What percentage of the initial energy stored in the inductor is eventually dissipated in the 40 resistor? Express your answer as a percentage using three significant figures.

Q: +1 9V R1 ZENER R R2 3k

A:

Q: find voltage of network

A:

Q: Q3. A logic gate circuit is designed as follows, where R₁=5.9 k 2 and R₂=4 k 2, Vcc=14 V, A is input…

A: R1 = 5.9 kΩR2 = 4 kΩAnd  Vcc = 14 V

Q: a) As depicted in the figure, input voltage is 120 Volts (RMS) and diode drops are 0.7 Volts. Design…

A: According to the question,  (a) As depicted in the figure, input voltage is 120 Volts (RMS) and…

Q: What is the node voltage, v4? (In Volts) Note that v0 is grounded. Answer in Volts v1 v1 v1 R1, 16…

A:

Q: Calculate.Vo.( Need handwritten solution please otherwise downvote).

A: For the given differential amplifier circuit the output voltage Vo needs.to be calculated.

Q: parabolic dish antenna has efficiency 85% and aperture area 3m². At a frequency of 12.85 GHz, what…

A:

Q: Determine the zero-state response of the following system, if the input is; f(t) = e-4t.u(t) H(s) =…

A: In this question we need to find the zero state response for the given input

Q: which of the following devices is used with a wattmeter to measure reactive power   A.…

A: Using a wattmeter to measure reactive power of the system. Wattmeter is a device which measures the…

Q: K nces Required information NOTE: This is a multi-part question. Once an answer is submitted, you…

A:

Q: Q 5:A 50 HZ 4 pole turbo generator rated at 20 MVA, 13.2 KV has an inetia constant of 9 KJ/MVA A.…

A: In this question we need to find the following Kinetic energy stored in rotor at synchronous speed…

Q: b) [Research Question] Design a DC battery charger for an electrical vehicle which has a 96 V…

A: As per the guidelines of Bartleby we suppose to answer first three subpart only for solution of…

Q: Using the Nyquist stability criterion, determine the closed-loop system with unity feedback…

A: The given open-loop transfer functions are,a. Hs=2s+1.b. Hs=2s-1.c. Hs=1s-2.

Q: find current I1 and I2

A: Current I1 and I2

Q: 3. The error in a unity feedback system is the error e(t) = x(t) − y(t) where x is the input and y…

A:

Q: 2) Calculate output voltage value of this circuit. ( 9V 1k 3k 2k 4k 2k 8k Vout

A:

Q: transformer

A:

Q: A series DC motor has a series-field winding of 25 turns per pole. Its armature resistance is 0.10.…

A:

Q: As given in the figure a clamper circuit with the input signal Vi is proposed to design. Determine…

A: According to the question, we need to plot output waveform for the for the proposed clamper circuit…

Q: We want to investigate how the field strength will be with air as dielectric and with steatite. A…

A: Parallel plate capacitor, Line voltage, VL=24 kV. Area of parallel plate A=1 m2. Distance between…

Q: A transformer has a primary voltage of 240 V and a secondary voltage of 48 V. What is the turns…

A: Turn ratio of transformer

Q: An inductor and resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a…

A: E=120Vf=60HzR=50ΩL=0.2H

Q: Where does the -32.771 degrees angle come from in Step 2? I tried to do arctan(b/a), but is that not…

A: here we have to clarify the given solution.

Q: A three-phase line has its conductors at the corners of an equilateral triangle of side 1 m. The…

A:

Q: Example 1 Amplitude of carrier signal is given 10 V, and free 20MUC This carrier is modulated by 16…

A: Given: Carrier signal has, amplitude Ac=10 V and frequency fc=20 MHz.  Carrier signal is modulated…

Q: An R-L parallel circuit is connected to 240 volts at 60 Hz. The resistor has a resistance of 68 52,…

A: Given data:ET=240Vf=60HzR=68ΩXL=48Ω

Q: For the system of resistors shown in the figure below, find the electrical bill (or cost) that you…

