Which of the following compensator is used to reduce the voltage drop at the receiving end? O Lead Compensator O Shunt Compensator O Lag Compensator O Cascade Compensator

Q: At high frequencies in an AC bridge, the source is _______ a) tuned amplifiers b) oscillators c)…

A: Electronic oscillators are used as a source of bridge measurement in the AC bridge circuit on high…

Q: 31. In a certain two-stage amplifier, the lower critical frequencies are fe(1) = 125 Hz and fe(2) =…

A: As per the guidelines of Bartleby we supposed to answer one question from remaining questions we…

Q: R V = 12 V, V1 = 6 V Determine the maximum output voltage O 18 V O ov O 6V O 30 V

A:

Q: series BIC circuit with R = 10 Q and wo = 1000 rad/s with a very high quality factor Q = 20.

A:

Q: Vo RP di

A:

Q: R, V, 8.3 V RL 0.7 V Determine the output V0 of above shunt regulator circuit

A: Zener diode is heavily doped semiconductor that conduct in forward and reverse direction In forward…

Q: In a step-up converter, Vd =12 V, Vo = 24 V, I0 = 0.5 A, L = 150 µH, C = 470 µF, and fs =20 kHz. •…

A: A step up converter has, Source voltage (Vd)= 12 V Output voltage (Vo)=24 V Output current (Io)=0.5…

Q: 28) In a certain oscillator A = 20. The feedback circuit must have gain magnitude of: 0.05 0.025 O…

A: As per the policy, I can attempt only first question.   28.   The gain is given as, A = 20

Q: If the highest modulating frequency is 3 kHz and the maximum deviation is 6 kHz, what is the…

A: Given that  highest modulating frequency (fm ) =3 kHz maximum deviation(fd)max =6 kHz Although…

Q: At the upper critical frequency, the peak output voltage of a certain amplifier is 10 V. The peak…

A:

Q: I need the answer as soon as possible 36. Recognize the type of filter, find wo and Q R Vo Vx Vin

A: The solution is given below

Q: Hw)ALow Pass Filter Sircuit Conlis ting of aresistor of 5052 inseries with a Cafacitor of 5onF is…

A:

Q: Circuit Analysis. 4. If the minimum frequency is reduced to 100 Hz, what value of bypasscapacitor C2…

A:

Q: or melho a) output Current io (t) if VCH) =20 Con (377t +45) b) what is Hhe Phase angle difference…

A:

Q: In a certain oscillator, Av=120z200°. The attenuation of the feedback circuit must be 0.0083/160…

A:

Q: Which of the following compensator is used to improve the relative stability? O Lead Compensator O…

A: In this question we need to find a which compensator is use to increase the relative stability.

Q: perive the expteksio n of resonance foeque hcy and Calculate gesonaut foqueng fx R= 40. C=4uf el= Oo…

A: Inductor is passive element that store energy in magnetic field. Capacitor is an electrical…

Q: 2.2 k2 +30 V Vout Vin O V 12 V- -30 V +

A: problem on diode circuits. Look below for the soltion:-

Q: Choice the correct answer: Operational amplifier work in …. 1) DC only 2) AC only 3) both AC and DC

A: Operational amplifier : Operational amplifier are the integrated circuits which are mainly used for…

Q: Series RLC H() 40 20 700 180 100 (ap) e Phase (degy

A: It is given that: vin(t)=5 u(t) Vt=1 s The given magnitude and phase diagrams are:

Q: In the midrange of an amplifier's bandwidth, the peak output voltage is 6V. At the lower criticar…

A:

Q: i. To amplify the signals we use [ ] a) Attenuators b) Compensator c) Bandwidth d) None

A: The basic problem on amplifier.

Q: (b) A power amplifier is illustrated in Figure (b), showing the values of some circuit elements. (6)…

A:

Q: In CRO ,the vertical deflection system consists of an input attenuator, which is used to reduce the

A: Vertical deflection system consists of input attenuator

Q: Calculate the voltage gain and power gain in dB. Zin =10 KΩ, RL = 600 Ω, Vin = 20 mV, Vout = 500 mV

A: In this question, Calculate the voltage gain and power gain in dB. If input impedance Zin =10 KΩ,…

Q: v) Derive an expression for the cutoff frequency. vi) Calculate the output voltage at frequencies:…

A:

Q: (b) The output voltage of an amplifier is 2 V at signal frequency of 3 kHz, and reduced to 0.5 V at…

A: We need to find out the output voltage for given change and we will find out change in voltage for…

Q: The amplifier circuit below has a single ac input and two ac outputs. Assuming transistor parameters…

A: "According to the Company's policy we will solve the first three parts of the question". Given the…

Q: · The epuaton of impedance of the generatar in fuction of the fregnency A

A:

Q: Active low Pass eilter /Dayn non-inueting that hos ain 10 at low frefunins, a high frop Cht-off 170…

A:

Q: 2. DI -不 D2 RZA RaB un ni v. Vo choose va lues Jor G = C4 and ReB so that this circuit will…

A: An operational amplifier (op-amp) is an analog circuit block that provides a single-ended voltage…

Q: Positive clipper remove the - -of the AC input signal O a. Positive cycle O b. Both positive and…

A: a..>> positive clipper clips the positive cycle of the input ac signal. So,positive cycle of…

Q: nvolution between the fo

A: Given the signal: We need to find and the graphical convolution of f(t) and h(t).

Q: hello, please answer the following question a,b,c and d. please make sure you understand the…

A:

Q: At summing point, more than one signal can be added or O Multiplied O None of the answers O Divided…

A: Four options are given we need to choose the correct option for the completing the given statement.

Q: Select an answer 1. The heart of an AM modulator is the block: A. Integrator. B. Adder. C. Mixer. D.…

A:

Q: If the cut-off frequency of a HPF is increased, the bandwidth will be * Becomes zero Increased Not…

A: The power circuit has some ripple frequency. Pure AC and pure DC signal does not exist.  Filter…

Q: Ex: Detarmine the lower cutoff frequency of the following ampli fier. 1ok Vout H 0.00l uF lok looM

A:

Q: What is the average value of output voltage, if the ON time of a step up chopper is 0.2 times the…

A: In this question we need to find a average output voltage of the chopper.

Q: In p-channel JFET, the cut off voltage is negative. Select one: OTrue O False

A: For N-channel JFET, the cutoff region point is reached when the gate-source voltage, VGS, goes below…

Q: Q2/ Calculate the lower and upper cutoff frequencies of the bandpass Rilter Shown below 4.1K 20k 20k…

A: The expression for the lower cutoff frequency of first order band pass filter is given as:

Q: In the following improved push-pul stage, the DC Vg is used to eliminate the dead aone -Vee K..…

A:

Q: (), On the emror. 03: It there is a gain in the Formand path, estinate es effect

A: Steady state error for any system is the difference between input and output of the system as time…

Q: 25   CRT is the heart of the CRO Select one: True False

A:

Q: In non-inverting amplifier, the phase shift between the input and the output is equal to 0° 90° 180°…

A: 0 degree.

Q: Which of the following compensator increases the margin of stability? O Lead Compensator O parallel…

A: Compensator increase the stability

Q: The capacitance of the resonant converter having fixed value of resonant frequency 60 Hz and…

A:

Q: Series-parallel compensator is otherwise called as cascade compensator. Select one: O True O False

A: In order to provide a suitable performance, it is required to adjust the control system design this…

Q: are used to increase the temporary voltages. over Static Var compensators Select one: O True O False

A: SVC tends for Static Var Compensator.