Answered: with the For a…

with the For a poly(hexamethylen-adipamide) polymerization degree of 200, write the structure and compute the exact and approximate molecular mass.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Related questions

Q: Show three units of a linear silicone polymer made from (CH₃)₂Si(OH)₂ with some (CH₃)₃SiOH added to…

A: These linear silicone polymers are used as silicone caulk and adhesives. It is also used as…

Q: Under the same environmental conditions, does benzene or toluene have a higher mass transfer…

A: KA= mass transfer coefficient [mol/(s·m2)/(mol/m3)], or m/s

Q: The degree of polymerization determines the weight of polymer True O False Combustion reaction to…

A: Degree of Polymerization It is the number of monomer units in a polymer.It is calculated as ratio…

Q: Poly(vinyl alcohol), a hydrophilic polymer used in aqueous adhesives, is made by polymerizing vinyl…

A: Poly vinyl alcohol (PVA) cannot be prepared by direct polymerization of vinyl alcohol. Its synthesis…

Q: In a non-acid catalyzed step-growth polymerization between A-A and B-B monomers, the A groups are…

A: The term degree of polymerization (DP) refers to the number of monomeric units in a polymer chain.…

Q: Outline the experimental method used to prepare Hydrogels/ Cryogels by Free Radical Polymerization…

A: Given information, Preparation of Hydrogels/Cryogels by free radical polymerization technique in the…

Q: d) Provide the structure for the chain end group X that would result from chain termination through…

A: d)Detail solution is given in below step e.) Branched polymers form due to increased termination…

Q: Chain-growth polymerization is a polymerization process that where unsaturated oligomers molecules…

A: Answer: FALSE Chain-growth polymerization is a polymerization technique where unsaturated MONOMER…

Q: Measured values at present indicate that the chain. . of polyethylene can be higher than 280 GPa.

A: Measured values at present indicate that the chain modulus of polyethylene is certainly higher than…

Q: Producing a polymer part whose medium of use will be water at a constant temperature of 90°C is…

A: The above mentioned polymer chain has a repeating unit which contain amide group. Amide are formed…

Q: #7: Draw/sketch representative structures for (a) homopolymers, (b) alternating copolymers, (c)…

Q: CH, foom (G) 0-CH-CCH,-0-C- CH3

A: Given Polymer

Q: Another vanation on this type of polymer is used in hair gels. In these, the polymer chains are…

A: As you have posted a question with multiple questions, we will solve the first question for you. To…

Q: What is charge transfer mechanism in N type doped polyaceteylene? Explain!

A: It is organic polymer. The repeating unit is (C2H2)n. The IUPAC name is polyethyne.

Q: Write the chemical structure of the alternating copolymer which is synthesized by the…

A: An alternating copolymer is a copolymer comprising two species of monomeric units distributed in…

Q: Expalin that- A tri-bi functional monomer system gels at about 83% conversion during polymerization.

Q: In this compound polymerization isomerism present or not?? Can we get 2:6:3 as simple ratio? [cog…

Q: Define a polymer and describe why using a structural formula would be useful when representing the…

A: The detailed explaination to the above question is given below step

Q: Ver age molecular w levage moleculow w Polymerization. .16 0,28 0.20

A: 1) Number-average molecular weight MN¯ : MN¯ = n1M1 + n2M2 + n3M3 + ....n1 + n2 + n3 + .... 2)…

Q: #7: Draw/sketch representative structures for (a) homopolymers, (b) alternating copolymers, (c)…

Q: The mechanism given for cationic polymerization of isobutylene shows that all the monomer molecules…

A: During polymerization, the chain reaction involves the intermediate formation, which may be a…

Q: For the free radical polymerization of the monomers below, provide the polymer repeat unit. Provide…

Q: Polymers prepared by condensation polymerization are usually of high molecular weights, but the…

A: Condensation Polymerization is an of Step growth polymerization, where smaller molecules are removed…

Q: Poly(ethylene terephthalate), known as PET or industrially as Dacron, is a polyester synthesized…

A: Ethylene glycol has alcohol functional group Terphthalic acid have Carboxylic acid They both combine…

Q: (a) A sample of linear polyethylene is dissolved in a large excess of xylene at 130 C, and dilute…

A: (a) The fine white suspension obtained after cooling the diluted solution of linear polyethylene in…

Q: Give a schematic drawing of a linear, branched and cross-linked polymer, as well as an isotactic,…

Q: One of the polymers that exhibit tacticity is polypropylene. Show the structure of atactic,…

Q: Investigate and explain two experimental methods to measure the molecular ` weight distribution of…

