Answered: Why does the E/I ratio of an electric…

Why does the E/I ratio of an electric circuit indicate its ability to oppose electric current rather than its ability to permit current flo

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 3CQ: When working with high-power electric circuits, it is advised that whenever possible, you work...

See similar textbooks

Related questions

Q: What is the difference between EMF and Potential Difference (PD) across a circuit? Complete the…

Q: A light bulb used in a slide projector draws a current of 6 amperes when operating on 120 volts. If…

A: given.,current, I=6 Ampvoltage, V=120 v

Q: 1.The rate at which charge flows through a circuit is referred to as the rate which charge flows…

A: Ассоrding tо bаrtleby's роliсy, I аm аllоwed tо sоlve оnly оne questiоn аt а time.…

Q: A lamp draws a current of 0.50 A when it is connected to a 120 V source. What is the resistance of…

Q: To find resistance in a parallel circuit, you must sum the individual resitances The direction of…

Q: The current through a 10-ohm lamp energized by two series-opposing ideal batteries amperes when the…

Q: Question 10 When there is a difference in Electric Potential (voltage) in a closed circuit, current…

A: 10 . When there is a difference in Electric Potential (voltage) in a closed circuit, current flows…

Q: 1. If one bulb breaks in a series circuit containing three bulbs, the other two bulbs will remain…

A: Many inventions and discoveries have been made in order to facilitate human life smoothly. The…

Q: creative way the effect of temperature increases on the resistance of a metallic conductor. Express…

A: Answer

Q: What is a Parallel circuit? O Has only one light bulb. O Has only one path for current. Has more…

A: In the series connection or circuit, there is only one path for the current.

Q: Which conductor will dissipate more power

Q: If part of an electric circuit dissipates energy at 60 W when it draws a current of 5 Amperes, what…

Q: If the amount of current in a conductor is equal to (0.4A) calculate the amount of charge which…

Q: A 149.7 V battery is hooked to a 25Ω resistor. What is the resulting current (in A).

A: According to ohm's law Potential difference = Current * Resistance Therefore, current (I)…

Q: Current won't flow in an open circuit because... there are no electrons present in an open circuit.…

A: current in an open circuit :

Q: Choose the items that help to fully describe RESISTANCE. 1) Directly related to voltage O 2) Adds up…

A: The answer is below

Q: The open-circuit terminal voltage of a battery is its O electromotive force; O The answer cannot be…

A: The open-circuit terminal voltage of a battery is its Electromotive Force

Q: 120 40 240 48 V 200 1603 240 480

A: Given:- Draw and Analyze Circuit using Kirchhoff's Law KCL and KVL

Q: A positively charged sphere cartyIng charge of 0.4 mC is earthed using a wire. (1) Calculate the…

A: This question is based on Electric current topic. Average electric current formula:…

Q: In a flashlight, how does the amount of current that flows out of the bulb compare to the amount…

A: Electric current is the flow of electric charge. When the switch is pushed to the ON position,…

Q: A 220 V – 10 A electric lamp is used for 30 minutes. How much energy does it require (Watts)

Q: An energy source forces a constant current of 2 A for 10 s to flow through a light bulb. If 2.3 kJ…

A: Given Current I=2A Time t=10s Energy dissipitated E=2.3kJ=2300J

Q: Calculate the power of a hair dryer that operates on 130 VV and draws a current of 11 AA . Express…

Q: A 1.5 Volt (V) Battery is charged completely. If this battery attached to the terminals an of small…

Q: The charge (0.052 µC) stored in a component in your calculator is released and flows through a…

Q: In the diagrams, all light bulbs are identical and all EMF devices are identical. Rank the…

A: In circuit I, II, and III bulbs are in series, so the voltage through each bulb are different.…

Q: 20V 600-watt electric coffee maker is used to make a total of 10 cups of coffee in 45 minute ermine…

A: Answer

Q: Which of the following statements is true? Power is regardless if the resistors are connected in…

A: Given Electric power for a circuit We have to choose the correct option from given options

Q: Which option BEST explains how fuses interact with holiday lights? A They open the circuit if the…

A: They open the circuit if the electrical current increases and further fatal damage is prevented.

Q: 11. Complete the table below by identifying the effects on resistance and effects on current flow of…

Q: eck all that apply. The direction of current in a circuit is O the direction of motion of positive…

A: Current in a circuit is defined as the rate of change of charge per unit time.

Q: True/False and Why? When two lamps are connected in series to a battery the electrical resistance…

A: The equivalent resistance, that is the electrical resistance the battery experiences, of the…

Q: DATE: 06-JUNE-ZUZZ USE MESH THEORY (SIMULTANEOUS EQUATIONS) TO CALCULATE ALL THE VOLTAGES AND…

Q: 3.The diagram at the right depicts a conducting wire. Two cross-sectional areas are located 50 cm…

A: Given data : Time (t) = 2 seconds Charge (q) = 10 C Current (I) =?