A:

Q: Find the Z-transform for: f(k) = 1/a (1- e ^(−2ak)) u(k) -

A:

Q: Find the voltage across the capacitor as a function of time for t> 0 for the given circuit. Assume…

A: Given: with the assumption that the circuit is in steady state for t<0 and Vi = 55 V.  To find:…

Q: Determine the values of Ta, T, Tp, T, when the control system shown in Figure 10-28 is subject to a…

A:

Q: A 30392/524 volts, 51.5 hr, 239.992 KVA step-up transformer is connected to a source having a line…

A: A 30392/524 volts 51.5 Hz 239.992 KVA  transformer

Q: A 13320/370 volts, 62 hz, 160.95 KVA step-up transformer is connected to a source having a line…

A: In this question we need to find the output frequency of transformer

Q: a. Determine the branch currents of each of the given circuit below. -SV ID ww 本 Si ' 10 Ω ' 2.2 ΚΩ…

A: In this questions,  We need to determine the current in the diodes and resistance. Voltage Vo as…

Q: 1. A certain conductor has a resistance of 0.5 ohm. Calculate the conductance of the conductor of…

A: In this question,  We need to determine the conductance of the conductor.  Conductance = 1/R

Q: The angle between rotor teeth of permanent magnet stepper motor is 1.8° and there are five stator…

A: The angle between the rotor teeth of the permanent magnet stepper motor is 1.8°.  The number of…

Q: A full bridge inverter with RLC load having the following values: R-7.5 Ohms. L=12.5 mH, C-22 uF.…

A: In this question we need to find average and RMS current of each transistor

Q: Given Zc-j309 , R₁ = 390 , RL = 6401 2 and a = 0.39, what is the magnitude of the source voltage Vs…

A:

Q: For the circuits in Fig. P6.61, find values for the labeled node voltages and Branch currents.…

A: Here , fig a is npn transistor and fig b pnp transistor we need to find the branch currents and node…

Q: The voltage and current at the terminals of the circuit element in the figure are zero for t 0 they…

A: Circuit is, Voltage and currents are zero for t<0. For t≥0, v=60−60e−1000t V,i=65e−1000t mA

Q: The circuit parameters in the circuit in (Figure 1) are R = 500 M, L = 250 mH, C = 250 nF, and Idc =…

A: In this question we need to find the current io(t) for t>0

Q: 1. Briefly discuss the difference between Piecewise-linear model, Simplified model, and Ideal…

A: Step-1-> Ans(1)-> The piecewise-linear model is a mathematical model that divides the…

Q: 2002 1₁ 10Ω 1002 100V 2002 10Ω 50V 11 = 7A Apply Mesh Current Method to calculate the current, in…

A:

Q: a) A given PM signal is: PM (t) = 10 cos [90×10° πt+200 cos 2000 t] Determine the carrier frequency…

A:

Q: Thank you that helped a lot but In which part of the drawn circuit are inputs??

A: Given sequence is an irregular counter sequence . In the given sequential circuit for the given…

Q: Use the node-voltage method to find the voltage v.. + 160 V 2Ω ww + + V§24 Ω 3 Ω m ix 3 Ω

A:

Q: 30) Given circuit below: e = 7.07 sin ut E = 5V 20° ZT Ⓒ I + VR R www 1 ΚΩ L 20 mH VL a) Find…

A:

Q: 3v 5 ΚΩ ww 6 VI 2 ΚΩ να Bika Ε΄ 20 ΚΩ 10 ΚΩ vo

A:

Q: 15. Consider this circuit. (a) Which of the following is true? A) IA=IB + IC B) IB = IA + Ic C) Ic =…

A:

Q: If a magnetizing force H of 600 At/m established. Find the permeability magnetizing force. is…

A: In this question,  We need to determine the permeability of the material.  If flux density B=…

Q: Is it less expensive to operate the electric heating unit in Question 12 on 240 V or 120 V?

A: It is less  expensive to operate the electric heating unit in question 12 on 240V Or 120V?

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.