Which of the following is a crystalline solid? a) Anisotropic substances b) Isotropic substances c) Supercooled liquids d) Amorphous solids
Q: In very cold countries alcohol is used as a thermometric liquid because A) alcohol is a poor…
A: The freezing point of an alcohol is as low as -117°C. Therefore it won't freeze even in very cold…
Q: Question 4 The density of a steel block that has mass of mass 42 gm and a volume of 6 cm³ is 07…
A:
Q: All unit cell structures have six sides. Can crystals of a solid hay than six sides ? Explain your…
A: All unit cell structures have six sides. Can crystals of a solid hay than six sides ? Explain your…
Q: Consult Table 1 and rank the densities of the following materials from greatest to least: a. Liquid…
A:
Q: A basketball is very different from A fire. What are some difference that might make a basketball…
A: All matter In the world , including basketballs and water, shares two properties. A matter is define…
Q: Given the following information, calculate the density of the following solutions. Solution…
A:
Q: Describe the state of equilibrium between a liquid and a gas, a liquid and a solid, and a gas and a…
A: Liquid-gas equilibrium: An example of equilibrium between liquid and gas is that of water and steam…
Q: Amorphous solids do not melt at a sharp temperature, rather these have softening range. a) True b)…
A: A
Q: 9. Which of these has the largest density, 1 gram of aluminum, 1 kilogram of aluminum, 1 milligram…
A: The formula for the density is:
Q: Estimate the density of an alloy made from 5.5 kg of silver and 2.2 kg of gold. The density of…
A: When two solids are mixed to make an allow then the total volume remains the same.
Q: 7
A:
Q: None
A: To determine which statement is true, we first need to understand what water hardness is and how it…
Q: It the volume of a gas is decreased by a factor of 4, what is the change in its density? Density…
A:
Q: A piston has a pressure of 50 Pa to produce a volume of 35 cc. What pressure is necessary to reduce…
A: Given that : Initial pressure P1 = 50 Pa Initial volume V1 = 35 cc Final pressure P2 = unknown…
Q: 10. How did the hand force required to submerge the ball % compare to the force required to submerge…
A: Given Submerged volume V1 =3/4V Submerged volume V2=1/2 V
Q: 232. The solid E bounded by z= 1-x² and situated in the first octant is given in the following…
A: Given that For a solid E z=1-x2 And from the figure the x component of solid is from 0 to 1 the y…
Q: One component of a metal sculpture consists of a solid cube with an edge of length 0.203 m. The…
A: Given data : Side length of cube, L = 0.203 m Density of the material , ρ =…
Q: Orthoclase feldspar is a mineral that commonly occurs in certain intrusive igneous rocks that…
A: Given mass of orthoclase mo=4.5g Mass of 40Ar ma=1.8μg=1.8x10-6g molecular mass of orthoclase is…
Q: Hardness after quenching r/R 0.1 0.3 0,5 0,7 0,9 1 Hardness (Rc) 32 33 37 41 47 52 55 Hardness…
A: According to the above given question, the information provided to us is about some jominy test…
Q: Melting point depends on pressure. True or False? a) True b) False
A: True or False Melting point depends on pressure.
Q: You need a 40% alcohol solution. On hand, you have a 280 mL of a 15% alcohol mixture. You also have…
A: To make a 40% alcohol solution from a 15% alcohol solution and a 75% alcohol solution, you can use…
Q: At what temperature does liquid water have the highest density? A) 100 c B) 4 c C) 0 c D) -7 c
A:
Q: Ethyl alcohol has a density of 0.789 g/mL. What is the mass of 250 mL of this alcohol? a) 250g b)…
A: Given , density of Ethyl alcohol=0.789g/mL. volume of Ethyl alcohol=250mL.
Q: Four student measured the same volume of a glass of water. They all made three trials and summarized…
A: ans1 Most precise measurement is taken by Lianne. because difference between lowest and highest…
Q: How do you know the density of silicone?
A: Given, volume of silicon chip , v = 6.25×19-9 m3 Change in temperature, ∆T = 35°C-25°C = 10°C = 10K…
Q: What are dichroic materials? Give some examples.
A: The material which helps in splitting of visible light into distinct beam of different wavelength is…
Q: Where is chemical energy stored? A. In motion B. In bonds C. In sound D. In light
A:
Q: Normally, it is possible to obtain austenite at room temperature. * true false Martensite is a…
A: #1 Austenite is obtained when 2% carbon is added in iron at heated to a temperature of 1000°C. It…
Q: ACTIVITY 1 Four student measured the same volume of a glass of water. They all made three trials and…
A: we know that, Accuracy is how close or far a given set of measurements is to their true value.…
Q: One component of a metal sculpture consists of a solid cube with an edge of length 34.5 cm. The…
A: Edge length L = 34.5cm =0.345 m Density of solid cube p = 6210 kg/m3
Q: shampoo
A:
Q: Which of the following substances is NOT homogeneous? O 1. iron O 2. water 3. sand O 4. sugar
A: Homogeneous mixture is uniform composition
Q: Which solid has more volume recall density=mass/volume, so volume=mass/density a) A kilogram (kg) of…
A: Volume = mass/density because everyone have same mass so volume is inversely proportional to…
Q: Modern electroplate can cover plastic surfaces with silver of 1 μm thick. If a surface area is 150…
A: Here is the step-by-step explanation:Step 1: Conversion of the surface area from square feet to…
Q: Use Charles' Law to find V1. Pay attention to the temperature units. * a. V₁ T₁ 840 K V₂ 1,070 mL T₂…
A: Case(a):Initial temperature is Final temperature is Final volume is Find:Initial volume.
Q: For what is Mohs scale used? A) To measure brightness of a substance B) To measure viscosity…
A: The correct answer is option D the Mohs scale is used to measure the hardness of the minerals. it…
Q: What are the special characteristics of materials listed below? Materials Characteristics 1.…
A: Solution: Below given in the table are the characteristics of the materials: Materials…
Q: 5- In the cesium chloride CsCl crystal structure, what is the Miller's indices of the following…
A: Note: We’ll answer the first three sub parts of the question since the exact one wasn’t specified.…
Q: Determine the composition of the Liquid (wt% Sn) for a 40 wt% Sn, 60 wt% Pb alloy at 250°C.
A:
Q: Which of the following is the most conductive element? a) Aluminium b) Lead c) Silver d)…
A: C
Which of the following is a crystalline solid?
a) Anisotropic substances
b) Isotropic substances
c) Supercooled liquids
d) Amorphous solids
Step by step
Solved in 2 steps
