Answered: Write short note on anode protection

Engineering

Mechanical Engineering

Write short note on anode protection

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Which of the following property the insulating material should possess to ensure gripping the cable?…

A: Which of the following property the insulating material should possess to ensure gripping the cable…

Q: 8) In direct current straight polarity (DCSP), electrode and work piece are connected to Positive &…

A: In direct current straight polarity, the work piece is connected to positive terminal and the…

Q: 9- Excess weld metal according to EN ISO 5817, t = 20.0 mm, measured : h = 6.7 mm b = 35.0 mm…

A: We can answer the first question since the exact one is not specified. Please resubmit the question…

Q: what is the smallest gage size copper wire that will limit the conductor voltage drop to 5v when 120…

Q: The alternating current produced by the AC generatoris rectified into DC, or direct current, through…

A: As rectifiers, transmission limiters, power supplies, switches, signal modulators, signal mixers,…

Q: explain what happened here.

A: Given: Load current - Voltage graph

Q: When the compressor and motor operate on the same shaft and are enclosed in a.common casing is known…

A: Semi hermetic sealed compressor is a device in which motor and compressor are enclosed in a two…

Q: 4-The magnetie horce per meter on awire is measured to be only 55% of t Maki mum possible Value…

A: When the current is perpendicular to the magnetic field, the force will be maximum. Fmaxl=IB The…

Q: What is the difference between Momentary Contact and Maintained Contact?

A: Maintained Contact means that when you push it on it stays on until you push it off and so on.

Q: How to adjust the timing by using timing light Explain preignition Explain detonation

A: How to adjust timing light by using timing light Preignition Detonation

Q: the operating speed of the relay not depend on Rate of flux built up Armature core air gap Voltage…

A: The operating speed of the relay depends on:- Rate of flux built up Armature core air gap Spring…

Q: Which solar cell is highly flexible

Q: What are the two types of wires and which is the mostcommonly used in automobiles?

A: There are mainly two types of wires are mainly Used in the industrial applications. The first is…

Q: If the spark line is totally flat, is longer than 2 ms, and is less than 500 volts, there is a good…

A: A sparkline is a line on a chart, that represents the time for which the spark lasts. The height…

Q: What are the functions (or names) of those power electronics devices (blank boxes)?

A: The electric vehicle system makes use of some of the most important power electronic components…

Q: Make a research topic and question about underground cables

A: Given Underground cable To find Research topic and question

Q: What are Ball and socket connections

A: The ball and socket connection also known as spheroid joint, is a type of joint in which the…

Q: A rotating magnetic field inside a set of conductingwires is a simple description of a __ .a. DC…

A: Given data : Rotating magnetic field

Q: What are some important considerations when performing a handgrip dynamometer test?

A: Soln:- The important consideration when performing a handgrip dynometer test :- 1.This instrument is…

Q: What is indicated by a reading of battery voltage on the ground side of a component?

A: Voltage, which is measured in volts, is the unit of current in your battery. If you imagine your…

Q: What does this symbol refer to? Correct formal name, shorter name, or name of typical use in circuit…

Q: Why do most automotive spark plugs have a resistor between the top terminal and the centre…

A: When the spark is produced during the ignition stroke of the automotive engine, a burst of the high…

Q: The _____________ between the windings of a transformer is the same. current induced emf voltage…

A: Transformer changes current and the voltage of a circuit but power (P=VI) remains constant. This is…

Q: What is the magnetic particle test

A: Magnetic particle testing uses magnetic fields to locate surface and near-surface discontinuities in…

Q: When the compressor and motor operate on the same shaft and are enclosed in a common casing is known…

A: This question is based on the concept of semi hermetic sealed compressor

Q: L. NI Hotor 3. True or false? A magnetic field opposing the stator's magnetic field is produced in a…

A: Lenz's law says that the direction of the electric current induced in a conductor by a changing…

Q: A relatively soft and ductile magnetic material from room temperature to 1414 degrees F. O Austenite…

A: Ans. FERRITE, Ferrite is soft ,ductile and magnetic in nature .

Q: Which one of the following is not true about electrochemistry? Group of answer choices It is a tool…

A: option b is incorrect. It is not the tool to characterize nano structures.

Q: A pocket milled in the base of part A. Design of ared which will articulatewith part Band which will…

A: To mill a pocket in part A(base) , one should be aware of the process of the pocket milling. Pocket…

Q: 4. In a home, do you think lights are wired in parallel or series? 5. Does Ohm's law apply to…

A: The answers are provided below

Q: Which of the following is a place where the TPMS antenna can be mounted? Under the passenger seat…

Q: Which one of the below is not the source of UV radiation? Sunlight Electric arc…

A: UV radiation is a form of electromagnetic radiation that comes from sun and some man made sources.…

Q: Explain with a diagram how the bimetallic temperature switch is use to measure

A: Bimetallic temperature switch to be explained with diagram for the measurement.

Q: State steps that should be taken to prevent a trip hazard due to trailing leads:

A: A trip hazard due to trailing leads occurs when electrical cords or cables are left trailing on the…

Q: failure Mode why bellows corrosion.cause of corosion bellows and their solutions

A: Given Bellow To find Cause of corrosion Solution to corrosion

Q: What is Anodizing process? O a. None of these O b. An oxidizing process used for Aluminium to…

A: option (b ) An oxidizing used for aluminium to provide oxide layer. is correct option

Q: What is Anodizing process? O a. The process of coating of Zinc by hot dipping O b. None of these O…

Q: PROCESS INSTRUMENTATION AND CONTROL Mention the level measurement system, which protects the DP…

A: Introduction; Differential pressure(DP) transmitter are used for measuring pressure reading.

Question

Write short note on anode protection

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Fabrication of Microelectronic Integrated Circuits

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Why is the procedure for checking the resistance of awaste spark ignition coil different from the proceduresfor checking other types of ignition coils?
Di ignition systems are capable of producing higher electrical energy than the DIS ignition systems. true or false
Two identical 115-volt light bulbsconnected in series with 240 voltswould __________.a. burn dimlyb. burn out immediatelyc. burn correctlyd. none of the above
What are the components of the fire triangle? What actions should be taken to stop the spread of fire?Discuss the correct way of using a portable fire extinguisher.
Wiring harnesses are typically shielded by plasticconduit. What color is normally used to shield SRSrelatedwiring?a. Blackb. Greenc. Yellowd. Orange
I need information how the Lamp will working in this block diagram
Describe the meaning of each part of the following FCAwelding electrode identification: E81T-5
What are the types for pressure-releasing circuits? Please explain their differences.
The TRIAC can be triggered on by applying voltage. a. A positive at the gate b. A negative at the gate How TRIAC is different from SCR? State your observations below. c. both a & b
Technician A says that a 12-volt light bulb that draws 12 amps has a power output of 1 watt. Technician B says that a motor that has 1 ohm of resistance has a power rating of 144 watts if it is connected to a 12-volt battery. Who is correct? Expert Answer
Why do some manufacturers protect the headlamp circuit with a circuit breaker instead of a fuse?