Which of the following components are common to most automatic control systems for residential split air conditioners? a. Thermostat, contactor, transformer b. Thermostat, magnetic starter, contactor c. Thermostat, diode, contactor d. Thermostat, time-delay relay, contactor

Which of the following components are common to most automatic control systems for residential split air conditioners? a. Thermostat, contactor, transformer b. Thermostat, magnetic starter, contactor c. Thermostat, diode, contactor d. Thermostat, time-delay relay, contactor

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter4: Automotive Systems

Section: Chapter Questions

Problem 23RQ: While discussing the operation of air-conditioning systems: Technician A says that in order for the...

See similar textbooks

Related questions

Q: eat expulsion occurs in what section of a heat pump system when operating in the heat mode? A.…

A: Heat expulsion means removal of heat from the system,

Q: True or False: All reciprocating compressors start up fully loaded.

A: Reciprocating Compressors

Q: Q1 (a) Differentiate between open feedwater heaters and closed feedwater heaters.

Q: List two types of return air systems commonly found on residential air conditioning systems

A: Return air systems commonly found on residential air conditioning systems

Q: The bank of tubes at the back of domestic refrigerator is; * O evaporator tubes capillary tubes…

A: Refrigerator has 1. Compressor 2. Evaporator 3. Condenser 4. Expansion valves

Q: On most residential air conditioning units, the condensing fan motor is controlled by? a.…

A: In residential AC systems the fan motor is controlled by the indoor fan relay. The relay is…

Q: Describe four ways in which the heater control valve may be controlled

A: The heater control valve is a part of the heating ventilation, and air conditioning unit (HVAC) used…

Q: Which of the following is not a problem with cooling towers? 1) Freeze up 2) Water treatment 3)…

A: A cooling tower is a specialized heat exchanger in which air and water are brought into direct…

Q: what should you know before choosing a respirator

A: Workers should use respirators for cover from contaminants within the air on condition that…

Q: principle of Inverter air conditioner and energy saving.

A: An inverter air conditioner consists of a compressor such that the speed of the compressor can be…

Q: ondensing ter со condenser as earance volum

Q: Describ the procedure for using air bleedvalves to purge out of a coolling system

A: A bleed valve is typically utilized to eliminate the liquid from the vehicle's tank or for removing…

Q: If a hot water reheat coil is installed with a two way modulating valve. A. The VAV box can only be…

A: Given :- If a hot water reheat coil is installed with a two way modulating valve. Select one A.…

Q: Technician A says that suction lines become very warm during A/C operation. Technician B says that…

A: Suction line:The piping line which connects the outlet of the evaporator(refrigerated space) to…

Q: The compressor motor and condenser fan motor wired series or parallel?

A: The Compressor is a device used to increase the pressure of liquid or gas. Condenser is a heat…

Q: What types of hydronic heating systems are in use?

A: Hydronic heating systems are the modern equipment set used for heating rooms, entire houses, or even…

Q: What are the three components that have to operate when a residential air conditioning system is in…

A: Indoor fan, outdoor fan & compressor are the three components that have to operate when a…

Q: Air Service Unit comprises of O a. Pressure Reducing Valve O b. Filter Regulator Lubricator. С. O C.…

A: Air service unit is placed after a compressor in a pneumatic system. The main function of this unit…

Q: Which list states the correct order of components for the absorption refrigeration? A) Evaporator,…

Q: A device that opens when condenser pressure rises 19. to a proper level and closes to block the flow…

Q: safety measure

A: Hello you are asking about cardioxide refrigerant but currently there is no such a refrigerant in…

Q: The agent acting in between hot body and cold body is a Air conditioner Select one:

A: It is asked if Air conditioner is the agenet that acts between hot body and cold body.

Q: Describe the procedure for using air bleedvalves to purge air out of a cooling system.

A: Hot spots in the cooling system are usually caused by replacing a system component, refilling the…

Q: Which of the following is true regarding the refrigerantpiping on a rooftop package unit?A. The…

A: The rooftop package unit is a type of system in that all components that necessary for conditioned…

Q: What should you do if you suspect that an alternative refrigerant had been used in the A/C system…

A: Due to the use of alternative refrigerant, the A/C system suffered a failure. To restore its…

Q: Safety measures to be observe while using CO2 in Large Refrigeration Systems

A: Safety measures to be observed while using CO2 in large Refrigeration Systems, Safety is a major…

Q: Why are the air conditioning units usually placed above head level?

A: Since cold air is emitted from the A/C unit blowers, the unit has to be placed at the top of a room…

Q: does a pump unloading

A: Unloading valves are pressure-control devices that dump excess fluid into a tank under little to no…

Q: Explain the layout and the basic operation of a centralized air conditioning system (or chiller…

Q: If the compressor and condenser fan motor will not operate but the indoor fan motor is operating,…

A: A condenser is a device or unit used to condense a gaseous substance into a liquid state through…

Q: Hermetic compressors are used mainly in smaller systems as they: * Yield higher COP Offer the…

A: Hermetic compressor have compressor and motor are in same shell.

Q: Which of the following components is NOT within the refrigeration cycle? A: Expansion valve B:…

A: To find : Which of the following components is NOT within the refrigeration cycle?

