Write extensively on Hollow-Cathode Lamp and its uses.
Q: c) Choose the type of the FFs for the implementation. Give the complete state table of the sequence…
A: The Given is to considering 41 based 10=abcdefg base 2 To choose the type of the FFs for the…
Q: What is RF?
A: Given: RF The objective is to determine the RF.
Q: Q4: Find the energy stored in free space for the region 2mm <r<3 mm, 0 <0<90°, 0< < 90° given V =…
A: Given voltage expression, V=300 cosθr2 volt The region, 2 mm<r<3 mm, 0<θ<90°,…
Q: wo impedances, A and B, are connected in parallel across a 120 V AC supply. The total current and…
A: Power factor is the measure of the efficiency of the system, it is expressed as percentage, the…
Q: Write and verify an HDL structural description of the machine having the circuit diagram (schematic)…
A: Flip flop:- Basic flip-flop can construct by four NAND or four NOR gates. It maintains state until…
Q: A 230 V, d.c. shunt motor runs at 1000 r.p.m. on full load, drawing current of 10 A. The shunt field…
A:
Q: 16.a. Which one of the following leads on a dual-voltage motor serves as a motor terminal? A. T2 B.…
A: 16 a) T5 is the ANSWER none of the answer is correct.
Q: What is... The transfer function of a position control system is given by: Determine: a) Tp C(s)…
A:
Q: Q.6:- Draw the frequency response of the amplifier circuits and discuss the influence of the bypass,…
A: Given: Frequency response of the amplifier circuits Required: Influence of the bypass, coupling and…
Q: When the energy is equal to the Fermi level, the Fermi function is equal to: O a. 0.5 O b. none of…
A:
Q: Q8: Calculate the value of vector current density at P(2, 30°, 20°) if H= 1 ao sin 0
A: •Maxwell's equation for magnetostatics:- ∇×H=J The expression is the point…
Q: A/ For the half-wave rectifier of Fig. shown below, the source is a sinusoidal of 120 Vrms at a…
A: We need to analyze the given half wave rectifier circuit
Q: What determines the next state of a D-type flip-flop?
A: Given: D-type Flip-Flop Required: What determines the next state of a D-type flip-flop.
Q: Chorded windings are used in induction motors because they
A: Induction motor works on the magnetic induction principle. The induction motor always rotates less…
Q: The Fourier transform of a continuous-time function x(t) is X (f) = [² x (t) e-/12nft dt Choose A or…
A: For the above given signal we need to calculate its fourier transform and time and frequency domain…
Q: B) Calculate the reflection coefficient of the cavity reflectors for semiconductor laser with 500µm…
A: By considering the given values of initial and steady state gains of the semiconductor laser we need…
Q: Using Verilog continuous assignment statements or VHDL signal assignment statements, write a…
A:
Q: Find the Fourier transform of the signal shown in figure 2. Figure 2 2 x(t) 3.5 2
A: For the above given rectangular pulse we need to calculate fourier transform of it by using standard…
Q: Homework 8 (1) A two-level VSC with the switching frequency 6kHz, the AC line frequency is 60Hz,…
A: Note: We are authorized to answer one question at a time since you have not mentioned which question…
Q: A dc machine has 4-pole, wave wound armature with 46 slots and 16 conductors per slot. If induced…
A:
Q: The tap changer with inductive type of impedance uses high speed switching False True Earth relays…
A: 1. The tap changer with inductive type of impedance uses high speed switching. True or False Given…
Q: 15. An overhead line conductor has a cross-sec- tional area of 3.2 cm². It is supported on level…
A: Given an overhead line conductor has, Cross-sectional area, A = 3.2 cm2 Span length, l = 150 m The…
Q: Determine the remaining intensity of the light leaving through 8.3Km optical fiber if the…
A:
Q: Q4/:- For VCO-LO circuit block, if the message signal is the sine wave as shown in the figure below…
A: Frequency of message signal is: fm=1t=110-3=1KHz Message signal can be written as:…
Q: 10A 5 EMM 192 452 ww +Vx www 21a 652 +100V Determine the value for the voltage Vy using the…
A: Thevenin’s Theorem- Thevenin’s theorem states that it is possible to simplify any linear circuit,…
Q: Find: Ib, Ic, Vce, Vb, Vc, Vrb Vre, & Vrc Note: show your solutions no solution means wrong answers.…
A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part…
Q: 1.In digital modulation the information signal is one: A) sinusoidal B) sequence of logical ones and…
A:
Q: Q5. Draw the Bode Diagram for the transfer function below using straight line asymptote. Is it…
A: Our aim is to draw the bode diagram for the transfer function using sinle line asymptote by taking…
Q: EX: Calculate the value of vector current density ne". 6) In cylinderical coordinate at p (1.5, 90°,…
A:
Q: 2. Develop a simple ladder logic program that will turn on an output X if inputs A and B, or input C…
A: From the question, The Output is =X The inputs are(let say)=A,B or C which were taken to be in a ON…
Q: 17. If a 575-volt three-phase motor originally connected in 3-parallel △ is reconnected in…
A: 17) A 575-volt three-phase motor originally connected in 3-parallel △ Now it is reconnected in…
Q: A 60-Hz synchronous generator having inertia constant H = 5 MJ/MVA and a direct axis transient…
A:
Q: Q3) In a long-shunt compund generator, the terminal voltage is 230 V, when it delivers 150 A. The…
A:
Q: what are the circuit that used to convert PWM to PPM? 3:43 ✔
A: PWM:- Pulse width modulation (PWM) is modulation technique from which variable pulse width generates…
Q: /rite the required equation of the frequency response H(w) of the Ideal LPF ith drawing.
