When the frequency F= 5KHz, the effective bandwidth of the following signal is approximately sin(2tkft) k 4 s(t) ==xAx π O 5 KHz O 1 KHZ O 25 KHz Σ k=1, k odd

Q: a) For the Circuit shown calculate the value of C if the resonant frequency. is 5000 vad /sec

A:

Q: The frequency response of the linear system shown in figure is x(t) jat y(t) + de -00 Delay T Delay

A: We need to find out frequency response for given system .

Q: For the following circuit, find the frequency response A(jw) = VOUT(jw) v:(jw)

A:

Q: 1.4142 H 5Ω Is 0.2 F

A: The reactance of an inductor and the reactance of a capacitor is dependent on the frequency of the…

Q: resonant frequency

A: At resonance, inductive reactance is equals to capacitive reactance. Before resonance on increasing…

Q: 10 kHz C₁ 0.68 μF -00000 420 KH R₁ 56

A: Note: Only active power will be available in purely R Load Only Reactive power will be available in…

Q: Find the receiver output SNR as a function of y = P;/No if the following AM signal is transmitted…

A: Let Power spectral density of noise signal is equal to η2. We need to find the receiver output SNR…

Q: In an RLC series circuit, the voltage amplitude and frequency of the source are 100 V and 500 Hz,…

A: Step 1:Step 2:

Q: Determine the time period of the signal x(t) = 15 sin T 4t+ + 23 cos 12t + 4 π 6

A: Given- A signal: xt=15 sin4t+π6+23  cos12t+π4.   To find- The time period of the signal.

Q: The maximum frequency deviation for the FM signal v(t)= 10 cos(6000t+ 10sin2200t) is 1750 Hz 750 Hz…

A:

Q: For the given signal, x(t) = 3+ 1 sin(0.5x t)–0.3 sin(4.5x t+120°)–2.2 cos(0.5n t) +6 e/0.257 í +6 e…

A:

Q: Low Frequency Response: Compute for the following. c. Zi

A: The input impedance of the circuit can be calculated by considering the bias resistance and input…

Q: G(f) = f – 1000 rect f +1000 le-inf1500 +rect 100 100

A:

Q: Determine the input impedance of the circuit at f = 5 hz 1 mF 100 2 8 H ell Zin 1 mF 200 2

A:

Q: In the circuit shown in Fig.5, the magnitude circuit impedance is 15/0° V L im = 2mA R 70 I=1.5mA

A: Given data, Circuit diagram is given as,

Q: Q/ For the below system, if you know that the input is r(t) = A sin(wt) , explain and draw the…

A:

Q: What is the maximum frequency deviation of the following FM signal? x(t) = 15 cos(2.4 x 10°nt +…

A: According to question: The modulating frequency is calculated as ∵fm=2×103π2π⇒fm=1000Hz The maximum…

Q: Determine the Nyquist rate for a continuous time signal x(t)= 5 cos 250πt+ 20 sin 800πt - 10 cos…

A:

Q: Draw the magnitude plot and phase plot for the following transfer function. jw + 10 H(w) = jw(jw+…

A: Given H(w)=[jw+10]/[jw(jw+5)^2]

Q: G(s): 300(s+100) s(s+10)(s+40) Show that when the phase angle of G(jw) is -180, the frequency is…

A: Gs=300s+100ss+10s+40

Q: 2. Find the resonant frequency for the circuit shown below. 9 μF Zin 20 mH ell ww 192 ww 0.1 Ω

A: In this question,  We need to determine the resonance frequency of the given RLC circuit.  At…

Q: Get the Wr and Wo for R=50 and R=5. Then complete the table.

A: The required parameters can be obtained by analysing the circuit at resonance condition.

Q: Convolution the following: A xit) t Jh(t) et

A:

Q: The maximum frequency deviation for the FM signal v(t)= 5 cos(6000t+ 10sin2200t) is 1750 Hz 750 Hz…

A: A standard FM signal is represented by v(t)= Ac cos(2πfct+ kfsin2πfmt) Ac = carrier amplitude fc=…

Q: White noise has more energy at the low frequency end of the spectrum. Select one: O True False

A: Given :    Here they have mentioned white noise.     And they are  interested to know the the energy…

Q: For the given circuit caluclate the band width by means of rad/s

A:

Q: When the frequency f= 4 KHz, the absolute bandwidth of the following signal is approximately: sin(2…

A:

Q: Replace: 18 w/ -4, 40 w/ -17, -30 w/ 11, -24 w/ -16, and 10 w/ -10. The fundamental frequency is…

A:

Q: A linear time-invariant (LTI) system has the following amplitude and phase spectra: IHOI 90 0.5...…

A:

Q: The noise voltage at the 300 resistance TV input with a 6 MHz bandwidth at 30 degs C is a. 9.6 uV b.…

A: Given: Resistance, R=300 Ω Bandwidth, B=6 MHz Temperature, T=30°C=303 K

Q: The following signal is periodic with the period of y [n] = cos(0.1mn) + 2 sin(0.1mm) samples

A: Given: y(n)=cos0.1πn+2sin0.1πn

Q: Bandwidth of PAM signal with pulse train (0.03TS) for analog signal fm 3.4 KHz %3D is O 2.35 Mhz 3.5…

A: In this question,  Choose the correct option What is bandwidth of the PAM signal with pulse train…

Q: The Figure shows a Wien-bridge network. What is the frequency at which the phase shift between the…

A:

Q: 1. Find the frequency spectra of the signals shown in Figure below 20 10 10 30 t (ms) -30 -20 -10 20

A: Let given figure be x(t) It can be represented as a sum of two rectangular pulses. And the frequency…

Q: Where does the frequency value of 7 Hz (43.98 rad/s) comefrom? 1 j0₂ 00 H(o)= @c= 1- 1 RC H(o)= =…

A: Given: Frequency value is 7 Hz (43.98 rad/s)

Q: An FM signal, 2000 sin (27 × 10³t + 2 sin 7 × 10¹t), is applied to a 50 X antenna. Determine the…

A:

Q: 8. Calculate the angle(0)at 0.5 ms for the following frequencies а) 10 Hz b) 2 kHz с) 7 МHz

A: From angle wt = theta