Which statement is true about Symmetric (single-line) digital subscriber line (SDSL) a. A technology based on DSL; allows different data rates depending on the type of communication; differing rates may also assigned tosubcribers based on their demand on bandwidth b. A communication technology in which the downloadstream data rate is higher than theupstream rate c. Same as HDSL but one uses single pair twisted cable, available to mostresidential subscriber to achieve the same data rate as HDSL d. Design byTelcordia as an alternative to the T-1 line

Q: Explain the mechanism of VLAN tagging and outline common methods for implementing VLAN tagging in…

A: VLAN (Virtual Local Area Network) tagging is a technique used in Ethernet networks to segment and…

Q: Describe the sort of connection. Also, describe the many sorts of transmission modes.

A: A plug or connector's connection to a port or jack is referred to as a connection. A network is made…

Q: between circuit-switching , packet-switching  paradigm. Also distinguish between datagram and…

A: It is defined as the data transmits data across digital networks by breaking it down into blocks or…

Q: In order to access any node, we need to traverse the linked list from the start and only then we can…

A: There is one statement given, we have to verify this statement: in order to access any node we need…

Q: What kind of data transfer speed can you anticipate from an Ethernet local area network?

A: Ethernet Local area networks (LANs) are networks that connect computers and other electronic devices…

Q: Describe the process of VLAN tagging and how it allows for the identification of VLAN membership in…

A: In the realm of computer networking, VLAN (Virtual Local Area Network) tagging is a crucial concept…

Q: VLAN A Prefix Size: 19 VLAN B Network Mask 255.0.0.0

A: THE ANSWER IS

Q: How does the choice of transmission media affect the data transfer rate in a network?

A: The choice of transmission media can have a significant impact on the data transfer rate in a…

Q: What is pulse stuffing? How to utilize the full bandwidth of a link in TDM while other shared users…

A: NOTE  :-  Below i explain the answer in my own words by which you understand it well.   Pulse…

Q: B. Name the acronym for the following: 1- OSI: 2- WAN: 3- IP:

A: Name the acronym are as follows:

Q: How fast can a cable user receive data if the network is otherwise idle?

A: Introduction: Cable user: A type of ethernet cable-based network to facilitate communication.…

Q: What are the two main synchronization problems that can occur during message transmission? (max of 3…

A: Synchronization problems during message transmission occur when sender and receiver are not properly…

Q: How does the quality and length of a cable affect data transfer speeds?

A: Data transfer rates can be considerably impacted by the length and quality of a cable, particularly…

Q: In GSM, a "TDMA frame" is made up of eight independent time slots. Each GSM time slot is 577 seconds…

A: INTRODUCTION: TDMA:  Each user may send data only at predefined intervals (Time slots).  Numerous…

Q: What benefits will you get from learning assembly language in terms of your grasp of operating…

A: According to the information given;- We have to define the benefits will you get from learning…

Q: What is the purpose of a VLAN ID (VID), and how is it used to differentiate VLANs within a network?

A: In computer networking, a Virtual Local Area Network (VLAN) is a technology used to logically…

Q: A GSM "TDMA frame" has eight time slots. Each 577-microsecond GSM time slot comprises more than a…

A: The GSM system is part of the global mobile communications infrastructure.Time Division Multiple…

Q: UTP cables are bulkier and more expensive when compared to STP cables Select one: O True O False

A: Actually, STP stands for Spanning Tree Protocol.

Q: Explain the concept of latency in WANs. What factors can contribute to high latency, and how can it…

A: WAN is wide area network used for communication over a wide range of area. It can connect multiple…

Q: How fast can a cable user receive data if the network is otherwise idle?

A: Answer:

Q: Describe the key components of a WAN, including routers, switches, and transmission media.

A: A Wide Area Network (WAN) spans a large geographical area, such as a city, country, or even multiple…

Q: 2. What is pulse stuffing? How to utilize the full bandwidth of a link in TDM while other shared…

A: INTRODUCTION: The process of adding non-data bits to a binary signal before it is broadcast across…

Q: 26. The entire capacity of the link is reserved for transmission between those two devices. c.…

A: Two or more devices connected by a link form a network. A link is a communication channel that…

Q: It shows how fast each type of Ethernet sends and receives data. This table also shows how fast each…

A: It shows how fast each type of Ethernet sends and receives data. This table also shows how fast…

Q: Describe the process of VLAN tagging and its significance in a network with multiple VLANs.

A: VLAN tagging, also known as Virtual LAN tagging, is a technique used in computer networking to…

Q: It shows how fast each type of Ethernet sends and receives data. This table also shows how fast each…

A: Introduction: The data rate is the number of times data is conveyed in a given time, typically…

Q: In synchronous transmission data from various users Do not require header explain?

A: Given that: In synchronous transmission data from various users Do not require header explain?

Q: Compare T-1 carrier and High Bit Rate DSL (HDSL).

A: Compare T-1 carrier and High Bit Rate DSL (HDSL).

Wireless Transmission Technology

If communication is done between two mediums without using a cable or wire, then it is referred to as wireless communication. Wireless communication is a type of data communication in which the transmission of information takes place without the help of a wire or cable. The device works by broadcasting electromagnetic signals through the air, atmosphere, or physical environment. The sender device generates electromagnetic signals (wireless signals) which is received by several intermediary stations before it reaches the destination device. The destination station receives and processes these signals. An electrical circuit with antenna, which is capable of changing digital data to wireless signal, can act as a transmitter (sender) and a circuit converts wireless signal to digital data with antenna can be a receiver.