When an antenna is transmitting an unmodulated carrier, then the current is 10 amps and when the antenna is transmitting amplitude modulated signal, then the current is 15 amps. Estimate the modulation index. Round the answer to the nearest tenth.

When an antenna is transmitting an unmodulated carrier, then the current is 10 amps and when the antenna is transmitting amplitude modulated signal, then the current is 15 amps. Estimate the modulation index. Round the answer to the nearest tenth.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Figure 1 shows a signal obtained after amplitude modulation by a sinusoidal message. The carrier…

A: Step 1: Step 2: Step 3: Step 4:

Q: Identify the mathematical operation performed by an amplitude modulator (AM). Division…

A: In amplitude modulation, the amplitude (signal strength) of the carrier wave is varied in proportion…

Q: Suggest an alternative circuit by which FM signal can be detected

A: The FM signal can be detected by the basic Foster-Seeley circuit shown below:

Q: Calculate the modulation index for an FM wave where the maximum frequency deviation is 50 kHz and…

A: Given: In FM wave, The maximum frequency deviation, ∆f=50 kHz The modulating frequency, fm=5 kHz

Q: 24) The total power content of an AM wave is 1600W.For a 80% percent modulation „determine : (30…

A: Since your question has multiple sub parts , we will answer only the first three parts for you. If…

Q: A FM signal has a carrier swing of 100 kHz when the modulating signal has a frequency of 8 kHz. The…

A: Given: A FM signal having Frequency swing, fmax-fmin=100 kHz Frequency of modulating signal, fm=8…

Q: Figure (1) shows the block diagram of a wideband frequency modulator using the indirect method. This…

Q: Determine n and the percentage of the total power carried by the sidebands of the AM wave for tone…

A: It is given that:

Q: 1. An FM signal has a maximum frequency deviation of 25kHz and is modulated by a sine wave with a…

Q: A superheterodyne receiver tunes at the frequency range from 25 MHz to 50 MHz. The intermediate…

Q: Calculate the modulation index (in kHz/V) in an

A: Given - Modulating amplitude = 9.3V frequency deviation = 75.1 kHz

Q: Determine the Bandwidth of a FM wave when the maximum deviation allowed is 75KHZ and the modulating…

Q: A 100MHz carrier is frequency modulated by 1 KHz wave . For a frequency deviation of 50 KHz .…

Q: A 100MHZ carrier is frequency modulated by 1 KHz wave. For a frequency deviation of 50 KHz,…

A: The solution can be achieved as follows.

Q: When an antenna is transmitting an unmodulated carrier, then the current is 10 amps and when the…

A: It is given that: It=total or modulated current=15 AIc=carrier or unmodulated current=10 A

Q: Question: The maximum deviation allowed in an FM broadcast system is 75 kHz, If the modulating…

A: FM is a type of modulation where variations in the carrier wave frequency immediately translate into…

Q: If an AM modulator has a carrier frequency of 1.1MHz and the input signal has a frequency of 2kHz,…

A: Given data is shown below. For an AM modulator carrier frequency fc=1.1MHz Message signal frequency…

Q: signal using DSB-AM. Determine the bandwidth needed to transmit 99% of a 4 Hz square wave

A: We need to find out bandwidth for given signal for given modulation .

Q: A FM signal has a carrier swing of 100 kHz when the modulating signal has a frequency of 8 kHz. The…

A: Modulation is process by which some properties of carrier signal is varied according to modulating…

Q: 5. A frequency-modulated signal, which is modulated by a 3-KHz sine wave, reaches a maximum…

A: We need to analyse the given frequency modulated signal .

Q: The AM modulation of a single frequency sinusoid (single tone information single) result in A single…

A: The AM modulated signal of single frequency sinusoidal (single tone information signal) is expressed…

Q: 1. The phase shift between fi(t) and f:(1) in QAM is a. 90° b. 180° c. 270 d. 360

A: Since we only answer one question at a time. we’ll answer the first question only.Please resubmit…

Q: di len Volt/div = 65 V for red signal, Volt/div = 24 V for blue signal and Time/div = 64 s. What is…

A: Two signals waveform are shown in the figured. Find the phase difference between both signals.

