Which of the following is true when charging a capacitor using a DC source?     Current will flow due to the DC source and will charge the capacitor. Once the capacitor is fully charged, it has to be removed from the circuit it will not exceed the voltage of the source to avoid short-circuiting.     Since capacitors behave as open circuits when a DC source is applied, there will be no charging current. The charging will happen due to KVL where the voltage of the source will be charged to the capacitor.     Current will flow due to the DC source and will charge the capacitor. Once the capacitor is fully charged, it will act as if it is an open circuit.     The answer cannot be found on the other choices.

Q: For Common - collector of Emitte Follower JB 3RB 270k 3=120 -Vo 13 RE JE 2,4K 3 VEE -24V

A:

Q: A flat circular coil having 50 loops of wire on in has a diameter of 48 cm. What current must flow…

A: Given : A flat circular coil  No of loops , N = 50  Diameter of coil = 48 cm , Radius = 0.24 m Flux…

Q: QUESTION 2 A non-inverting amplifier has a 15-k Ry and a 1.2-KOR,. How m 9. 12.5. -12.5. 13.5.

A: Given data, A non-inverting amplifier has Rf=15 kΩRi=1.2 kΩ

Q: If the absorption coefficient of silicon is 0.05 pm-1 at 860 nm, find the penetration depth at which…

A: Given, The absorption coefficient of silicon, α=0.05 μm-1 At wavelength, λ=860 nm And,…

Q: Show that the system shown in Figure (1) is equivalent to : C(s) R(s) Gp(s)Gc(s) 1+ Gp(s)Gc(s) R(s)…

A:

Q: Q4. A system has the following transfer function 00(s) 2 0₁(s) 3s² + 3s + 2 Calculate the undamped…

A: Given: A system has transfer function θ0sθis=23s2+3s+2

Q: Answer the following questions

A: Given that A sinusoidal input signal with a peak of 10 V A unipolar square input signal. Zener…

Q: A radio receiver uses an RLC circuit to pick out particular frequencies to listen to in your house…

A: The radio antenna receives all frequencies. In order to filter the desired frequencies, the radio…

Q: independent • A three-phase, 400 V source (terminal voltages assumed constant of load) supplies a…

A: We have a three Phase source which supplies a load through a transmission line as,   Supply Voltage…

Q: Which of the following is true regarding the behavior of capacitors when energized by a DC source?…

A: Given: Analyze the behavior of capacitors when energized by a DC source

Q: Calculate the response of the signal below:

A: Given- x[n] =3δ(n-1)+2δ(n)-δ(n+2)h[n]=2u[n+1]-r[n+1]+u[n]+2r[n-1]-3u [n-1]-r[n-3] To find- Response…

Q: Write an HDL behavioral description of a BCD-to-excess-3 converter.

A: In the BCD to excess 3 code converter the binary value of 3 is added with the BCD value to get the…

Q: The transfer function of (1-7)(1-12-²²) a resonance MCZ) = 1=2rcos (W₂T) Z_ +r+Z ² -2 3 Date: filter…

A:

Q: 4 A. X(z) of -n7"u(-n-1) = 1+72-1 B. X(2) of -n7"u(-n-1)= -1 1-7z C. X(z) of -n7"u(-n-1)= D. X(z) of…

A: You have asked only 6th question  So i answered only this question.

Q: A transformer has 150 primary turns and 75 secondary turns. Its primary is excited at 200 V and the…

A:

Q: Write a hierarchical gate-level HDL model of the multiplexer described in Problem 4.31 .

A: The 16x1 multiplexer can be implemented by using 4 select line with two 8x1 multiplexer nad one 2x1…

Q: Simplify the following expression: Y=ABC + ABC +ABC + ABC

A:

Q: Construct a JK flip-flop using a D flip-flop, a two-to-one-line multiplexer, and an inverter.

A: Flip flop:- Basic flip-flops can construct by four NAND or four NOR gates. It maintains its state…

Q: A JFET has r(d) = 100 kilo ohm and voltage gain of A(v) = -200. What is the value of g(m)

A: We have a JFET with, Rd = 100 KΩ   AV­ = -200   And We have to find   The Value of gm

Q: In a second-order system, if the damping ratio is greater than '1', then what would be the nature of…

A: In second order system if the damping ratio is greater than 1 ( over damped ) then the roots or…

Q: 10. Which of the following is true about microprocessors? a) It has an internal memory b) It has…

A: The correct option along with the explanation is provided in the following section.

