When looking to upgrade your gear, what are the top three factors you should keep in mind?

Analyse, using the results, how each component failed and justify how each component’s design could be improved. Figure 1   The 220mm-long bolt was used to fasten one of the engine mount to a supporting structure. In an effort to prevent the bolt from coming loose, the torque-prevailing nut and split pin were utilized to tighten the bolt. The bolt held through an aluminum housing. Due to the reduced stiffness of the fastened parts, the bolt supported a greater proportion of the applied force. The bolt's size necessitated a high tightening torque of 660 Nm (487 Lbft). Since this level of torque could not be achieved with the tools at the time, this torque was not specified. The aluminum's maximum bearing pressure was far exceeded by the bearing stress under the nut's head and face. As a result, there was excessive preload loss due to creep. fan shaft First of all, the fan shaft was required to be made of cold-drawn 1040 or 1045 steel with a yield strength of 586 MPa and the expected…

The following methods are used to distinguish between ferrous and nonferrous metals and alloys (Choose all that apply) Magnetic test Density test Chemical test Scratching Visual observation Heat treatment

What two things can happen when a flex item drops below its basis size?

Q1

Specify the structural components of a program that could pass automotive safety inspections.