A: LPF: stands for low pass filter. It is a electronic circuit which allows the low frequency…
Q: The period of the signal x[n] = cos (a) N=12.6 (b) N = 63 (c) N=126 (d) Aperiodic signal San + sin…
A: Given data : The period of the signal xn=cos5πn9+sin4πn7
Q: Q4:- Find the Thévenin equivalent circuit for the network external to the resistor Rt for the…
A: Given data,
Q: Termination transmission line ideally O S 11 =0 O S 11 =1 O O S 11 = 00 S 11 = -00
A: Here, the objective is to determine the correction option.
Q: Calculate Fermi Function in the following scenarios: Energy level at positive infinity
A: Fermi function when the energy level at positive infinity....?
Q: Q4) A 220 V d.c. shunt motor has an armature resistance of 0.5 ohm, and runs at 850 rpm., When…
A:
Q: ix. What is the purpose of surge tank in hydro electric plant?
A: We are authorized to answer one question at a time, since you have not mentioned which question you…
Q: Q4: Show that the cut-off frequencies (We1 & Wcz) for the parallel RLC bandpass filter is given by:…
A:
Q: 9. Find the resistance of the box in this diagram. /- 2.5 mA E-18 V BOX
A: Given,
Q: Voltage (V) 2.0 3.5 5.5 7.5 9.0 11.0 Current 0.20 0.34 0.50 0.70 0.88 1.16
A: Given data, Voltage current table is given as, Value of direct measurement R=10 Ω
Q: Convolve the following continuous-time signals, assuming that Th=1 sec, and T=1.5 sec Plot the…
A:
Q: The OLTF of Ks (5+1) (5+2) [5+3) müll assumptates a unity feedback hove many towards infinity. CS is…
A: We need to find out number of asymptotes tends to infinity for given transfer function .
Q: a) Differentiate between FDM and TDM b) Assuming the channel BW of 250kHz. Find the number of…
A: PART-(a)-ANSWER Difference between TDM and FDM- Key…
Q: Write an HDL gate-level description of the circuit shown in
A:
Q: For the following reading of circuit current are [8, 8.2, 9, 7.8, 9.1, 8.5, 7.7, 7.9, 8, 8.1] mA.…
A:
Q: 14. The unit step response of an LTI system is given by g(t) = u(t)- 10u(t)et. Thus, the transfer…
A: Given data, g(t) =u(t)-10u(t)e-t
Write extensively on Hollow-Cathode Lamp and its uses.
Step by step
Solved in 2 steps with 2 images
- A. Explain the difference between charging current andfaradaic current. B. What is the purpose of waiting 1s after a voltage pulse before measuring current in sampled current voltammetry? C. Why is square wave voltammetry more sensitive than sampled current voltammetry?Do you understand the connection between a diode and an LED and semiconductors? Put the symbol and some background information on a graph?In terms of electronics, what purpose does light emitting diodes serve? and what are its application to everyday life.
- What is extrinsic semiconductor? Mention explain its formation with suitable diagram. (a) Write any five differences between Conductor, Semiconductor ind Insulator.Do you know how a diode and an LED are related to semiconductors? Put the symbol on a graph, along with some context?what is conduction current density
- How does a diode work in electrical circuits, and what is its construction? Explain the various types of diodes used in electrical engineering and their applications.(b) What is the reason behind few types of diodes to emit lights of different colors? Explain.Explain how diodes, photovoltaic cells, and light-emitting diodes work using the band theory of solids
- What's the connection between a diode and an LED and semiconductors? The symbol should be placed on a graph, with a brief explanation of what it means?What is the reason behind few types of diodes to emit lights of different colors? Explain.How do bypass diodes protect modules from damage and preserve power performance?