When there are,into action to prevent instability.in the power system, the voltage regulators will comeO Current variations in power systemO Oscillations in power systemO Voltage variations in power systemO Swinging in power system

In the power system, the voltage regulators are come into the action to prevent instability due to…

When there are in the power system, the voltage regulators will come into action to prevent instability. O Current variations in power system O Oscillations in power system O voitage variations in power system O Swinging in power system

When there are in the power system, the voltage regulators will come into action to prevent instability. O Current variations in power system O Oscillations in power system O voitage variations in power system O Swinging in power system

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 4. The simplest way to reverse the rotation direction of a three phase AC motor is Use stator CEMF…

A: In this question we will write about the simplest way to reverse the rotation direction of three…

Q: A generator is delivering power to infinite bus during post fault condition is 1.10 p.u at a power…

A: The solution can be achieved as follows.

Q: Line current drawn from an inductive load is 5A at a power factor of 0.8lagging, if power factor is…

A: Choose the correct option Line current drawn from load is 5A at power factor = 0.8 What is Line…

Q: The winding data for three different alternators are as follows I. 60 slots, four poles, span 1 to 9…

A: pitch factor=cos(short pitch angle2). slot angle=180slot /pole.

Q: The loss of generation in a generator which is meeting a huge amount of demand in small grid is…

A: In small power plant loss of generation is directly affect the load and after the loss of generation…

Q: FROM METER L N NL LN SWITCH RCCB MCB MCB FUSE C6 N L L N N Name: No. Matriks: Radial □ 0 Radial MCB…

A: The given diagram iss hown below.We need to draw the fittings or the wiring connections for this…

Q: V. Peak-to-peak voltage for 40VAC is 80

Q: Check the correct statements.

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: A compound generator has a no load voltage of 136 V and a full load voltage of 145 V. Calculate the…

Q: A Chopper circuit is operating at a frequency of 2 kHz on a 460 V supply. If the load voltage is 350…

Q: How many poles must be used for 100kW, 230V, 80 Hz alternator running at 10 rps speed?

Q: A non-liner load is connected to a 220 V, 50 Hz power supply. Determine the harmonic order of the…

A: When the supply voltage is balanced then it does not contain harmonics. when a linear load is…

Q: Compare between 2-pha motor and universal mot

A: On the basis of constructional details and basic working principles motors are classified into…

Q: The number of currents alternating at different time intervals in an alternating current circuit are…

Q: Instantaneous power output of a single phase 60 Hz generator will not be constant under following…

A: Instantaneous Power: Instantaneous power is defined as the electric power available at any given…

Q: What happens when the duty cycle changes

A: Duty cycle=(Ton)/T Ton= On time. T=Period of time.

Q: Lightning over-voltages and switching phenomena of switchgears are two examples of transient…

A: Lightning surge: A lightning surge is a very short burst of high voltage which if not suppressed can…

Q: What are rotor faults in alternators

A: The rotor of an alternator is directly connected with field winding of the alternator whenever there…

Q: For a system if the value of peak overshoot is 22 %, then the value of damping ratio Oi is

A: Peak over shoot pos = 22% = 0.22 Damping ratio Zeta

Q: QUESTION THREE a)A single phase haf wave controle rctifer suppies a 1KQ resistor. Ifthe peak voltage…

A: The single-phase half wave rectifier consisting of the SCR having firing angle 60 degrees. The…

Q: 12 - Which of the following power plant is based on wave energy? a. Off Shore System b. All of…

A: Off shore system and on shore system are based on wind energy.

Q: what would be the minimum size feeder conductor THHW 75 degrees for four 30- amp motor generator arc…

A: To find minimum size feeder conductor THHW 75 degrees motor generator arc welders = 4 numbers , 30…

Q: Explain briefly why is there no wattmeter reading when the load is purely capacitive.

Q: to

Q: • A snubber circuit has snubber time constant (10 msec), voltage source (10 kV), discharge current…

A: The snubber circuit consist of the series connected resistor and the capacitor Given Data: I = 5 uA…

Q: If it is desired to bring alternating current out of a generator, what kind of a "take-off" system…

A: If the alternating current is required from the generator a copper or brass rings are connected at…

Q: The DC shunt generator with the terminal voltage 300 V, armature drop 6 V and the each brush drop 4…

A: Please upload only one question at one time for better explanation

Q: A generating station has the following daily load cycle: Time (Hours)0-5|5-8 8 – 12 | 12 – 15 | 15 –…

A: i) From given data, It is clear from that maximum demand on the generating station is 80 MW and…

Q: A 100kW generator, 250V, 6 poles have a wave wound armature with 300 turns then the number of…

A: The solution can be achieved as follows.

