Why would an ARP frame have a destination MAC address of 00:00:00:00:00:00?   Question 19 options:   To indicate the ARP frame was sent to two devices on the network.   To indicate the ARP frame was sent to another device on the network.   To indicate the ARP frame was sent to three devices on the network.   To indicate the ARP frame was broadcasted to all the devices on the network.

Latency is Select one: Oa. amount of time for a packet to travel from one router to another O b. amount of time for the bits of a packet to travel from one data node to another O c. amount of time for a packet to travel from one data node to another O d. amount of time for a packet to travel from one data network to another

1. It is known that the MAC address is the only address that is used in order to communicate and reach to the destination in the local network. Study the figure below carefully and then answer the following question: Suppose that a data (shown in the figure) has arrived to the router A. The ARP table for Router A is as shown in the figure below. Discuss the necessary steps that are needed for the Router A to prepare the frame for the final hop. MAC src: 74-29-9C-E8-FF-55 ARP Table MAC dest: E6-E9-00-17-BB-4B IP src: 11.11.11.11 IP MAC TTL IP dest: 22.22.22.22 11.11.11.11 74-29-9C-E8-FF-55 22.22.22.11 88-B2-2F-54-1A-OF 20 minutes 18 minutes 11.11.11.11 22.22.22.22 74-29-9C-E8-FF-55 49-BD-D2-C7-56-2A Router A 11.11.11.10 22.22.22.20 11.11.11.22 22.22.22.11 E6-E9-00-17-BB-4B 1A-23-F9-CD-06-9B cC-49-DE-DO-AB-7D 88-B2-2F-54-1A-OF

Choose the kind of cable that will be used to link the switch and the router. What piece of hardware is used to connect two distinct networks (operating under different protocols)?

Correct and detailed answer will be Upvoted else downvoted

Q8: what is hexadecimal values for the source and destination address in the Ethernet frame containing the ARP request message?   *In the filter field of the Wireshark window type arp, and click enter.From the packet list window, select the first ARP request packet.From the packet detail pane, select the Address Resolution Protocol.

Dont answer from the internet or from other source I will downvote for sure only answer if you have accurate answer other wise I will surely Downvote Consider a two-link network where Host A is connected to the router by a 1 Mbps link with 10 ms propagation delay and the router is connected to Host B by a 15 Mbps link with a 25 ms propagation delay. Host A sends a 1500-byte packet to Host B. What is the transmission delay (in ms) of the packet from Host A to the router?

An Ethernet MAC sublayer receives 1510 bytes of data from the upper layer. Can the data be encapsulated in one frame? If not, how many frames need to be sent? What is the size of the data in each frame?

Is it accurate to say that, in the case of routers, packet routing happens at MAC addresses? If you replied no, could you kindly describe the equipment that would be needed to do the job, along with how it functions, and then please explain how it works.

A designated router is elected on any ethernet subnet where EIGRP is used. O True O False