What logic function is being performed? Logic function:
Q: A current of 3 A flows for 5 minutes. What charge is transferred?
A:
Q: The reactance of the Impedance Z=1 O 100 Ohms 48.48 Ohms 87.46 Ohms 1.64 Ohms
A:
Q: 7.27. A linear time-invariant discrete-time system has transfer function 3z H(z) = (z+0.5)(z- 0.5)…
A: Given:- transfer function Hz=3zz+0.5z-0.5 Output response, yn=0.5n-3-0.5n+4un We have to find…
Q: Calculate the power gain in decibels for a power amplifier that has an output of 360 W and an input…
A: Given data, Output is given Pout=360 W Input is given Pin=40 W
Q: Problem 9: Find the Thevenin equivalent circuit for the following circuit with respect to the…
A: Solution !!
Q: 2- Using the nodal analysis to find V₂ for the network. 3LER, ISA RIZER. Iz 2A R3 452 R₂&n 4A + V₂
A:
Q: 15 A current? What is the radiation resistance of an antenna which radiates 5 kW when it draw
A: Given information: The power radiated by the antenna is P=5 kW. The current drawn by the antenna is…
Q: 11- A conductor with a positive Q (charge) of 4 C has a 2.56 X 10^18 electrons added to it. It will…
A: Given data, Total charge Q =4 C Number of electron n=2.56×1018
Q: 1. For the network of Fig., determine: (a) S(co) {b) S(Var) (c) S(B) Using T, as the temperature at…
A: Solution !!
Q: Consider the circuit shown in Figure 1. The capacitors have the same plate area. The capacitance of…
A: We are authorized to answer one question at a time, since you have not mentioned which question you…
Q: If the peak voltage of a 60-Hz AC generator is 250 V, what is the instantaneous voltage after the…
A:
Q: 2. Relation between currents according to KCL is 12 i1 i5
A: .
Q: The band of interest for a DSP system extends from 0 to 2 KHz. The achievable…
A: PART(a) GIVEN=> SQNR = 86 db Signal frequency (fm =…
Q: A three-phase induction motor with 72 stator windings is excited with a 50 Hz AC voltage source. The…
A: Given: A 3-phase induction motor has 72 stator windings. Excitation frequency, f=50 Hz Slip,…
Q: Que 2.23. What should be the value of R, so the maximum po can be transferred from the source to R,…
A: Solution !!
Q: The circuit shown below on the left has the following parameters: Is=27 mA R, = 2.2 ΚΩ R2 = 15 ΚΩ…
A:
Q: Calculate the average power supplied by the source as shown below. * find the averaged power…
A: Given parameters: The series-parallel circuit consisting of R, L, and C components s shown below,…
Q: image480
A:
Q: State and explain Carson's Bandwidth Frmula. Need urgently help. |
A:
Q: 2. For a given transfer function G(s) = a) Find the natural frequency b) Find the damping ratio. c)…
A: Given, Transfer function G(s) = 25s2+12s+25 ωn=?ξ =? ωd=?
Q: A variable speed drive is reversing under no load. Figure shows the reversing torque and the speed…
A: We have an variable speed drive and reversing under no load with , Given data from figure, Speed…
Q: 43. ★★ To reduce the 120. V AC voltage to 12.0 V AC to operate a standard doorbell, a step-down…
A: Given that: Stepdown transformer Primary voltage, VP=120 V Secondary voltage, VS=12 V Primary…
Q: The period of the voltage 2 cos 4500πt + 7 sin 7500πt is
A:
Q: In K-map, you might find some cells filled with the letter d (or X). This d is called "Don't care"…
A: The given k-map table is as shown below,
Q: ii) Just show induced current directions on figure 5 by using Lenz's law. Current I is constant and…
A: Note: We are authorized to answer one question at a time, since you have not mentioned which…
Q: Find the applied voltage on a forward biased diode if the current is 1mA and reverse saturation…
A:
Q: 2.b. Find the indicated unknown currents in the circuits shown below. 3 A 2A 14 A
A: Kirchhoff's current law- According to KCL at a node summation of incoming current is equals to…
Q: Two resistors R1=1000 Ohm and R2= 500 Ohm are connected in parallel. The total current is 10 A. The…
A:
Q: State and explain Carson's Bandwidth Frmula. Need urgently help.
A: Carson's bandwidth formula has been explained in the following section.
Q: The voltage eo in Fig. is 12V 452 www. 402 eo 4Ω 292 ww MM. 292
A: Given data,
Q: Determine the gradient of V = e(2x+3y) cos5z, at point (0.1, -0.2, 0.4) ax az ay
A:
Q: A moving coil instrument with a coil resistance of 25 ohm has a full scale deflection current of 2…
A: We have an moving coil instrument with, Coil resistance (r) = 25 Ω Full scale deflection current (i)…
Q: What is the natural frequency of the system with the following transfer function? a) On = 2 b) @₁ =…
A: Given system with the transfer function, XsFs=322s2+4s+32
Q: Using Parseval's theorem,
A:
Q: Design a unity gain inverting summing amplifier that will output the sum of two input voltages. Use…
A:
Q: 2. The power of a circuit is giving as follow: p(t) = 150e(-10t) Calculate the total energy of the…
A: Given data, Signal is given as, pt=15e-10t
Q: Section 3.7 39. For the circuit shown in Figure 3.61, determine the total circuit current. 10 V Rs…
A: Given data, Circuit diagram is given as,
Q: Compare but do not explain once again compare and do not explain between detection methods used in…
A: Frequency Modulation is a process through which a signal can be transmitted wirelessly over long…
Q: Q\ Compare but do not explain once again compare and do not explain between detection methods used…
A:
Q: 500 V 470 Ω www 470 Ω Figure 5-9 : 470 Ω The total current flowing in the circuit in Figure 5-9 is:
A: Given circuit, Source voltage, Vs=1500 V
Q: 29. Determine Zx in the circuit shown below. * + I= 31.5 (24° A V-50/60v 1+j10 2+j20 3+j30 O 4+ j40…
A:
Q: tír(t), t≥0.
