wire sample (1mm in diameter by 1m in length) is placed in an electrical circuit at 20°c. A voltage drop of 432 mV is measured across the length of the wire as it carries a 10 A current Calculate the electrical conductivity

wire sample (1mm in diameter by 1m in length) is placed in an electrical circuit at 20°c. A voltage drop of 432 mV is measured across the length of the wire as it carries a 10 A current Calculate the electrical conductivity

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter12: Batteries And Other Sources Of Electricity

Section: Chapter Questions

Problem 14RQ: 14. A 6-V lead-acid battery has an A-hr rating of 180 A-hr. The battery is to be load-tested. What...

See similar textbooks

Related questions

Q: A 1,000 – ft length of copper wire (ρ = 10.37 Ω − CM⁄ft) has a resistance of 40.8 ohms. What would…

A: A network problem on finding resistance. Look below the explaination..

Q: A coil of wire of resistace 50 ohm is embeded in a block of ice. What is the amount of ice melted in…

Q: An electric heater contains 40 litres of water initially at a mean temperature of 15° C. The heater…

Q: The technique for measuring specific heat that involves heating a material, adding it to a sample of…

A: The correct answer is d.

Q: Total charge entering a terminal is given as q=5tsin40t mC. Calculate the current at t=0.5 s.

A: Given; q=5tsin40t mCt=0.5 s

Q: A 5m of aluminum wire, whose diameter is 0.7 in., has a resistance of 0.18 Ω at 20°C. What is its…

Q: Typical replacement for a 100 W incandescent bulb is a 20 W LED bulb. The 20 W LED bulb provides a…

A: Given, Rating of incandescent bulb is 100 W. Rating of LED bulb is 20 W. The bulb is turned on…

Q: The length and dismeter of a copper wire are found to be 100 and 0.002 m, respectively. Consider…

Q: If, for the construction of this potentiometer, a wire with a diameter (

A: Given parameters are: Diameter of a wire: d=0.1mm=0.1×10-3mResistivity of Copper ρe=1.7×10-8ΩmCore…

Q: When a current of 2 A flows for 3 micro-seconds in a coper wire, estimate the number of electrons…

Q: The outer sphere radius of the concentric spherical electrode system is 32 cm. Puncture resistance…

A: To calculate the required value of the radius of the inner surface, consider the following…

Q: An apple "weighs" 60 g and has a volume of 75 cm^3 in a refrigerator at 8 degree Celsius. What is…

A: Weight of the apple is given, m = 60 gram Volume is given, V=75 cm3

Q: The current in a conductor is 40 mA (a) Find the total charge in coulomb,s that passes through the…

Q: You apply a potential difference of 10.55 V between the ends of a wire that is 62.98 m in length and…

Q: Calculate the resistance of a copper tube 0.7 cm thick and 4 m long. The external diameter is 13 cm.…

A: We have been given a copper tube with, External Diameter (D) = 13 cm Thickness = 0.7 cm Length = 4…

Q: (b) Typical replacement for a 100 W incandescent bulb is a 20 W LED bulb. The 20 W LED bulb provides…

A: First calculate energy consumption by the incandescent bulb and LED bulb and than calculate cost…

Q: The resistance of a wire at 0° Celsius is measured to be 182. If the temperature increased to 25°…

Q: Q5/ The illustration shows the electric field lines due to three-point charges. Which one is a…

Q: 2. Determine the value of charging current required to transfer a charge of 0.55 mC in a time of 600…

Q: 5. A conductive block in the shape of a rectangular solid has a cross-sectional area of 12 cm2…

A: Dear student as per our guidelines we are supposed to solve only one question in which it should…

Q: Q1/A type (n) semiconductor has a specific resistance of 10-22m 20 and electron mobility is 102…

Q: Manganese(IV) is an even stronger oxidizing agent than manganese(III). Itoxidizes zinc to Zn2+ in…

A: The reaction is shown below: Zn→Zn2++2e- The work done by the battery is, W=E∆Q The charge…

Q: An insulated piston-cylinder device contains 8L of saturated liquid water at a constant pressure of…

A: The final enthalpy of the water after the evaporation is, h2=h1+x2hfgh1175 kPa=487.01…

Q: A sample of wire (1 mm in diameter by 1 m in diameter) length) of an aluminum alloy (containing 1.2%…

A: Given: A wire of aluminium alloy is placed in electrical circuit such that its parameters are

Q: Calculate the sensitivity of a 200 micro Ampere meter movement which is to be used as a dc voltmeter

A: In the question, Calculate the sensitivity of the meter If 200 micro Amperem Meter movement which…

Q: 56. A coil has 6,000 turns of wire and a resistance of 380 N. The coil is rewound with the same…

A: Given same weight with new arrangement which means same volume of material is used . But volume =…

Q: 1. The density of copper is 9 grams per cu. cm, and the resistivity is 1.724 µ-cm. Determine the…

A: we need to determine the resistance.