Q: Write down the important properties of parallel connections of resistors

A: There are two types of combination of resistors. 1. Series combination 2. Parallel combination

Q: When a switch is closed, two pieces of conducting material A. touch, allowing the electric charges…

Q: An electric heater consumes 3.6MJ when connected to a 250 V supply for 40 minutes. Find the power…

A: Given : E = 3.6 MJ = 3.6 × 106 J V = 250 V t = 40 minutes = (40)(60) = 2400 seconds

Q: The label on a portable radio recommends the use of rechargeable nickel-cadmium cells (nicads),…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: If the circuit is open at the source of electric energy in a parallel circuit, some current can…

A: An open circuit implies that the two terminals are points that are extremely disconnected. It has a…

Q: A charge 20 C flows out from the battery in 8s and as a result 120J of energy is supplied to a lamp…

A: Given : Charge (Q) = 20 C Time (t) = 8 secs Current (I) is given as : I = Qt I = 208 I = 2.5 A

Q: During 23 seconds of use, 200 C of charge flow through a microwave oven .compute the size of the…

A: Time (t) = 23 seconds Charge flowing (q) = 200 C

Q: Determine the electric current that flows into the circuit in the Figure below. R1=2 Ohm, R2=4 Ohm…

Q: Draw an electric circuit diagram that is made up of a load, three resistors in parallel, and an open…

Q: t is the rate of flow of electrons thru a conductor in a close circuit. Select one: a. potential…

A: Let's check each option one by one a. Potential difference Incorrect potential difference between…

Q: A charge of 16.0 C is sent through an electric lamp when the difference of potential is 220V. What…

A: If a charge q is sent through a potential difference ∆V then the energy expended is, U = q∆V

Q: A cell has a terminal voltage of 50.0 V for a current of 10.0 A, and 54 V for a current of 6.0 A.…

A: Given: The terminal voltage is 50.0 V for a current of 10.0 A. The terminal voltage is 54.0 V for a…

Q: What is the SI unit of electric current? O a. Volt (V) O b. Candela Ос. Mole O d. Ampere (A)

Q: Steady current circulation is desired for a lamp connected in a circuit to light. For this, explain…

A: Kirchoff's junction rule states that at any junction, the sum of the currents entering the junction…

Question

Why does the E/I ratio of an electric circuit indicate its ability to oppose electric current rather than its ability to permit current flow?

Flow of electric charges through a conductor.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

Integrated Concepts (a) What energy is dissipated by a lightning bolt having a 20,000-A current, a voltage of 1.00102 MV, and a length of 1.00 ms? (b) What mass of tree sap could be raised from 18.0°C to its boiling point and then evaporated by this energy, assuming sap has the same thermal characteristics as water?
A man foolishly tries to fish a burning piece of bread from a toaster with a metal butter knife and comes into contact with 120-V ac. He does not even feel it since, luckily, he is wearing rubber-soled shoes. What is the minimum resistance of the path tire current follows through the person?
Foolishly trying to fish a burning piece of bread from a toaster with a metal butter knife, a man conies into contact with 120-V AC. He does not even feel it since, luckily, he is wearing rubber-soled shoes. What is the minimum resistance of the path the current follows through the person?
The batteries of a submerged non-nuclear submarine supply 1000 A at full speed ahead. How long does it take to move Avogadro’s number (6.02 1023) of electrons at this rate?
When operating on a 120-V circuit, an electric heater receives 1.30 103 W of power, a toaster receives 1.00 103 W, and an electric oven receives 1.54 103 W. If all three appliances are connected in parallel on a 120-V circuit and turned on, what is the total current drawn from an external source? (a) 24.0 A (b) 32.0 A (c) 40.0 A (d) 48.0 A (e) none of those answers
Integrated Concepts (a) Assuming 95.0% efficiency for the conversion of electrical power by the motor, what current must the 12.0-V batteries of a 750-kg electric car be able to supply: (a) To accelerate from rest to 25.0 m/s in 1.00 min? (b) To climb a 2.00 102-m- high hill in 2.00 min at a constant 25.0-m/s speed while exerting 5.00 102 N of force to overcome air resistance and friction? (c) To travel at a constant 25.0-m/s speed, exerting a 5.00 102 N force to overcome air resistance and friction? See Figure 20.44.
Review. Ail aluminum rod has a resistance of 1.23 at 20.0C. Calculate the resistance of the rod at 120C by accounting for the changes in both the resistivity and the dimensions of the rod. The coefficient of linear expansion for aluminum is 2.40 10-6 (C)-1
A 120-V immersion heater consists of a coil of wire that is placed in a cup to boil the water. The heater can boil one cup of 20.00°C water in 180.00 seconds. You buy one to use in your dorm room, but you are worried that you will overload the circuit and nip the 15.00-A, 120-V circuit breaker, which supplies your dorm room. In your dorm room, you have four 100.00-W incandescent lamps and a 1500.00-W space heater, (a) What is the power rating of the immersion heater? (b) Will it trip the breaker when everything is turned on? (c) If it you replace the incandescent bulbs with 18.00-W LED, will the breaker nip when everything is turned on?
An electric eel generates electric currents through its highly specialized Hunters organ, in which thousands of disk-shaped cells called electrocytes are lined up in series, very much in the same way batteries are lined up inside a flashlight. When activated, each electrocyte can maintain a potential difference of about 150 mV at a current of 1.0 A for about 2.0 ms. Suppose a grown electric eel has 4.0 103 electrocytes and can deliver up to 3.00 102 shocks in rapid series over about 1.0 s. (a) What maximum electrical power can an electric eel generate? (b) Approximately how much energy does it release in one shock? (c) How high would a mass of 1.0 kg have to be lifted so that its gravitational potential energy equals the energy released in 3.00 102 such shocks?
A portable coffee heater supplies a potential difference of 12.0 V across a Nichrome heating clement with a resistance of 2.00 . (a) Calculate the power consumed by the heater. (b) How many minutes would it take to heat 1.00 kg of coffee from 20.0C to 50.0C with this heater? Coffee has a specific heat of 4 184J/(kg C). Neglect any energy losses to the environment.
(a) What advantage does 120-V operation offer over 240 V? (b) What disadvantages does it have?
When working with high-power electric circuits, it is advised that whenever possible, you work "one-handed” or “keep one hand in your pocket." Why is this a sensible suggestion?