A simply supported beam L meters long carries a uniformly distributed load of  6.8 KN/m  over its entire length and has the cross section shown .  If the L used will cause a maximum flexural stress of 35 MPa, what maximum shearing stress in MPa is then developed?

Q: A steel structural member of rectangular cross-section 50 mm wide x 200 mm deep carries a…

A: a) stress : stress =Compressive loadArea Area = b*d b is the width of the member  d is the depth of…

Q: A timber beam triangular in section of base 100 mm and altitude 200 mm carries the loading as shown.…

A: Solution:- We know that, bending equation: MI=σY=ER Bending moment due to udl: BM=wL28 =w×338 =1125w…

Q: A simply supported beam has a concentrated load at midspan. If the beam properties are given below,…

A: Maximum moment due to concentrated load at mid span will occur at the mid span.

Q: An 2014 T-6 aluminium flag pole with a hollow rectangular section experiences a wind force of 750 N…

A: ultimate tensile strength : A tensile test is commonly used to determine ultimate tensile strength,…

Q: 2. For the beam loaded as shown, find the maximum tensile and compressive flexure and shearing…

A:

Q: A beam simply supported over a span of 9m is loaded with a uniformly distributed load of 48 kN/m.…

A: Given: The length of the beam is 9 m. The UDL on the beam is 48 kN/m. The width of the beam 200 mm.…

Q: We constructed a half bridge with two strain gauges in order to capture the effect of maximum normal…

A:

Q: Problem 1. Classify the pre – stressed beam (shown in the figure) at midspan if it is uncracked,…

A:

Q: Q- A circular beam of 100 mm diameter is subjected to a shear force of 30 kN. What is the maximum…

A: Given data: Diameter of circular beam, d = 100 mm Force, F = 30 kN

Q: 20 mm 60 mm 20 mm Figure Q4 - Beam Cross-Section ws oz ww 09 20 mm

A:

Q: A simply supported beam is carrying a unıform load. It the beam prop below, what is the final stress…

A: Introduction: Prestress of concrete is basically concrete in which internal stress of suitable…

Q: B\\ A simply supported post-tension beam as shown below it's carries a uniformly distributed service…

A: The post-tensioned beam is a horizontal member of the building or structure in which the steel wires…

Q: The steel beam has the cross section shown. The beam length is L = 6.7 m, and the cross-sectional…

A: L = 6.7 m d = 355 mm bf = 205 mm tf = 13 mm tw = 9 mm

Q: A decorative concrete beam is simply supported over a span of 16 m. The beam weighs 4 kN/m and the…

A:

Q: A simply supported steel beam ODD:9m EVEN: 8m long carries a uniformly distributed load of 21KN/m…

A: Span of simply supported beam = 9 mUniformly distributed load = 21 kN/mCentral concentrated load =…

Q: A trailer truck crossing a 10-m span circular beam ( D = 400 mm ) has axle loads of 7 kN, 9 kN, and…

A:

Q: A simply supported beam of length 4m is subjected to a uniformly distributed load of 2 kN/m. What is…

A: Given data  b = 100 mm  d = 200 mm  Find maximum shear stress in rectangular section.

Q: beam has a uniform dead load and live load has a fixed support at both ends. If the beam properties…

A:

Q: A beam has a uniform dead load and live load has a fixed support at both ends. If the beam…

A:

Q: A cantilever simply supported beam, which carries a uniform load of 64 kN/m, has an unsupported span…

A:

Q: The service loads acting on a structural member are as follows: DL = 80 kN/m; WL = 50 kN/m The limit…

A:

Q: A simply supported beam of width 100 mm, depth 150 mm and a span of 2 m carries a point load of 10kN…

A: Given data- simply supported beam-width b=100 mmdepth d=150 mm span L=2 mpoint load P= 10kN at the…

Q: A 4 m long S130 x 22 steel beam carries a uniform varying load from zero at the left end to 15 KN/m…

A: Given- A 4 m long S130 x 22 steel beam as shown below-

Q: A rectangular beam of width 500 mm and depth 600 mm is subjected to shear force of 400 KN. The…

A:

Q: Consider a circular beam 8 m long and 600 mm in diameter subjected to uniformly distributed load of…

A: For given circular beam,Length,L= 8 mDiameter, D= 600 mmLoading, 30 kN/m uniformly distributed load

Q: Find the total deformation for the bar shown in fig. if the axial loads are applied if cross section…

A:

Q: A cross section through a wooden beam 200mm side by 220mm deep is shown in figure 3a. The beam has…

A:

Q: A simply supported beam is carrying a uniform load. If the beam properties are given below, what is…

A:

Q: m wide by 290 mm high ro at the free end to 130

A:

Q: A bar having a cross-sectional area of 700 mm² is subjected to axial loads at the positions…

A:

Q: A beam has a uniform dead load and live load has a fixed support at both ends. If the beam…

A:

Q: In a rectangular beam of size 200 mm x 400 mm, if the ultimate shear force due to design load is 80…

A: Width b=200 mm, Depth d=400 mm, Ultimate shear force due to design load=80 kN,

Q: 20 kN/m ↓↓↓↓ 5m 30 kN 5 m 10 kN W610 x 82 The W610 x 82 beam shown above has a Young's modulus of E…

A: Beam: Beam size: W 610 x 82 Young’s modulus: E = 200 GPa Allowable bending stress: σallow= 300 MPa…

Pressure and Stress