Q: A 6-Pole generator operates at 1,200 rpm. a) What frequency does it generate? b) At what speed must…

Q: Determine the maximum instantaneous positive voltage drop across Rin the series AC/DC circulit belo…

A: Given AC/DC circuit, Where, AC supply voltage, Vrms=18.3 V DC supply voltage, Vdc=17 V Resistance,…

Q: Which of the following is the rotor fault of alternator? Phase to earth Over current Inter turn Non…

A: Choose the correct option Which of the following is the rotor fault of alternator?

Q: 10 kW, 230 V, d.c shunt generator is operating at rated condition with 80% efficiency. Input power…

A: In this question, 10 kW, 230 V, d.c shunt generator is operating at rated condition with 80%…

Q: Before closing the synchronism switch to connect two alternators in parallel, it is observed in a…

A: Given: A set of 3 lamps

Q: What is the phase sequence of the voltages induced in the three coils of an alternator shown in the…

A: From the given figure, the phases/windings are displaced by the 120o. Assuming the windings are…

Q: To control a three phase motor from two different places we need two contactorns Select one O True O…

A: In this question , we have to find how many contactors used to control a three phase motor from two…

Q: An alternator has 6 poles. At what speed must it be driven to develop 120 cycles? Group of answer…

A: In this question we will find speed of given machine.....

Q: Instantaneous power output of a 3-phase 60 Hz generator will not be constant under following…

Q: A short composite motor draw or pulls stream a current of 50 A at a voltage of 220 V it rotates at…

A: A short composite motor is nothing but a short shunt compound motor. The given parameters for a…

Q: circuit connection diagram on how to synchronize an alternator to the grid using lab volt. using…

A: The purpose of the synchronization is to ensure that during the circuit breaker closure (closing the…

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

When there are,
into action to prevent instability.
in the power system, the voltage regulators will come
O Current variations in power system
O Oscillations in power system
O Voltage variations in power system
O Swinging in power system

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

b) A power station has the following daily load cycle as Figure Q1(b) below: Time in Hours 6-8 8-12 12-16 16 20 20-24| 24–6 Load in MW 90 40 60 20 20 20 Figure Q1(b): Daily Load Cycle i) Plot the load curve i) Plot the load duration curve i) Determine energy generated per day
I:56)
q24 Match the following choose the correct answer Electromagnetic interference .controls voltage at all level scarry inrush current for short period disturbance of frequency around 10MH zzoning regulations shunt or series capacitors High voltage DC Transmission prevents complete shutdown cost of insulation is more Reactive power compensation .controls voltage at all level scarry inrush current for short period disturbance of frequency around 10MH zzoning regulations shunt or series capacitors High voltage DC Transmission prevents complete shutdown cost of insulation is more Tap changing transformers . .controls voltage at all level scarry inrush current for short period disturbance of frequency around 10MH zzoning regulations shunt or series capacitors High voltage DC Transmission prevents complete shutdown cost of insulation is more Single bus bar with sectionalisation ...controls voltage at all level scarry inrush current for short period disturbance of…
A 110-V, 50 Hz supply is connected across 15 ohm resistor. Determine the instantaneous current after 5 millisecond.
O Four field coils, each with a resistance of 80 ohms, in series and Supplied by a 240-volt de generator. are Connected Calculate la) the current in each resis tor (6) the voltage across each coil.
urgent please fast 15 min u have
The winding data for three different alternators are as follows 1. 60 slots, four poles, span 1 to 9 II. 120 slots, six poles, span 1 to 16 II. 144 slots, eight poles, span 1 to 11 The windings having a pitch factor less than 0.9 are a. I and II only b. I, Il and III. c. I and II only d. Il and III only
For a system if the value of peak overshoot is 16 %, then the value of damping ratio o is
11. In a certain series R-C circuit the instantaneous current is 22.1 ma two times constant (2T) or 25 msec after an emf of 115.5 volts is suddenly impressed. What are the values of R and C?
13. A rotary standard with a K of % whr per revolution and a multiplier of 3 makes 42.4 revolutions during the testing of a watthour meter with a K,, of 1.8 whr per revolution. If the meter has two current coils connected in series and makes 48 revolutions, what is the percent registration of the meter under test? A. 79.5% B. 98.1% C. 119 % D. 102%
What happens if there is only coil present in Dynamo type wattmeter?
You are working as an electrician installing fluorescent lights. You notice that the lights were made in Europe and that the ballasts are rated for operation on a 50-Hz system. Will these ballasts be harmed by overcurrent if they are connected to 60 Hz? If there is a problem with these lights, what will be the most likely cause of the trouble?