Q: Which of the following heating system is known as umbrella system? (it works against natural…

A: Given Umbrella system heating system To find Supporting statement

Q: is used to desuperheat hot-gas vapor from the 13. A discharge line. A. condenser pressure regulator…

A: Fill in the blanks,

Q: Write the name of each of the following systems and its plant type (use A, B, C, D ). Condensate…

A: A. Steam generation cycle.

Q: i) Components in the vapour compression cycle ii) The indoor unit and outdoor unit iii) Cooling…

A: Vapor-compression employs a circulating liquid refrigerant as the medium, absorbing and removing…

Q: • Non-condensable gases and air finding their way into the surface condenser are removed by: a.…

A: First Question: Ejector is the device that is used to remove the non-condensable gases and air from…

Q: Types of industrial air conditioning systems.

Q: Which one of the following is a CFC refrigerant?

A: Given; Choose the CFC refrigerant for the following;Where, CFC stands for; Chlorofluorocarbon

Q: How the vapor cycle air conditioning system works?

Q: What type of control would be used to turn a compressor off in the event of a large refrigerant leak

A: Low pressure control system is a type of accessory used in many refrigeration system. This is a type…

Concept explainers

Hydronics

Question

Which of the following components are common to most automatic control systems for residential split air conditioners?

a. Thermostat, contactor, transformer

b. Thermostat, magnetic starter, contactor

c. Thermostat, diode, contactor

d. Thermostat, time-delay relay, contactor

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Which of the following statements is false? The condenser is normally mounted just in front of the radiator. The receiver/dryer is a storage tank for the liquid refrigerant from the condenser. An accumulator is not used in any system with a receiver/dryer. All of the above.
What type of control would be used to turn a compressor off in the event of a large refrigerant leak
to run d. both a and b 44. Ifa thermostatic expansion valve's thermal bulb came loose from the suction line at the outlet of the evaporator, whích of the following could result? The bulb pressure would increase and the c. thermostatic expansion valve would open. b. The superheat in the evaporator would decrease. a. Liquid refrigerant would flow back to the compressor. d. All of the above are correct. 45. If the thermal bulb assembly develops a leak, what will occur? All of the system's refrigerant will leak a. The valve will open to allow more c. refrigerant to flow. d. It will have no effect on system operation. out. b. The bulb pressure will reduce and the valve will close. 46. The purpose of an externally equalized thermostatic expansion valve is to compensate for excessive evaporator pressure drop b. allow system to equalize faster a. prevent the expansion valve from frosting up d. c. allow refrigerant to expand in the compressor 47. The primary function of an expansion device is…
8. What would be done to increase the compressor speed on a belt-driven compressor? A. Decrease drive pulley size B. Increase drive pulley size C. Increase driven pulley size 13. What lubricates the refrigeration compressor? A. Refrigerant B. Moisture C. Desiccants D. Oil D. Both A andC 9. Describe the reciprocating compressor piston, rod, crankshaft, valves, valve plate, head, shaft seal, internal motor overload device, pilot-duty motor overload de- vice, and coupling. 10. Name two things in the design of a reciprocating com- pressor that control the efficiency of the compressor. А. 14. What can the service technician do to keep the refrig- eration system operating at peak efficiency? 15. List the main advantage that a discus compressor's valve plate design has over a conventional piston-type В. 11. At what speeds in rpm does a hermetic compressor nor- mally turn? A. 1750 В. 3450 C. 4500 D. Both A and B 12. What effect does a slight amount of liquid refrigerant have on a compressor…
If a hot water reheat coil is installed with a two way modulating valve. A. The VAV box can only be used for a heating-only application . B. A variable volume circulating pump must be used. C. A constant volume circulating pump can be used. D. The VAV box can only be used for a cooling-only application
Select the simple system from the following. a. Air conditioner b. Closed loop room heating system c. Speed control of Motor d. Lamp with on/off switch
If the thermostat contacts are closed the compressor and the condenser fan motor are not operating, and all the other loads are operating properly, which might be the problem? A. A bad high pressure safety switch. B. A bad low pressure switch C. Both A. and B. D. A bad thermostat
On most residential air conditioning units, the condensing fan motor is controlled by? a. Transformer b. High pressure safety switch c. Compressor contactor d. Indoor fan relay
Which of the following is true regarding the refrigerantpiping on a rooftop package unit?A. The discharge and liquid lines must be field installed.B. The suction and liquid lines must be field installed.C. The discharge and suction lines must be field installed.D. No refrigerant lines are field installed.
Select the most accurate system from the following, O a. Lamp with on/off switch O b. Room heating system O c. Traffic light O d. Air conditioner
Sketch of air conditioner
All of the following are true statements about flushingan A/C system after a compressor failure, except __ .a. the condenser must be flushed and the receiver/dryer replacedb. filter screens are sometimes located in the suctionside of the compressor and in the receiver/dryer.These screens confine foreign material to thecompressor, condenser, receiver/dryer, and connectinghosesc. use only CFCs for flushing. After the system hasbeen flushed, be sure to oil all components thatrequire itd. some manufacturers recommend replacing theclogged components and installing a liquid line(inline) filter just ahead of the expansion valve ororifice tube instead of flushing the system