What process does this following sample have gone through? I. none II. quenching III. annealing IV. cold rolling

The beam in the figure below is subjected to a load P= 3.9 kN at its end. Young's modulus is 210 GPa and the moment of inertia for the beam's cross-section is 5×106 mm4. P If a = 1.5 m and b= 1.3 m, determine: A F a B |-x₂ b Tuc

The answer is one of the options below please solve carefully and circle the correct option Please write clear .

Finish the Orthographic drawing

can you write step clearly

i) The displacement at point A. Enter your answer in mm to 2 decimal places.

A hole is to be drilled as shown by the circle. Using the part geometry shown below, indicate on the part sketch where locator(s) should be positioned according to the 3-2-1 principle. Use dashed lines to indicate locators on hidden surfaces. Also indicate where clamping force(s) should be applied using arrows. Use the minimum number of clamping forces.

MULTIPLE CHOICE -The answer is one of the options below please solve carefully and circle the correct option Please write clear .

Pls answer correctly and corresponding to what is given in the image attached. The instructions are already in the image. Thank you