When using a double acting pressure intensifier for continuous pressure increase, we are looking to have pressure intensified brand operate at 5L/min at 30 MPA. If the main pump can supply 10L/min at 10 MPA, what is the diameter ratio needed between actuator and boosting piston?

Q: can you include all the calculations step by step please, such as scaling law and propulsive…

A: We apologize for the earlier confusion. The correct solution is given below.μ = 5V = 100 m/sVh​ =…

Q: om the dala given beIOw, calculate the power requin an axial flow compressor. Lo arive the…

A: Handwritten.jpg

Q: In an Otto cycle, air is cơmpressed from 2.2m to 0.26m2 from an initial pressure of 1.2kg/cm2. The…

A: Otto cycle is the standard cycle used in Spark Ignition engine. In Otto cycle, intake of air-fuel…

Q: Show the arrangement of blades in an axial compressor with two stages. Show graphically the…

A: The  axial compressor are very high speed compressors used to compress the air. In this type of…

Q: How do we find the force and pressure exerted in using a 12 volts mini reverse air pump and a 25mm…

A: Given: Mini reverse air pump = 12 V Round suction cup diameter= 25 mm To find: Force and pressure…

Q: D1/ The folle and a fixed r blade speed angle of the fa factor for all Using a suitat (i) Developed…

A: INTRODUCTION : Steam turbines are the prime movers in which the heat energy of the steam is…

Q: takes minimal effort to recognize where energy can be saved. However, it takes cond efforts to…

A: Working principle of lobe compressor A gear with a narrow clearance but no metal-to-metal contact…

Q: running and delivering air at 12

A: Given: t=12 minPmax=180 PsiPmin=155 PsiQr=25 scfmQc=0

Q: ortunities to recogni at these en

A: given:

Q: Compression ratio in Diesel Cycle will be 2.5 time higher than the cutoff ratio. Volume at TDC is…

A: The diesel cycle is an air standard cycle that diesel engines work on. It comprises one adiabatic…

Q: Energy-saving opportunities are present everywhere in compressed air systems, it just takes minimal…

A:

Q: B) A single stage, double acting air compressor running at (650 rpm) has a FA.D. of (16 m'/min)…

A: This question is related to the single-stage, double-acting air compressor. In the double-acting…

Q: 2. A civil transport aircraft powered by a four turbojet engines is flying at Mach number of 0.8 and…

A:

Q: ..Equation for Law of conservation of mass and energy for a nozzle

A: Law of conservation of mass (For nozzle) The mass is conserved during the process, the mass of fluid…

Q: Q5) A turbojet engine is operates at altitude where temperature and pressure are 216K, 60kPa…

A: Disclaimer: "Since you have posted a question with multiple sub-parts ,we will solve first three…

Q: A flexible tube peristaltic pump operates at 100 rpm, with a lobe volume of approximately 3 ml. What…

A:

Q: 1.- A pump feeds a boiler taking water at 75°C from a constant level tank. The suction pipe is 100 m…

A: Pump detailsSuction pipe length = 100 msuction pipe dia = 5 in = 0.127 mDelivery pipe length = 150…

Q: DC heater pressure = 50 psig, Assume: pump efficiency of 70%, water is at saturated cor ressure from…

A: TO given thatwater mass flow rate,m=100000Ib/hr=12.5998KG/Sout let…

Q: Apply the steady flow energy equation to nozzle, compressor, turbine, boiler, and mixing  chamber.

A: During steady flow-process, the total energy of a control volume remain constant i.e., ECV=constant…

Q: A closed type injector has a nozzle orifice diameter of 0.949 mm and the maximum cross sectional…

A: To find: The volume flow rate of fuel through the injector and the velocity of jet. Given: The…

Q: report about gas turbines in racing cars. I need more information for (powerpoint).

A: TURBINE: A turbine (/ˈtɜːrbaɪn/or/ˈtɜːrbɪn/) (from the Greek τύρβη, tyrbē, or Latin super, meaning…

Q: 1. define the cutfof ratio and the compression ratio     2. air is compressed at a constant…

A: Define cutoff ratio and compression ratio

Q: A centrifugal pump delivers 900 ?3/ℎ? of sea water (sp.gr.= 1.03) from a source where the water…

A: given:Pump delivers=900 m3/hrspecific gravity of sea water=1.03water level=2 mLocation of pump=2.6…

Q: ck work ratio, Thermal Efficiency (% No Description Pressure ratio=B Ratio…

A: Given, T1 = 27oC = 273 + 27 = 300 K P1 = 100 kPa Compressor Ratio1  = 7 Compressor Ratio2  = 12 From…

Q: Define the overall pressure ratio of a two stage compressor? A- It is the ratio of isothermal power…

A: For a gas turbine the overall pressure ratio for any two stage compressor is defined as the "ratio…

Q: A 4-stage centrifugal pump discharges 1000 gpm of water at 1750 1pm with a total heat head of 1000…

A:

Q: Draw the different cases for the inlet and outlet velocity triangle for centrifugal compressor. Also…

A:

Q: Problem 5: Calculate the thrust of a gas turbine engine if the exhausting jet expands to ambie…

A:

Q: 3. The power output is 30 hp to a centrifugal pump that is discharging 900 GPM at which operates at…

A:

Q: The inlet and exit blade angl e axial direction. The inlet st e assumed to be a constant ssor is…

A:

Q: recognize where energy can be saved. hese energy savings can be maintain air systems or application…

A: Given

Q: 7. A mobile application with the pump driven directly from the engine delivers 12 gal/min at a…

A: Introduction: Pumps are used to move fluid from one location to another in order to convert…

Q: A single reciprocation compressor takes 1m³ of air per minute and 1.013 bar and 15 degree Celsius…

A:

Q: A single stage single acting air compressor with runs at speed 600 rpm. It has a polytropic index of…

A:

Q: Ans. 3908 m’/min. 14.5 Find the cylinder dimensions of a single-cylinder, double-acting compressor…

A: Answer: The dimensions of the cylinder are: D = L = 27.865 cm.

Q: Q2/ The compression ratio of a diesel engine is 20, and cut-off occurs at 5% of he stroke. Calculate…

A:

Q: b) A single-acting, two-stage reciprocating air compressor runs at a speed of 500 rev/min with…

A:

Q: Fixed geometry jet engine inlet is not feasible for very low supersonic Mach no.

A: In order to achieve optimal operational efficiency, the air flow into the compressor should be…

Q: For a centrifugal compressor rotating at 2500 rpm, find the compression ratio for the following…

A: Given that, Ta0=300 K,N=2500 rpm,ηst=0.85rb=0.55,ra=0.015,Q=1.25 m3/sec,βb=60°t=0.15 m,   Determine…

Q: . Calculate 1.The delivery air indicated power in KW to two decimal places. 1.The volume of air…

A:

Q: Derive an eeporession for Gysoscopic Couple

A: The answer is given in next step

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.