wo students measured the density of water three times each. Their results are shown below. Trial Student 1       Student 2 1 0.953 g/mL          1.102 g/mL 2 0.949 g/mL          1.005 g/mL 3 0.956 g/mL          0.901 g/mL 9. Calculate the standard deviation in the measurements for student 1 and then do the same for student 2. Show your work

Q: The additive in gasoline was measured 16 times to give a standard deviation of 0.24. The standard…

A: GivenNo of times measured = N = 16Standard deviation = S.D. = 0.24Standard deviation of the mean is…

Q: The scatter of replicate measurements may be expressed by: Accuracy 2. O Standard deviation 1. 3. O…

A: When we obtain data which is highly scattered, the analytical tool we can use standard deviation.

Q: Chromatography is done on a mixture containing a drug. The drug has an R value of 0.66. The diagram…

A: The question is based on the concept of chromatography technique. Rf value is defined as the ratio…

Q: 2.Based on the data, calculate the mean value of the mass of 15 mL of ethanol. Calculate the average…

A: Formula :-  Mean = sum of all value / n  Where n is number of values

Q: Consider the following two standard deviation values: 0.100 grams/mol and 1.00 grams/mol. Which of…

A: Standard deviation is defined as the variation of a quantity from its recorded mean value. It is…

Q: State whether the errors in (a)–(d) are random or systematic: a. A 25-mL transfer pipet consistently…

A:

Q: Shown is a thin-layer chromatography (TLC) plate. In this case, a student decided not to line up the…

A: The R f factor is called retention factor. The expression to find out R f factor in thin layer…

Q: Use the "Statistics" function of your calculator to find the mean and standard deviation for the…

A: Ans. Mean and Standard deviation according to statistic calcultor Mean = 68.7 inch  Standard…

Q: Scenario: The student is asked to measure 9.20 mL of potassium permanganate solution using a 10-mL…

A: A numerical problem based on quantitative analysis, which is to be accomplished.

Q: The percent relative uncertainty of a buret reading of 24.35 ± 0.02 is: The choices are : A.…

A: Introduction: We have to calculate the uncertainty of a buret reading of 24.35 ± 0.02 .

Q: The picture says my question

A: #1. Your answer to 1 is right.

Q: determine the organic material in a dried lake bed, the percent carbon by mass is measured at two…

A: Given that  the percent carbon by mass is measured at two different locations

Q: c Calculate the standard deviation for each set of data. The average value for Method A is 2.3 g/cm…

A:

Q: You are trying to determine the caffeine content of brand X coffee using HPLC-UV/VIS analysis. You…

A: Mean is the average of the numbers, i.e., add up all the numbers, then divide by how manynumbers…

Q: standard deviation

A: If there is two results having standard deviation Sa and Sb. Therefore standard deviation indicate…

Q: A series of standards were analyzed which gave the following results SOLUTION % Transmittance  0 mL…

A: Beer-Lambert Law: The absorbance (A) is proportional to the concentration (c) of the solution and…

Q: Q2/ The average teacher's salary in a particular state is 54166. If the standard deviation is 10200,…

A: Solution - According to the question - Given - Solution:Given that mean = 54166, sd = 10200 Z =…

Q: Date Wednesday, November 20, 2019 9:59 AM 1017 100 95- 9어 85 8어 75 3277.4 7어 1448.4 65 1367.9 2936.2…

A: Some important IR peaks of 4-tert-butyl cyclohexanol are discussed below :  A. Broad medium peak at…

Q: Wallie weighed 3 different cylinders that all looked the same. He noticed that the masses were all…

A:

Q: An analysis of city drinking water for total hardness was done by two students in the laboratory and…

A: Note: Since  you have posted question with multiple parts, we will solve only first part for you. To…

Q: where the uncertainties are all standard deviations for infinite -sized samples. How will you report…

A: P = (4.75 +- 0.03) - (0.1198 +- 0.0008)(15.00 +-0.04)(14.01)*(100) / (750.0 +- 0.3) = (4.75 +- 0.03)…

Q: You conducted 3 gravimetric determination trials. The average values are: 3.45g, 3.55g, and 3.35g.…

A: Gravimetric analysis:  This kind of analysis in chemical science has the application in determining…

Q: You measure 35 turtles' weights, and find they have a mean weight of 72 ounces. Assume the…

A: True population mean turtle weight =  72 ± 1.35

Q: Concentration 3006 2901 2892 Absorbance std 0.540 0.540 0.540 Absorbance sx 0.555 0.526 0.540 100.3…

A: Here for calculation of % potency one has to put all required data on that formula and compute .