A: At the time t<0, capacitor was connected with the 10V voltage source as shown in figure it this…
Q: The voltage across a 81 mF capacitor is 15.4 V. How much energy is stored in the capacitor in W?…
A: Given: Capacitance, C=81 mF Voltage across capacitor, V=15.4 V
Q: Q.11: For the coupled circuit shown 1. Compute the complex value of 20 J12 me 0.75 currents i & iz…
A: The given circuit diagram is shown below:
Q: a. Explain what is loading effect in measurement.
A: We are authorized to answer one question at a time, since you have not mentioned which question you…
Q: Q.4: Use the mesh analysis on a circuit at Figure 1 to find: a- Currents on resistors R1, R2, and…
A: The required parameters can be calculated by using the mesh analysis and by using the ohms law. The…
Q: An IDMT type over-current relay is used to protect a feeder through 5000/1 ACT. The relay has a PS…
A: We got an over current relay of IDMT type. CT ratio = 5000/1 Current Setting = 125 % Time Setting…
Q: (i) (ii) XAM (t) = Ac cos (wet + c) + m(t) cos (wet + c), m(t) = - Am cos (wmt). Determine the value…
A: Given:
Q: An alternator is connected in star. Its phase voltage is 250 V. This alternator supplies the load…
A:
Q: The open circuit and short circuit data of a three-phase, 3300 V, 500 kVA, star connected alternator…
A:
![NOTCH
+5V
14
SW1
L1
LED
13
[D]
12
2
Logic function:
3
TOP VIEW
2
11
4
1/4-7400
||
10
3
9
N
22²2
5
HA
6
8
LED
7
GND
I
What logic function is being performed?](/v2/_next/image?url=https%3A%2F%2Fcontent.bartleby.com%2Fqna-images%2Fquestion%2F99a6e6d3-da0f-49c9-8619-426b7d37648f%2F06c17417-0ef6-41be-8381-4bba0e849910%2Fz69pjqe_processed.png&w=3840&q=75)
Step by step
Solved in 4 steps with 3 images
- (c) Figure Q3(c)(i) shows a register and Figure Q3(c)(ii) shows the input waveforms (CLOCK and Data in) to the circuit. A1 A9 A10 A2 Function generator A3 A11 A12 AS A13 A6 A14 A7 A15 Data in Bop.7) ip.r 82p.7) Logic analyser U1 U2 U3 U4 UO 6. 1. 6 1 6 INVERTER 3 CLK 3 CLK oCLK CLK 5 K K 5 K K 4027 Clock Function generator Figure Q3(c)(i) (i) Determine the type of register as shown in Figure Q3(c)(i).The numbers from 0-9 and a no characters is the Basic 1 digit seven segment display * .can show False True In a (CA) method of 7 segments, the anodes of all the LED segments are * "connected to the logic "O False True Some times may run out of pins on your Arduino board and need to not extend it * .with shift registers True FalseElectrical Engineering Draw 2, 1 bit ALUS to create a basic 2 bit ALU. the carry out and carry in bits must ripple across. The ALU should subtract/add, logical NOR, logical AND, and logical OR. Draw out the adding logic circuit
- Q3) A - Convert the Excess-3 to binary number : ( 110001011100.10001010)ex-3 B- convert each Gray code to binary: 1-( 011010001001)G 2-(59)DConvert the following numbers: 10101010 binary to hexadecimal Hexadecimal number BEAD to decimal Decimal number 129 to binary. Decimal 47802 to hexadecimal.I was able to fill out the truth table for part A. I ONLY need help for PART B. B) Implement the logic function (z) using the multiplexer 74HC151 shows in the picture.
- Build a truth table and draw the output wave form for the following logic gates shown in Figure Q2. A o B Co Do E o D D Figure Q2 Zd) Draw the schematics of 4-bit synchronous and asynchronous MOD-8 counters and comment on their pros and cons. e) Calculate the noise margin for a logic gate with the following logic levels: VIL = 1.1 V, VIH = 3.2 V, VOL = 0.6 V, VOH = 4.0 V.ehcu.org/pluginfile 100% 10 / 11 locations, count how many times is 0 and how many times 1 is. Questions:- 1- Write a program in assembly language to perform the following logic ci BL CL DL [5100]- 2- How we can perform the NEG and NOT instructions by using different instructions. 3- Write the following program by using different instruction or instructions for each instruction on the program. MOV AL , 00 MOV BX , FFFF XOR CL , FF NEG BYTE PTR [DI] AND CX , LG
- 21. (a) By referring to Figure Q1(a), derive a logic (Boolean) expression for the given circuit. If the input abcd-1011, m=1, and re-Q, what is the value of output at /? MHEU Figure Q1(a)Determine the truth table for the following logic circuit. Then identify the type of logic gate using Boolean algebra. O +Vcc R23 ER O O/P Q1 Q2 BOWhat are the two primary categories of output circuits in TTL?