wooden storage vat full of liquid with specific gravity of o.75 is in the form of frustum of a cone, 1.5 m in diameter at the top, 3 m at the bottom, and 2 m high. It is provided with steel hoops, one at the top and one at the bottom. Determine: a. The hydrostatic force acting on the side of the container.  b. How high is the said force above the bottom

Q: Determine the hydrostatic force acting on the horizontal bottom and on the vertical ends of the…

A: Given : Depth of water = 5' Width = 8' Length = 10'

Q: The storage tank contains lubricating oil of specific weight (y). In one inclined side of the tank,…

A: As per our company guidelines we are supposed to answer ?️only first 3️⃣ sub-parts. Kindly repost…

Q: Determine the resultant force the ol 5m exerts on the semicircular surface AB. The tank has a width…

A:

Q: 3. An open vat holding oil (s=0.80) is 8m long and 4m deep and has a trapezoidal cross -section 3m…

A:

Q: A pipe line which is 6 m in diameter contains a gate valve. The pressure at the centre of the pipe…

A:

Q: Q.2 (a) In a vertical pipe conveying oil of specific gravity 0.8, two pressure gauges have been…

A:

Q: What pressure is required to reduce the volume of water by 0.6%? E= 2.2GPa

A: Given %change in volume ΔV/V*100 = 0.6 ΔV/V = 0.006 E = 2.2GPa We know bulk modulus is given k = -…

Q: 16. A rectangular block 2 m long, 1 m wide and 1 m deep floats in water, the depth of immersion…

A:

Q: Al m-diameter pipe bend shown in the diagram is carrying crude oil (S= 0.94) with a steady flow rate…

A: Given; 1m-diameter pipe steady flow rate of 2 m3/s Angle of 30°+ volume of oil in the bend is 1.2 m3…

Q: Fluid mechanics, pipe problem: The pipe shown has a 180o vertical bend in it. The diameter, D, is 1…

A: Determine the density of water using the relation;

Q: An open tank contains 9.4 ft of water beneath 1.8ft of oil with specific gravity of .85. Find the…

A: Pressure is given byP=Sγw×zS=Specific gravityγw=Unit weight of waterz=depth

Q: liquid on the gate Determine the distance of the force from the hinge A How much force, F, applied…

A:

Q: 2. Determine the absolute pressure of the water in the pipe at B if the tank is filled with crude…

A: Patm =101kPa H=0.6+0.4+0.5 H=1.5m

Q: d, = 500 mm 0 = 45° P1 = 40 kN/m? Control Volume dz =, 250 mm P2 = 23 kN/m2

A: Given data  Diameter  Discharge  Angle Pressure    We will use Momentum equation to solve this…

Q: A pipe conveys water with velocity 360 m/min and pressure gauge shows 5 bar pressure under which the…

A:

Q: What is the capillary rise "h" of water inside the space between two concentric cylinders? Let the…

A: Capillary rise : capillary rise is the rise in liquid level due to action of adhesion or cohesion…

Q: a) Determine the hydrostatic force (in kips) acting on the dam. b) Determine the moment of inertia…

A: We will solve this question in step no. 2

Q: Force P on plastic bar - Inner plastic bar -Outer cast iron bar PROBLEM 1.7-4 (a) What is the…

A:

Q: The figure is a section of a masonry dam resting on a previous foundation and subjected to water…

A:

Q: Q#1: The strength of the longitudinal joint is 25 kips/ft, whereas for the girth joint it is 20…

A: Longitudinal joint strength=25 kips/ft Girth joint strength=20 kips/ft Cylindrical tank internl…

Q: Problem 1 Given: Mass of canister: 4000 kg Mass of beam BD: 50 kg Max allowable force:

A:

Q: A 300 mm cast-iron pipe is discharge 120 lit/sec. At a point 200 m from the reservoir the center of…

A: Given:       Discharge through a 300 mm cast-iron pipe = 120 lit/sec.                  At a point…

Q: Oil (SG oil = 0.95) flows at 200 L/s through a 200mm diameter pipe, 500m long. Friction factor is…