Q: A sequence of alternating Is and Os is transmitted as a square wave. What is the fundamental…

A: Solution

Q: 2. An FM signal expressed as M() = 1000cos@0r107)+0.25sin(4x10') is measured across a 502 antenna.…

A: Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: signal if the maximum voltage is 90 V and the minimum voltage is

Q: 3. What is the best value for the modulation index, k. What will happen if B> A?

A: The best value for the modulation index, k, depends on the specific modulation scheme and…

Q: single side spe ctrum for Home worlc: s ketch the function. the same 6 - 16

Q: 7-11 A90-MHz carrier is to be frequency modulaled by a 2-kHz tone. The maximum frequency deviation…

A: Brief description : Modulation technique is one of the major advantage which is exist in the…

Q: When an antenna is transmitting an unmodulated carrier, then the current is 10 amps and when the…

A: Given: Current while transmitting an unmodulated carrier I0=10 A Current while transmitting…

Q: It's simply the proportion of the actual frequency deviation to the maximum frequency deviation.

A: Percent modulation is the proportion of the actual frequency deviation to the maximum frequency…

Q: A desired signal at 26.2 MHz is mixed with a local oscillator of 42.0 MHz. What is the image…

A: Given: Desired signal frequency, ftrx=26.2 MHz Local oscillator frequency, f0=42.0 MHz

Q: What is the frequency of the ISM frequency band?

A: The ISM frequency bands are the bands (or Radio Frequency Spectrum) reserved for only Industrial,…

Q: b) Double-Sideband Amplitude Modulation (or DSB-AM) is one of the simplest modulation schemes used…

A: i) We need to draw a DSB-AM waveform in the time domain, identifying any key features. ii) We need…

Q: Question 9 The AM modulation of a single frequency sinusoid (single tone information single) result…

Concept explainers

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.

Question

When an antenna is transmitting an unmodulated carrier, then
the current is 10 amps and when the antenna is transmitting
amplitude modulated signal, then the current is 15 amps. Estimate
the modulation index. Round the answer to the nearest tenth.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Make an essay about "how filter circuits for AC and DC power supply works"
Includes codes used in octave gnu
In an amplitude modulation process, write what name the signals indicated in diagram 1 receive A) signal at frequency of 1400kHz B) signal b with a bandwidth of 300Hz to be transmitted C) Signal c
1. Calculate the total power of AM signal (par-A). 2. Calculate the bandwidth of AM signal (part-A). 3. Draw the spectrum of AM signal (part-A). DC Vmax Vmin m 3v 1.4 0.25 0.7 2v 1 0 1 1v 0.8 -0.36 1.94
An FM transmitter operates on a frequency of 100.3 MHz. The modulating frequency is 15 KHz. The maximum FM deviation is 075 kHz. What are the maximum and minimum frequencies that occur during modulation? What is the rate the carrier changes frequency?
In an AM system, the carrier with frequency of 10 MHz and amplitude of 10 V is modulated by an audio frequency signal of 3 KHz frequency and a 6 V amplitudeEstimate the depth of modulation and draw the spectrum for(a) 100% modulation(b) 60% modulation
For which frequencies amplitude modulation is used?
Sub:communication Need solution please
When an antenna is transmitting an unmodulated carrier, then the current is 10 amps and when the antenna is transmitting amplitude modulated signal, then the current is 15 amps. Estimate the modulation index. Round the answer to the nearest tenth.
When an antenna is transmitting an unmodulated carrier, then the current is 10 amps and when the antenna is transmitting amplitude modulated signal, then the current is 15 amps. Estimate the modulation index. Round the answer to the nearest tenth.
‏In case of the amplitude modulation of an information signal A)the modulated signal has a single frequency which is the carrier frequency . B)the modulated signal has three components with the frequencies fc , fc + fm and fc - fm C). the modulated signal has a single frequency which is fm . D)none of the other answers is correct
In an amplitude modulation (AM) wave with 100 % modulation (ma), the carrier is suppressed. The percentage of power saving will be?