e=11You are logged in as Gavin RitchWhat load or resistance on a circuit would pull a current of 7.4 A when connected to a voltage source of 1.0 V?Answer:CheckNext pageDELL D&page=12You are logged in asWhat is the voltage needed to run a 9.2 ohm toaster on 5.5 amps?Answer:CheckpageFinishDELL

Answered: Image /qna-images/answer/ed38b41e-ad10-4734-b73e-3e18e4872e37.jpg

Answered: What load or resistance on a circuit…

What load or resistance on a circuit would pull a current of 7.4 A when connected to a voltage source of 1.0 V? Answer: Check

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: Resistors of 10, 15 and 5 ohms are all connected in SERIES to a 90 V source of potential difference.…

A: Given that-Resistance, R1= 10ΩResistance, R2= 15ΩResistance, R3= 5ΩWhen resistors are connected in…

Q: What is the current in a circuit with a 2Ù resistor followed by a 3Ù resistor that are both in…

Q: ThOsistance of a voltmeter is 1000. It is connected to a battery of e.m.f 8 V and internal…

A: Given Emf = 8 V Internal resistance =r = 20 ohm Resistance =R = 100 ohm Voltmeter reading ,V =??…

Q: In the circuit shown, the battery voltage, V 15V and the load resistance, R = 452. %3D V A R V The…

A: Given data: Battery voltage (V) = 15 V Load resistance (R) = 45 Ω

Q: How much current flows thru a 6 Ω resistor in 4 minutes if it is connected to a 9V battery ?

A: Given : R = 6 Ω t = 4 minutes = 4 x 60 = 240 seconds V = 9 V

Q: In a 240 V circuit, how many 65 W light bulbs can you connect in parallel without tripping a 10-A…

Q: circuit is connected to a 12V battery and every resistor has a resistance of 200 W. what's the total…

A: Given, voltage of battery, V=12V .............(1) Resistance of each resistor,R=200…

Q: In an automobile, the system voltage varies from about12 V when the car is off to about 13.8 V when…

A: The power delivered to load be defined as, P=V2R

Q: The RC charging circuit in a camera flash unit has a voltage source of 295 V and a capacitance of…

A: The voltage source is V=295 V. The capacitance is C=126μF=126×10-6 F

Q: The resistance of an electric heater is 70 Ω when connected to 120 V. How much energy does it use…

Q: You are analyzing a circuit with an unknown resistance connected across a battery of unknown…

Q: A 1520-W hair dryer plugs into a 120-V outlet. What is the current through the hair dryer when it…

A: Power of hair dryer (P) = 1520 W Voltage (V) = 120 volts

Q: The emf of a particular battery is 45V and the internal resistance is r=7Ω. When attached to load…

A: a) The required terminal voltage is,

Q: Q3(a) Design an electrical circuit with 3 resistors out of which 2 resistors must be connected in…

Q: When a 20.8-Ω resistor is connected across a 15.6-V battery, a current of 500 mA flows. What is the…

Q: A 16.27 Q resistor is connected to a battery that has an internal resistance of 0.76 Q. If the…

A: Given that,Resistor : R = 16.27 (Ohm)Internal resistance : r = 0.76 (Ohm)The terminal voltage : ∆V =…

Q: How long does it take the charge to reach 63% of its final value if a 10 microfarad capacitor is…

Q: The storage battery of a car has an emf of 12 V. If the internal resistance of the battery is 0.492,…

A: Given that - EMF of the battery Internal Resistance of the battery To Find - We have to determine…

Q: Consider a 12.0 V motorcycle battery with an internal resistance of 0.53 Ω. (a) Find the terminal…

A: The objective of this question is to find the terminal voltage of the battery when it is being…

Q: In measuring a voltage, a voltmeter uses some current from the circuit. Consequently, the voltage…

Q: A circuit contains a 10.0 ohm resistor, a 12.0 ohm resistor, and a 6.0 ohm resistor. If they're…

Q: Two resistors are connected in parallel to produce an equivalent resistance of 171 Ohms. If R1 =…

A: The resistors are connected parallel to each other hence the equivalent resistance is,…

Q: Two appliances are connected in parallel to a 120-V battery and draw currents I₁ = 2.0 A and I₂ =…

A: I1 = 2 A I2 = 3.5 A Vbattery = 120 volts

Q: Consider the terminal voltage of a 3.00 V lithium cell in a digital wristwatch that draws 16 mA.…

A: The objective of this question is to find the terminal voltage of a lithium cell in a digital…

Q: A 9 ohm resistor and a 16 ohm resistor are connected in series in a circuit with a 5.0 volt battery.…

A: Given , R1=90 ohmR2=16 ohmThese are connected in series , voltage V=5V

Q: Consider the terminal voltage of a 3.00 V lithium cell in a digital wristwatch that draws 29 mA.…

A: given: V=3.0 V Ii=29 mA = 29*10-3 ARi=1.8 Ω

Q: When two identical resistors are connected in series to a 100 V voltage source, the current is…

Q: THREE RESISTORS OF SAME VALUE ARE CONNECTED IN SERIES TO A 12-V SOURCE. WHAT IS THEIR COMMON OHMIC…

Q: A battery delivering a current of 55.0 A to a circuit has a terminal voltage of 23.9 V. The electric…

Q: A 16.27 Q resistor is connected to a battery that has an internal resistance of 0.76 Q. If the…