A:

Q: Two new cast iron pipes in series connect two reservoirs. Both pipes are 300m long and have…

A:

Q: Question 49/50 Determine the Reaction at B. O 0.236 kN O 0.125 kN O 0.417 kN O 0.652 KN Previous…

A:

Q: he rectangular bin with an inclined gate AB is filled with oil to the depth shown. Determine the…

A: This question belongs to subject fluid mechanics. In this question we find out resultant force on…

Q: An upward flow of oil (mass density 800 kg/m°, dynamic viscosity 0.8 kg/m-s) takes place under…

A: Mass density of fluid (ρ) = 800 kg/m3 Dynamic viscosity (μ) = 0.8 kg/m-s Diameter of pipe (D) = 0.1…

Q: 2. The suction pipe of a pump rises at a slope of 3 vertical in 4 along the pipe which is 12 cm in…

A: To find Maximum discharge that the pump may deliver?

Q: An upward flow of oil (mass density 800 kg/m3, dynamic viscosity 0.8 kg/m-s) takes place under…

A:

Q: Oil surface 2.1 m Water surface Oil 0.9 m Hinge Water 1.8 m

A:

Q: A pipe of 0.7 m diameter has a length of 6 km and connects two reservoirs A and B. The Ans water…

A:

Q: he diameter of a pipe changes gradually from 6 inches at A to 18 inches at B. A is 15 ft lower than…

A:

Q: 2–126. The raft consists of a uniform platform having a mass of 2 Mg and four floats, each having a…

A: Introduction - The Mechanical float switches feature a basic operation that detects water levels by…

Q: es at entrance and exit of conical daft tube are y the entrance of draft tube. Assume friction lo…

A:

Q: 4. A beaker of height 10 cm is half-filled with water (Sw = 1) and half-filled with oil (S, = 1). At…

A:

Q: vertically into a body of water with open end down and floats with a 1300 N block of concrete (SG =…

A: D=350mm h=1.8m

Q: Water 6 m F₂ Figure la F₁ 2 m Gate m

A:

Q: The figure is a section of a masonry dam resting on a previous foundation and subjected to water…

A:

Q: 1. A cylindrical container 8 ft. high and 3 ft. n diameter is reinforced with two hoops a each end.…

A: From given data a.) The expression for hydrostatic force is given as F=γ.h.A Substitute the value…

Q: 600 mm 600 mm Solve for the following buoyancy problems: 1. Water in the container is originally at…

A:

Q: Determine the volume of the storage tank.

A: Consider the figure shown below. Segment A (ft2) r (ft) rA (ft3) 1 0.5 x15 x 4 = 30…

Q: 3 m diameter , 7 m long cylindrical tank is completely filled with water. The tank is pulled by a…

A: Pressure is generally the force per unit perpendicular area over which the force is applied and…

Q: Two tanks A and B are connected by a pipe 30 m long. The first 21 m has a diameter of 75 mm and then…

A:

Q: A vertical gate 2m wide and 6 m high is located at the side of a large tank and was hinged at the…

A: Peessure at the centre of gravity of the gate 0.84×γw×4-18.7514.2116 kpaTotal hydrostatic…

Q: The height of the reinforced concrete water dam in the figure is L width a. The unit weight of the…

A: Unit weight(γ)=24 kN/m3, Lateral water trust(H)=5h2 kN/m, Length(L)=15 m, a=7m.

Q: Oil (µ = 0.35 Pa-sec) flows through a horizontal 20 cm diameter circular pipe. The velocity at any…

A: Given data in question  Dynamic viscosity 0.35 Pa - sec. Equation of velocity is given Radius of…

Q: The figure is a section of a masonry dam resting on a previous foundation and subjected to water…

A: Weight of Dam portion-1=8×12.4×9.81=188.352 kN/mWeight of Dam portion-2=4×12.4×9.81=94.176…

Q: The figure is a section of a masonry dam resting on a previous foundation and subjected to water…

A:

Q: A solid right circular cylinder is vertically submerged in saltwater. Due to the buoyant force, the…

A: