular type of circuit board,…

A: Since one wavelength corresponds to the propagation delay of 360 degrees, that implies to a…

Q: (b) In an FHSS system, a hopping bandwidth of 120 MHz and a frequency spacing of 12 kHz is used.…

A: b) Given that, In a Frequency Hopping Spread Spectrum (FHSS) system has hopping bandwidth of 120MHz…

Q: When we can say to the beam of light coherent? What is the property of HE-NE laser? Define the beam…

A: 1. Two beams of light are said to be coherent when the phase difference between their waves is…

Q: Discuss the theoretical principles governing the propagation of electromagnetic waves in different…

A: The propagation of electromagnetic waves in different media is explained through several key…

Q: a. Find the frequency of 3 cm wavelength EM radiation. What band o phenomenon does this radiation…

A: According to the question we have to find the value of frequency.

Q: Noise is added to a signal in a communication system a. At the receiving end b. At transmitting…

A: The correct option along with the explanation is provided in the following section.

Q: For the reciprocity theorem we consider of response to excitation. a. addition b. subtraction C.…

A: The Reciprocity theorem states that if an EMF E is in a branch (a) of a reciprocal network produces…

Q: A resolver is to determine the distance D to the destination. Suppose the range R to the base…

A: Determine the resolver distance D:

Q: Explain the concept of electromagnetic interference (EMI) and radio frequency interference (RFI) in…

A: EMIDefinition - EMI refers to the interference or disturbance caused by electromagnetic radiation…

Q: How to get a stable source of light IN AFS? Please explain.

A: AFS is known as Atomic fluorescence spectrometry this is the process which is used for determining…

Q: A message signal has bandwidth of 1 kHz Hz to 21 kHz. It frequency modulates a 100 MHz carrier. The…

Q: What will be the radiation resistance of a quarter wave dipole antenna? Please show the calculation…

A: The radiation resistance for a dipole antenna can be expressed by the following equation: In this…

Q: Show with a diagram that FM and PM are equivalent and interchangeable. Briefly explain why the…

A: According to the question we need to show with a diagram that FM and PM are equivalent and…

Q: Problem 4 to separate ITU channel 59 using a fiber Bragg grating (FBG) and an optical circulator.…

A: Demultiplexer- It is a device which is used to dissociate various signal passing or received by a…

Q: Question # 1 In an air filed coaxial line operating with TEM mode, adjacent maximum and minimum are…

A: Given data, An air filled coaxial line operating with TEM mode has Vmax at x1=12.5 cmVmin at x2=37.5…

Q: Describe the image station problem in the supper-heterodyne receivers. How can we overcome it?

Q: find the system Noise factor and Noise Figure for Te = 30,50,75,150, and 300 K measured at To of…

A: Given: The effective noise temperature measured at reference temperature 290K is: Te=30, 50, 75,…

Question

Write shortly about the instrumentation of FT-IR? Please shortly answer at your own words. Answer should be to the point.

Expert Solution

Step 1

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

q4- In spread spectrum communications, a pseudo-noise (PN) sequence converts _______ signal to ______ signalSelect one option: a. unmodulated, modulated b. narrowband, wideband c. none of other answers d. wideband, narrowband
An optical fiber has a core radius 2µm and a numerical aperture of 0.1. Will this fiber operate at single mode at 600 nm? * Yes O No
13) Explain the nomenclature of additive white Gaussian noise (AWGN). the PSD and auto-correlation of the AWGN? What erf are
Question 3 a) For a single-frequency sine wave modulating signal of 3 kHz with a carrier frequency of 36 MHz, what is the spacing between sidebands? b) A carrier of 49 MHz is frequency-modulated by a 1.5-kHz square wave. The modulation index is 0.25. Sketch the spectrum of the resulting signal. (Assume only harmonics less than the sixth are passed by the system.)
please solve this important,thanks.
Kindly provide a COMPLETE and CLEAR solution. (Please write legibly) *Solve the following problem accordingly. Show your solution. *
Describe the difficulties in listening to a receiver without AGC.
Why is low-frequency operation the most reliable for TRIACs? Kindly provide a CLEAR and COMPLETE explanation
What range of % transmittance results in the smallest relative error for an instrument limited by (a) noise in the thermal detector of an IR spectrometer? (b) shot noise?
Please don't copy in other websites... I need correct answer please...
What is the relationship between a microstrip transmission line, attenuation loss and signal integrity?
1. A super heterodyne receiver is used to receive an FM signal in the range of 88 MHz-108 MHz with IF frequency 10 MHz. In order to avoid image frequency, what will be the maximum and minimum capacitance ratio at the local oscillator section. (high side tuned is used)?