What type of bridge is this? Why is it called the type that it is? Explain how this bridge works.

Q: Q3: For a beam with the cross-section shown (w=8 in. and h -6 in.), find: a) The distance from the…

A: Moment of inertia  The Place The cross-sectional area's moment of inertia of a beam gauges the…

Q: 1.67 Determine the orthogonal component of C= rx F in the direction of the m, F = 300i 100j + 500k…

A:

Q: The joist AB used in housing construction is to be made from 8-in. by 1.5-in. Southern-pine boards.…

A:

Q: Determine the purchase quantity and number of board feet of 2 × 12 joist needed for the floor in the…

A:

Q: ater flows in a 1.5-m wide rectangular channel with a constant bed slope So = 0.19. The…

A: In this question we will firstly find the area of the bed. Then we will calculate the value of the…

Q: Show complete solution. Draw all necessary diagrams/illustrations. Using elastic method, compute the…

A: The given figure is shown below:

Q: Determine the force in each member of the truss and state if the member are in tension or…

A: Given :

Q: 8" H E = 36,000 ksi 5" Max Bending Stress: 1.25" TYP A simply supported beam has a symmetric cross…

A: Given Vmax = 800lb Mmax = 2400 ft-lb Required Maximum bending stress

Q: Calculate the x-, y-, and z-coordinates of the mass center of the brac 105 mm 230 mm 110 mm 180 mm…

A:

Q: 1. An A992 steel W150 x 22 column is braced at the top against both x and y displacement but not…

A: The given data is: AT section W150x 22 consider the following properties. A=2860 mm2Ix=12.1x106…

Q: The permissible bending compressive strength for M 25 grade of concrete is 8.5 N/mm². Its short-term…

A: Given: Bending compressive strength Grade of concrete  To find: Short term and long term modular…

Q: SITUATION 11: A 300-mm diameter test well penetrates 27 m below the static water table. Water is…

A: Given a 300 mm diameter test well y = 27m; Water is pumped at a flow rate of 69 l/sec   The rate of…

Q: Please show the complete solution. M 10' L B L Answer: CD-i 6 panels at 4¹ K L D L E L H L F L Find…

A:

Q: a. 9.30 kN b. 18.61 KN c. 37.21 AN d. 74.42 kN Compute the value of eccentricity e. 0.026 m 0.062 m…

A:

Q: For the beam and loading shown, use the double-integration method to determine (a) the equation of…

A:

Q: Sub 8 KN ✓ A 16 KN ↓ U₁ 4₁ 16 KN J U₂ L2 16kN 1 M 16kN U4 35-m 16KN U3 4₁ 16kN 1 U₂ L₂ 16kN U₁ 8KN…

A:

Q: a Pile have diameter of 0.4 m and ultimate pile capacity 12000 Kn, F.s=3 if the load will applies =…

A:

Q: A cylinder (2.0 m diameter, 3.0 m long and 25 kN weight) is acted upon by water on one side and oil…

A: Given- Diameter of cylinder D=2 mLength L=3 mWeight W=25 kNSG=0.8It is needed to find the ratio of…

Q: 3. What type of major urban structure is supported by congestion pricing and park-and-ride…

A: Hi! Thank you for the question.  As per the honor code, we’ll answer the first question since the…

Q: The natural moisture content of a soil sample is found to be 30%. It has been calculated that the…

A:

Q: Determine the forces in members BE and CE of the loaded truss. The forces are positive if in…

A: Given data  Load acting at node B = 6 KN  Load acting at node C = 3.1 KN  Angle between AB and AE is…

Q: Compute the vertical component of the resultant between blocks B1 and B2 considering uplift force.…

A: To Determine: The vertical component of the resultant between blocks B1 and B2.   Explanation: The…

Q: How did you get 42799.532?

A: Problem Explain the steps taken to get 42799.532

Q: Why foldable wagon is important for apartment/high rise building?