Q: _et x[n] = 0.8¹u[n − 1] & h[n] = 0.4”u[n]. Find their convolution. Answer: (2(0.8¹) — 2(0.4″))u[n −…

A:

Q: What will be the frequency corresponding to a wavelength of 4 m?

A: In this case, the frequency corresponding to a wavelength of 4 m is to be determined.

Q: The armature of a dc machine running at 1200 rpm carries 45 A in current. If the induced armature…

A: Given: N=1200 rpmIa=45AEa=130V

Q: Draw the logic circuit for the simplified expression a) and b)

A:

Q: 1 0 8 (t) t

A:

Q: Equivalent resistance (CLO 2): Determine the value of R2 in the below circuit when REq-10.8 02: om 4…

A: Given circuit:

Q: A 400 V, 3-phase, 4 wire system supplies resistive loads between each of the three lines and…

A: We have an 3-Phase, 4-Wire System That supplies power to the resistive load as shown in figure   We…

Q: Fourier Transform

A:

Q: 8) Design a binary counter that counts from 0 to 5. At each clock pulse, 3 lights will be ON and 3…

A: Given data: A binary counter that counts from 0 to 5

Q: 1. A circuit with 2 or more connected transistors is called _________ or multi-staged amplification.…

A:

Q: Determine the velocity of electromagnetic wave in free space. I need detail calculation.

A: In this case, the velocity of an electromagnetic wave in free space is to be determined.

Q: Determine the output time function, y(t), from the convolution integral y(t)=√ h{t=t\r{t}dt where…

A:

Q: voltage of v(t) = 4 cos(2π 43 t) volts is applied across the 33-ohm resistor. Find the total charge,…

A:

Q: An induction motor has 10 poles and an electric frequency of 50 Hz. Computer the synchronous speed…

A: Given data, Number of poles P = 10 Frequency f = 50 Hz

Q: find the indicated resultant.

A:

Q: Using the equation: X (s)_ _1-6²³² (5+₁) 2 5² a closed-form expression for the clime-domain) output…

A: Time domain provides a picture of how a dynamic system's state evolves over time in response to a…

Q: What truth table is implemented by the logic diagram in Fig. PE 2.4 ?

A:

Q: What would be the inducesd voltage for a conductor moving at a speed of 25 km/h and having a length…

A: Given data, Speed of conductor, v=25 km/h Length, L=1 m Magnetic flux density, B=0.6 T

Q: To measure RLC values, is a Wheatstone bridge more accurate or a multimeter? Explain your reasoning.…

A: Wheatstone Bridge: The Wheatstone Bridge is one of the most common and simplest bridge network /…

Q: A conducting disc 20 cm in diameter pivoted by a vertical spindle which is lying in uniform vertical…

A: Given: The diameter of the disc is 20 cm The flux density is 0.3 T The current is 15 mA

Q: 23. Use series to evaluate : Limit 210 1-cost

A: By expanding the expression of cos(t) in the above expression we get a finite value for the above…

Q: question: Find the value of V

A: It is given that:

Q: Use the node voltage method to find the steady-state expression for io in the circuit seen in Fig.…

A: Given data: Source current Ig=5 cos 2500t A Source voltage Vg=20 cos 2500t+900 V The given circuit…

Q: 2. Find the transfer function. Y(s) of Figure 2 U(s)

A:

Q: Application of Distance Relay (Device 21) in sub-transmission and distribution lines. Also discuss…

A: The distance relays are used as a better alternative in the place of overcurrent protection relays.…

Q: Consider the following stick diagram. Draw the electrically equivalent transistor-level schematic.…

A: Stick diagrams are a way to visually represent topography and layer information of a transistor.…

Q: 14.3.4 - What signal is sent in period 9 if a slave on the 12C bus has the same slave address as was…

A: The address of the slave with which the master communicates is sent by the master to every slave…

Q: In the circuit below, what is the value of the current 13? A 25 Ω F 0.52 A O 0.19 A O 0.71 A O 0.25…

A:

Q: A proton travels with a speed of 5.0x106 m/s in a direction that makes an angle of 60.0° with the…

A: Given data, Velocity of proton v=5×106 m/s Angle θ=600 Magnetic field B=7.5 T Charge on proton…

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.