A: Given that,Resistance : R = 16.27 (Ohm)Internal resistance : r = 0.76 (Ohm)Terminal voltage : ∆V =…

Q: 3. Two resistors a and b are connected in parallel. The total resistance R in such a circuit is…

Q: of 5 > Two 1.5 V batteries are connected in series with a 165.4 Ohm resistor. What is the current in…

A: There are two batteries connected in series.R = 165.4 ohm

Q: A battery has an emf of 9.09V and an internal resistance of 1.0822. What resistance connected across…

A: Given:emf of the battery, E = 9.09 Vinternal resistance, r = 1.08 Ωpower dissipated by external…

Q: When a battery is connected to a load with a resistance of 40.0 Ω, the terminal voltage is 24.0 V.…

A: Let battery is having emf E and internal resistance r . Circuit -1 -When battery is connected to a…

Q: The open-circuit voltage of a storage cell is 2.4 volts. The terminal voltage, measured when the…

Q: The current flow through a resistor is 0.150 A when 4.0 V is applied. What voltage is needed for…

A: Formula of ohm's law is as follows: V=IR…

Q: What is the voltage between the ends of the 4Q resistor in the circuit shown in the figure? Note:…

Q: Two identical resistors of 276 Ohms are configured in parallel and connected to a 13.3V power…

A: Given that,The resistance of a resistor : R=276 Ohm The voltage difference between the terminals…

Q: An ammeter whose internal resistance is 57 Ω reads 4.75 mA when connected in a circuit containing a…

Q: A 30-ohm resistor and a 60-ohm resistor are connected as shown above to a battery of Voltage of 20…

A: Given that, 30 ohms and 60 ohms are connected in parallel. The voltage of the battery = 20 V The…

Q: A battery with voltage V is connected to an Ohmic resistor resulting in a current of I flowing in…

A: Given Current in the resistor is I and voltage of the battery is V

Concept explainers

Ohm's law

Ohm’s law is a prominent concept in physics and electronics. It gives the relation between the current and the voltage. It is used to analyze and construct electrical circuits. Ohm's law states that the voltage across a conductor is directly proportional to the current flowing through it.

Path of Least Resistance

In a series of alternate pathways, the direction of least resistance is the actual or metaphorical route that offers the least resistance to forwarding motion by a given individual or body.

Question

e=11
You are logged in as Gavin Ritch
What load or resistance on a circuit would pull a current of 7.4 A when connected to a voltage source of 1.0 V?
Answer:
Check
Next page
DELL

D&page=12
You are logged in as
What is the voltage needed to run a 9.2 ohm toaster on 5.5 amps?
Answer:
Check
page
Finish
DELL

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A flash unit for a camera has a capacitance of 1300 µF. What resistance is needed in this RC circuit if the flash is to charge to 90% of its full charge in 22 s ?
Thank you
= Four resistors are connected to a battery with a terminal voltage of 12 V, as shown in the figure below. (Assume R₁ R₁ ww ww 20.0 Ω www R₂ 50.0 Ω ww + 12 V (a) How would you reduce the circuit to an equivalent single resistor connected to the battery? Use this procedure to find the equivalent resistance of the circuit. 0.21 Ω (b) Find the current delivered by the battery to this equivalent resistance. 0.19 XA (c) Determine the power delivered by the battery. 2.52 X W 31.0 and R₂ 84.0 Ω.) (d) Determine the power delivered to the 50.0- resistor. W
Some light bulbs are connected in parallel to a 120 V source. Each bulb dissipates an average power of 60 W. The circuit has a fuse F that burns out when the current in the circuit exceeds 9 A. Determine the largest number of bulbs, which can be used in this circuit without burning out the fuse.
A circuit you’re building needs a voltmeter that goes from 0 V to a full-scale reading of 5.0 V. Unfortunately, the only meter in the storeroom is an ammeter that goes from 0 μA to a full-scale reading of 500 μA. It is possible to use this meter to measure voltages by putting it in a measuring circuit as shown. What value of R must you use so that the meter will go to full scale when the potential difference ΔV is 5.0 V? Assume that the ammeter is ideal.
Four 2.2 V cells are connected in series to a 8.0 light bulb. If the resulting current is 0.75 A, what is the internal resistance (in Q) of each cell, assuming they are identical and neglecting the resistance of the wires?
The household circuit operating at 120 V has a 30 A circuit breaker. 1500 W iron, 2000 W fryer and light bulb work together. What should be the maximum power of the bulb so that the circuit breaker works?
25. Two copper balls, each weighing 10 g, are kept in air 10 cm apart. If one electron from every 106 atoms is transferred from one ball to the other, the coulomb force between them is (atomic weight of copper is 63.5) (a) 2.0x 10¹0 N (c) 2.0 × 108 N (b) 2.0 x 104 N (d) 2.0 × 106 N
A 1.00-MΩ voltmeter is placed in parallel with a 75.0-kΩ resistor in a circuit. What is the resistance of the combination?
A 2-V battery has 0.02 ohms internal resistance. It is attached to a 4 ohm resistor. What is the terminal voltage of the battery?
You have a battery of 960 V and four (4) resistors each with a resistance e of 40 Ohms. If you make a PARALLEL CIRCUIT with these components, what is the resistance of the circuit?
A certain medical device has a resistance of 2 kilo-Ohm and is rated for 20 Watts. What is the maximum voltage, in V, it can safely handle?