A: In this question we are asked to find importance of all types of foldable wagon specially in case of…

Q: A +2.50% grade sets a -1.75% grade at station 44+25 and elevation 386.96 ft, 400ft curve, stakeout…

A: Given :

Q: please

A: Iy,triangle=Iyy+Ax2Iy,triangle=1603×1603+12×160×16023×1602=0.36408×109mm4

Q: A truck weighing 5 kips is traveling with a constant velocity of 55 mph when brakes are applied…

A:

Q: A 1.0-kg ball has a velocity of 12 m/s downward just before it strikes the ground and bounces up…

A: given data,             mass of ball=1kg             velocity just before strikes(V1)= 12m/s…

Q: A simple torsion-bar spring is shown. The shear stress in the steel [G= 11,500 ksi] shaft is not to…

A:

Q: Determine the forces in members CD, CJ, and DJ. M A L 6' B L 6 panels at 3¹ K C L D L I H E L F L L…

A:

Q: Reflection on the most dangerous bridges in the world

A:

Q: For the beam shown, EI = 24 × 10° kip-in² over the length of the beam. The slope (rad) of the beam…

A: Slope and Deflection The angle between the deflected beam and the real beam at the same spot is…

Q: as snow figure, exerted on the boom, for the equilibrium of the system. cable Figure

A:

Q: Q.A D400 circular cast iron manhole cover on a weighbridge has a diameter of 600mm and thickness of…

A: As per Bartleby answering guidelines we are supposed to answer first 3 subparts, please post other…

Q: A rigid beam of weight W= 800 lb hangs from three equally spaced wires, two of steel and one of…

A: Given :

Q: Find the angle a. 235 lb a Answer: a = i 10.4' B 3.6 56 O

A:

Q: Two cables are used to hang a traffic light as shown in Figure 1(b). The weight of the traffic light…

A: We have to find the magnitude of the force F and it's direction.

Q: Design a non-air-entrained concrete mix for a small job with a nominal maximum gravel size of 19 mm.…

A: Given:- gravel size=19mm To find:- a non-air-entrained concrete mix for a small job  a. mass of…

Q: Calculate the moment of inertia of the shaded area about the x-axis. 66 mm A 25 mm -*-. -41 mm 41 mm…

A: Given data  Radius of semicircle (R) = 25 mm  Heigth of triangle (h) = 66 mm  Base width of triangle…

Q: Use the graphical method to construct the shear-force and bending-moment diagrams for the beam…

A:

Q: 1. Determine the magnitude of the vector sum V = V₁ + V₂ and the angle x which V makes with the…

A: Given Data: The data is given as: a=3b=5V1=11 unitsV2=15 unitsθ=50°   To Determine: The magnitude of…

Q: ter 6) A pump impeller is 37.5 cm in diamete and discharges water with velocity components of 2 m/s…

A: Given Data The pump impeller diameter (d1) = 37.5 cm The velocity in radial direction (V1) = 2 m/sec…

Q: What type of bridge is this? Why is it called the type that it is? Explain how this bridge works. G

A: We have to show To Bridge picture and asked which type of bridge and how its work.

Q: Question 1 Prepare a set of profile leveling notes for the survey in the following figure. In…

A: Leveling The process of figuring out the relative heights or elevations of points or objects on the…

Q: A hydraulic jump is formed in a 5.0 meter wide rectangular outlet downstream of a control (sluice)…

A: Given :

Q: 6. For a given soil, density = 2180 kg/m3 and n = 0.3. Determine: a. Void ratio b. Specific gravity…

A: The given data is shown below: Density=2180 kg/m3n=0.3

Q: well has a diameter of 10 cm. Under steady state condition, what is the expected discharge (lps) if…

A: According to given data  The average discharge  in Lps  is 7.01LPS (Liter per second)

Q: What are the difficulties faced by residents in high rise buildings such as apartments, condominium,…

A: High-rise buildings are nothing but tall buildings that use elevators and escalators to reach the…

Q: Kinematic viscosity' is dimensionally represented as M (a) LT (c) M L'T 20 27 (b) T (d) to

A: given- kinematic viscosity-v=μρμ=dynamic viscosityρ=density

Q: What are the difficulties faced by residents in high rise buildings such as apartments, condominium,…

A: High-rise buildings are nothing but tall buildings which make use of elevators and escalators to…

Issues During Construction

Construction is the combination of art, science, and engineering to build buildings, bridges, structures, roadways, highways. airports, etc. The construction business is a challenging and promising business worldwide with certain risk factors involved. Increasing demand for mankind leads to the growth of several construction companies which specialize in different construction projects. These construction companies initiate their construction process under certain agreements and time durations called the construction contract.