A: Concept Introduction: The molecular weight of a polymer is not fixed. It has a certain range under…

Q: The number-average molecular weight of a polypropylene is 1241772 g/mol. Compute the degree of…

Q: Use mechanisms to show how monomers polymerize under acidic, basic, orfree-radical conditions. For…

A: Polymer - are the very large macromolecules. Monomer-it is the smaller unit or repeating unit.…

Q: (i) Calculate the stoichiometric imbalance factor in a polymerization reaction between adipic acid…

A: The stoichiometric imbalance factor (SIF) can be calculated using the following formula: SIF =…

Q: How might you determine experimentally whether a particular polymerization is propagating by a…

A: Given polymerization process, Step-growth or chain-growth polymerization. In step-growth…

Q: 1) Discuss how polymerization changes the properties of any ensemble of amino acids so that a…

A: Proteins may be defined as compounds of high molar mass consisting largely or entirely of chains of…

Q: Polymer X was copolymerized with butadiene to produce the elastomeric material that can be used to…

A: To find out the average molecular weight of a copolymer given that the polymer is formed by the…

Q: At room temperature, classify the following materials as elastomers, TP or TS polymers: a) a lightly…

A: Elastomers are polymers that have both viscosity and elasticity. They also have weak intermolecular…

Q: Which of the following statement/s is/are true for free radicalic polymerization? I. It involves…

A: Free radical polymerization is generally occur in addition polymerization reaction. There is 3 basic…

Q: Explain the following observations: (i) Kevlar has an extremely high tensile strength and melting…

A: To explain the given observations:

Q: Determine the degree of polymerization of polypropylene having an average molecular weight of one…

A: Given the average molecular weight of polypropylene = 1 million or 1*106 g/mol

Q: Poly(vinylidene chloride) Monomer - vinylidene chloride Use- packing of poultry,cured…

A: Polymer polyvinylidene.

Q: the production of vinyl polymers using bulk methods

Q: Assume that you are conducting a chain-addition polymerization using 5.15 grams of monomer (MW=…

A: We need to find the expected number of repeat units per chain. Masses of monemers are given. This…

Q: Molecular weight of a condensation polymer hardly increases if the reaction is stopped either at 45%…

A: condensation polymer It is also known as step growth polymer. The condensation polymer are formed…

Question

with the
For a poly(hexamethylen-adipamide)
polymerization degree of 200, write the structure
and compute the exact and approximate molecular
mass.

AI-Generated Solution

AI-generated content may present inaccurate or offensive content that does not represent bartleby’s views.

Unlock instant AI solutions

Tap the button
to generate a solution

Click the button to generate
a solution

SEE SOLUTION

Similar questions

(a)Is this a condensation or addition polymer? Explain how you know. (b) Provide the IUPAC name of the monomer that does not contain the benzene group.
(a) Compute the repeat unit molecular weight of polybutene unit chemical formula =( C8H16) (b) Compute the number-average molecular weight for a polybutene for which the degree of polymerization is 24,000.
Describe how the stereoisomerism affect the degree of crystallinityof a semicrystalline polymer such as polyethylene
Compute the repeat unit molecular weight for poly(methyl methacrylate).
Monomers/initators used in free radical polymerization i) What monomer can be used with benzoyl peroxide and under what conditions? ii) What monomer can be used with di-tert-butyl peroxide and under what conditions? iii) What monomer can be used with hydrogen peroxide and under what condition?
d) Early in the polymerization at lower conversion of the MVK monomer, the polymer chains formed are primarily linear. However, close to the end of the reaction, as most of the monomer is consumed, branched polymers may start to appear. Propose a possible rationale for the formation of branched polymer structures (hint: consider the types of termination reactions that may compete with polymerization when only little monomer is still present). 로 3 3 linear vs. branched
1. What is Tacticity, show syndiotactic, isotactic and atactic polymer. Which is easiest to crystallize and why.
What is Macromolecular hypothesis, what is contribution of Staudinger, Carothers, and Paul Flory to Polymer science.
Determine the change in kinetic chain length if the concentration of monomer decreases by 6.5 and the concentration of initiator increases by 4.9 during chain polymerization? 9.29 14.39 31.85 2.94
f. An alternating copolymer is known to have a number-average molecular weight of 250,000 g/mol and a degree of polymerization of 3500. Compute the repeat unit molecular weight of copolymer.
The number average molecular weight of polymer A reaches 16000 g/mol at the percent conversion of 92 %. What would be the stoichiometric imbalance factor in this polymerization? Given that the molecular weight of the repeating unit of this polymer A is 113 g/mol
Do