Which type of equipment is used to bridge sections of horizontal, backbone, or patch cable? A. Cross-connect B. Splice enclosure C. Pull box D. Conduit 3.b. Which of the following types of cables is most rugged? A. Tight-buffered cable B. Patch cable C. Standard loose-tube cable D. Loose-tube armored cable

6. Which type of cable would you use to connect two buildings in an office installation?A. Buried loose-tube cableB. Aerial armored cableC. OFNP cableD. Tight-buffered cable

15. Which of the following conductors in a typical separable connection plug and receptacle has a firstmake, last-break feature?A. The neutral grounded conductorB. The equipment grounding conductorC. A center wye conductorD. The grounded delta conductor

13. If the largest ungrounded service-entrance conductor for a service is 750-kcmil copper, what is the minimum size required for a wire-type main bonding jumper for the service? a) 2/0 AWG copper b) 1/0 AWG copper c) 3/0 AWG copper d) 1 AWG copper   14. If the total circular mil area of the largest ungrounded service-entrance conductor for a service is 2000-kcmil copper, what is the minimum size required for a wire-type main bonding jumper for the service? a) 4/0 AWG copper b) 250-kcmil copper c) 350-kcmil copper d) 500-kcmil copper   15. The minimum-size grounded conductor for a service supplied by a grounded system shall not be smaller than the minimum size required for a(n)______. a) Equipment grounding conductor b) System bonding jumper c) Ungrounded conductor d) Grounding-electrode conductor