Which of the following is true about machine home, part origin, and tool change position? (choose all that apply) Machine tool home is a position set once by the machine manufacturer. Part origin is set by the programmer. All subsequent relative programmed tool movements are measured from part origin. Tool change position is set by the setup person.

Which of the following is true about machine home, part origin, and tool change position? (choose all that apply) Machine tool home is a position set once by the machine manufacturer. Part origin is set by the programmer. All subsequent relative programmed tool movements are measured from part origin. Tool change position is set by the setup person.

Precision Machining Technology (MindTap Course List)

2nd Edition

ISBN:9781285444543

Author:Peter J. Hoffman, Eric S. Hopewell, Brian Janes

Publisher:Peter J. Hoffman, Eric S. Hopewell, Brian Janes

Chapter8: Computer Numerical Control

Section8.4: Cnc Turning: Setup And Operation

Problem 7RQ: When setting up a machine to run a program that will use TNRC, what settings must be entered in the...

See similar textbooks

Similar questions

In the FILLET command, when selecting the objects to fillet, holding down the <Shift> key: a. Allows you to remove objects from the selection set b. Puts a 0 radius corner at the intersection of the two objects c. Allows you to select additional cutting edges d. Allows you to extend objects to the cutting edges
When setting up a machine to run a program that will use TNRC, what settings must be entered in the offset pages in order for the TNRC to work properly?
NUMERICAL METHOD PLEASE FOLLOW THE INSTRUCTION
6. Write one block of code to perform the indicated operation. Assume the location is X2.0, Y2.0, and the depth is Z-1.5 for each operation. 1) Drill with dwell of 0.2 seconds 2) Peck drilling cycle with a 0.15" peck depth 3) Chip breaker with a 0.15" peck and full retract every 0.6" 4) RH tapping cycle for 14-16 NC thread; define a spindle speed and feed 5) Bore a hole with the tool being retracted manually
Please show me a walkthrough of the problem attached.
Make the part program using CNC code. Tool Dia. = 6 mm depth of cut 3.0 mm (Use G90 code) (follow the points as marked Start point, P1, P2, P3, P4, P5, P6) (don't use G41, G42)
The following jobs are waiting to be processed at a small machine center: JOB 10 20 30 40 50 DUE DATE 260 254 260 265 275 days (round your response to one decimal place). days (round your response to one decimal place). DURATION (DAYS) 18 T 22 14 32 All dates are specified as manufacturing planning calendar days. Assume that all jobs arrived on day 200 (yesterday) in the order shown but are not scheduled to begin until day 201 (today). a) Sequence the jobs according to LPT. According to the LPT rule, the sequence of jobs should be 50, 20, 10, 30, 40 b) What is the average completion (flow) time? The average completion (flow) time is c) What is the average job lateness? The average job lateness is d) What is the average number of jobs in the system? The average number of jobs in the system is jobs (round your response to one decimal place). 62446
A programmable indexing fixture creates a fourth axis called a ________ __________ that is similar to a rotary table used on a manual milling machine.
If a G1 code command is programmed partway through a machining operation, but no F-value is given in that block, what feed rate will be used?
Copied Solution will get Multiple Downvote. (Provide Handwritten Solution Only)
Explain the necessary steps for a machine command to work by drawing a figure
able to draw the sequence chart?