Q: The density of an irregular shaped object was measured three times with the following results: 2.15…

A: Standard deviation: The dispersion of a group measured values from the average value can be known by…

Q: A student determines the concentration of an unknown sample using two different methods. Each method…

A: Comparing the given data by creating a comparison table: Observations Method 1 Method 2…

Q: Use a spreadsheet to calculate the mean and standard deviation of the data set. 54.99, 54.40, 54.60,…

A: Given - expected values are 54.99, 54.40, 54.60, 54.63, 54.36

Q: What is the relative error in the ppt of the following data if the accepted value is 70.05 M? 70.24…

A:

Q: 9) The following results were obtained in the determination of Vitamin E mass in tablet samples.…

A:

Q: A method of analysis yields masses of gold that are low by 0.4 mg. Calculate the percent relative…

A:

Q: Calculate the standard deviation of the four trials below.  Trial 1: 49.59 grams Trial 2: 51.25…

A: X                     X^2  49.59       2459.1681 51.25       2626.5625 49.78        2478.0484 50.19…

Q: Construct a calibration curve: (a) Subtract the blank value (9.1) from all other values (this means…

A: (a)       Slope = 874.05 ± 10.62       Intercept = - 29.61 ± 9.65 Calculation table vol %…

Q: 3. Two laboratory staff titrated a 50.00 mL of hydrochloric acid with an unknown concentration with…

A: Smaller the standard deviation of a data set, more precise is the measurement. A more accurate…

Q: A student determines the concentration of an unknown sample using two different methods. Each method…

A: Formation of comparison table for comparing the given data of both the methods: Observations…

Q: If the actual value is 100 and the measured value is 99 then the percent error is---- O 0.1 O 2% O…

A: We can calculate percent error by following formula percent error=Actual value-Measured vaueactual…

Q: With the information from my pictures please help me with the following: 1. Volume at Equivalence…

A: From the titration curve we can figure out equivalence and half equivalence point volumes. Note: As…

Q: Two methods were used to measure the arsenic level (ppb) in drinking water. Quantity Mean arsenic…

A: First, we need to calculate the F value and T-value, and compare the standard deviations for the two…

Q: find absolute and relative standard deviation of this data.

A: Absolute standard deviation is the measure of the deviation of each data point from the mean value.…

Q: Trial 1: 9.865 g Trial 2: 9.996 g Trial 3: 9.563 g Trial 4: 9.658 g Trial 5: 10.235 g Select…

A: Standard deviation (S) is a measure of precision. This quantity is obtained by the summation of the…

Q: Which is true for standard deviation (s) for a sample size (n)? A The greater the n, the smaller the…

A: Standard deviations decreases, with the increase in the sample size.

Q: Three trials for this experiment had been conducted and the following are the masses of limiting…

A: Solution -

Q: Glucose levels are routinely monitored in patients suffering from diabetes. The glucose…

A:

Q: Calculate the standard deviation for the answer of the following mathematical operation. The number…

A:

Q: Location 2 To determine the organic material in a dried lake bed, the percent carbon by mass is…

A: As per our company guidelines we are supposed to answer first three sub-parts only. Kindly repost…

Q: Data Sheet Extraction ODD EVEN ODD EVEN GROUP   Single Extraction 1 Single Extraction 2…

A: Ans) Multiple Extraction 1 Multiple Extraction 2

Q: Convert your average ppm concentration (and standard deviation) of Ca from the ISE measurements…

A: "Since there are multiple sub-parts in this question and it is not mentioned that which one has to…

Q: You pipette and weigh a 100 ml sample of water & get the following results for 3 trials: 0.1041g,…

A: A question based on tools in analytical chemistry that is to be accomplished.

Q: Estimate the absolute deviation(or uncertainty) for the results of the following calculations. Round…

A: Thank u for your question, answer is attached below.