Q: 7. What is the value of the diameter in millimeter of a certain wire having a resistance of 0.56 0,…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: A 200-turn solenoid produces 400,000 Maxwell when excited by current of 2 amps. Calculate the…

Q: A typical 12-V automobile battery, storing about 5 megajoules (MJ) of energy, is connected to a 4-A…

A: (a) The voltage delivered by the automobile battery E=12 V The current rating of the headlight…

Q: A 100 W tungsten filament light bulb functions by taking advantage of resistive losses in the…

A: Here, The capacity of world = 100W Energy absorbed by the bulb = 100 J/s Relation 1 W = 1 J/s

Q: Example 1.1: Determine the time required for 4x1016 electrons to pass through a surface if the…

A: The formula to find the time required is Q=Itt =QI whereQ = charge storedI = current flowingt = time…

Q: Surface energy, y, by definition, is the energy required to melt the macro-particles. the energy…

A: The solution is given below

Q: Calculate the velocity of a hole in an electric ﬁeld of 10 V/cm. What is the electron velocity in an…

A: Given: To find the electric field in the resistor is shown as: E=10 Vcm & 1000 Vcm ,μp =470…

Q: i/ At any finite temperature, the energy level at which the probability of finding electrons falls…

Q: 2. Consider a system а. Give a b. Deter

Q: When a current of 2 A flows for 3 micro-seconds in a coper wire, estimate the number of electrons…

A: The solution can be achieved as follows.

Q: voltage is equal to the change in energy divided by the change in charge Select the correct…

Q: The resistance of a coil aluminum wire at 21OC is 210Ω. The temperature of the wire is increased and…

Q: The length and diameter of a copper wire are found to be 100 and 0.002 m, respectively. Consider…

Q: Q1 /A piece of metal is its length 5m and its cross-sectional area 0.5 mm^2 and the specific…

Q: A 1,000 ft. of aluminum wire, whose diameter is 0.365 in., has a resistance of 0.13 Q at 20°C. What…

A: According to the question we have to find the value of percentage conductivity.

Q: A wire with a diameter of 0.001 in has an area of how many CM?. Round off your numerical answer, no…

Q: Q7: How can you explain scientifically the generation of high voltages to feed the ignition plugs in…

A: Electrical machines can be either generator , transformers or motors. They can be either Ac machines…

Q: A conductive block in the shape of a rectangular solid has a cross-sectional area of 12 cm2 across…

A: As per the guidelines, we supposed to answer the first three-part of the question at a time so…

Q: Calculate the electric potential at a distance of 32cm from a -1.4μC charge. Enter your answer in…

A: Calculate the electric potential at a distance of 32cm from a -1.4μC charge

Q: The decay of a current is given by the relationship i = Ie^(-Rt/L) Calculate the charge decay…

Q: 1. The density of copper is 9 grams per cu. cm, and the resistivity is 1.724 u-cm. Determine the…

A: In this question, choose the correct option We know Volume density = mass/volume Resistance R= rho×…

Q: A copper conductor (wire) used in a 30 amp common household circuit has a resistance of 1.73 Ω/1000…

A: Whenever a current flows through any conductor of resistance Then there exist power loss in the…

Concept explainers

Types of Charge Carriers

A carrier is a type of object which carries a particular thing from one point to another point. For instance, people use different vehicles from one place to another, and the vehicle carries those people and acts as a carrier.

Question

100%

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Semiconductor Material and Its Energy Band Analysis

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Semiconductors are ____________. conductors insulators half conductors none of the above
Describe briefly the method a dry cell battery uses to produce voltage.
14. A 6-V lead-acid battery has an A-hr rating of 180 A-hr. The battery is to be load-tested. What should be the test current, and what are the maximum permissible amount and duration of the voltage drop?
By doing the " Coloumbs Law Lab " how do you calculate the electric force on suspended balloon and the charge on each balloon? Can you give an sample calculation
For solar cell the Open Circuit Voltage (Voc) occurs when O a. voltage is minimium f O b. voltage is zero ion O C. current is maximium O d. current is zero page
A rubber rod is rubbed with fur, so that the fur becomes positive. The rod is then used to charge an electroscope. The charge on the electroscope will be:positive if charged by contact. neutral. positive if charged by induction.negative if charged by induction.
An ampere (A) of current is defined as the amount of charge that passes through a reference plane in a given amount of :
b. A piece of pencil lead is connected in series with an ammeter and a power supply. The power supply is turned on. After a few minutes, although the potential difference across the pencil lead does not change, the current in the circuit increases significantly. Explain why the current increases. c. Electric fields are caused by both point charges and by parallel plates with a potential difference across them. Describe the difference between the electric field caused by a point charge and the electric field between parallel plates. Your answer should include a diagram of each type of field and reference to electric field strength. Question 2
A cube of an alloy of resistivity is 2.12µn-m is 3x10^-2 m on a side. Determine the resistance between any two faces of the cube. * 67.07µn O 60.77µn O 70.67µn O 77.06µn
The resistance of wire increases from 40 – ohm at 20 0C to 50 – ohm at 70 0C. Find the temperature coefficient of resistance at 0 0C.
For number 12 question Final problem, you will need a test charge to move from one point to another point. Please consider the value of the test charge 15 mC 12. Determine the work needed to move a 13.3 mC charge from 1.2 mm to 0.41 cm.
Question 7 One of the following elements can be used to make P-type semiconductor Phosphor(P) Arsenic(As) Antimony(Sb) Aluminum (Al) A Moving to another question will save this response.