Answered: What is UPS in electrical engineering?

Engineering

Electrical Engineering

What is UPS in electrical engineering?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: What is the Importance of power electronics in engineering?

A: Electrical engineering's field of power electronics deals with the processing of high voltages and…

Q: Draw the equivalent circuit and briefly explained on the rectifier circuit operation. Find the…

Q: What is the condition to obtain the maximum efficiency of a Rectifier? Neglecting the value of total…

Q: Consider the following signal: s(t) = 20[cos (1000 pit)][cos(4000.pit)]. The value of fm for this…

A: Given signal, st=20 cos1000πtcos4000πt

Q: Can you get a DC signal from the Digital Multi-Meter? If not, why?

Q: What are microchips, and how do they differ from traditional integrated circuits? Provide examples…

A: Microchips, often referred to as microprocessors or simply chips, are a type of integrated circuit…

Q: electric arc furnace

Q: Describe the challenges and techniques for power management in microchips. How do low-power modes…

A: Power management in microchips is crucial for achieving energy efficiency, extending battery life,…

Q: Define slew rate with the formula and its unit.

A: Generally slew rate is calculated in analog electronics. Where it is defined as the rate of change…

Q: Ex. 2110. Refer to Figure 2110. Assume MKS units. Given: V4=15/_ 0.30, XL1=16, R2= 4, 15= 3/ 1.40,…

A: The solution is given below

Q: R 12 V 2Ω (a)

Q: What are the different integrated circuits? Describe their characteristics, advantages and…

A: When a set of electronic components mount on a small piece of semiconductor to perform some…

Q: Write the basic idea of a WECS

A: In this question we need to write the basic idea of WECS ( wind energy conversion system )

Q: B/ Answer the word true or false and the 1 The electrodynamic device is used to measure the…

Q: 3. What is the disadvantage of ripple voltage (Peak-Peak) in DC Supply on the electronic instruments…

A: Ripple voltage is an unwanted SC components in a electronic equipments workin on DC supply. This…

Q: xplain concisely and in your own words the procedure to be carried out for: Vacuum test and…

A: Vacuum test : Vacuum test is also known as non destructive examination which is used for locating…

Q: 2. A full wave rectifier is used to convert 400 Hz ac todc Design a full-wave rectifier power supply…

A: According to question: Full wave bridge type rectifier designed using 1:1 transformer and four ideal…

Q: Electric resistance seam welding uses . . electrodes. (a) pointed (b) disc (c) flat (d) domed

A: According to the question we have to find electric resistance seam welding.

Q: What is metastability.How it can be avoided. What is clock gating.

A: Meta stability in electronics is the ability of the digital electronics system to persist for an…

Q: Devices that pass the signal from its source to the measurement device without a physical connection…

A: Given, Devices that pass the signal from its source to the measurement device without a physical…

Q: What are Linear Voltage Regulators? Give an example.

A: A linear voltage regulator maintain the steady output. Here resistance of the regular varies…

Q: Explain the Commutation process in DC machines.

Q: a) Prove that the rms output voltage of a full wave single phase rect with resistive load Vrms =…

Q: (a) How one can alter the electrical conductivity of semiconductor material? Discuss it in detail.

A: According to guidelines I have solved only first subpart. (a)We need to know how one can alter the…

Q: 1. a) Explain the operation of Light Activated Thyristors. b) Why a 48-pulse rectifier needs a…

A: Note: As these subquestions are isolated from each other, we are allowed to answer only one…

Q: Is it Inverter is important in solar power system? Why?

A: Inverter is a device which converts the DC supply into AC supply. As we have the storage batteries…

Q: Q5. Explain Digital Abstraction with practical applications? If the applied voltage to DC motor is…

A: 5- In Digital abstraction the circuit is interpreted as a digital circuit giving output as the…

Q: y=A/B+/c

A: The given logic expression is Y=AB¯+C¯

Q: A 3 phase fully controlled rectifier has a 3 phase line to line supply voltage of 410 V rms at 50 Hz…

Q: Write the Shockley equation and define all of the terms.

A: The expression for the shockley equation is: iD=IsexpvDnVt-1 iD is diode current Is is saturation…

Q: Design a bridge rectifier circuit to provide an output of 100 VDC. Calculate the diodes PIV rating…

A: For full wave rectifier peak inverse voltage is Vm , peak value of secondary supply voltage. DC…

Q: pls ans soon

A: The sources which give electrical energy as output after processing called sources of electrical…

Q: Discuss the importance of power efficiency in microchip design. What techniques and technologies are…

A: To discuss:the importance of power efficiency in microchip design.Optimizing techniques microchips…

Q: Explain in detail DC and AC current.

A: Direct Current Definition: DC is a unidirectional flow of electric charge. Electrons move…

Q: What is meant by FACTS in power systems? Discuss about SVC type FACTS device

A: Power system A network that consists of generation, distribution, and transmission systems. It uses…

Q: 3.1. A three-phase bridge rectifier has a purely resistive load of R. The rectifier delivers Iac =…

A: The solution is given below

Q: What is voltage stability?

A: According to question, we need to explain the voltage stability.

Q: How does an electrical engineer practice management? Give examples of management being practice by…

A: Management is the one of the most important non technical aspect for an electrical engineering…

Q: What does a compatible load mean? What if the load is not compatible?

A: This question is from "Power system and protection". Under which we are going to study load…

Question

What is UPS in electrical engineering?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: concept

VIEW

Step 2: Definition

VIEW

Solution

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is a simulator? What are advantages of simulation in electrical power system? Which is the nearest generating station to Ibra? What is its output voltage?
a.it a Moore machine or Mealy? Why? b. Create the next-state table. Show your work. Label your columns. c. Question b's table and question c is attached from the picture below
Discuss the importance of power system protection and control.
a) Buses are the conductive channels found in the circuitry of a microprocessor. This means that there is potential for current to flow among the various parts. Expertly classify these buses according to their function and describe how they interact with microprocessors.b) In a microprocessor, what is the distinction between data and instructions?
Discuss the impact of power consumption in microchip design and how it relates to the efficiency of electronic devices.
Electrical Engineering _ Power Electronics Notes: pls try to answer in less than 30 min.
Select the best answer for the question. 4. Look at the drawing shown in the figure above. When you see this drawing in a schematic diagram, you should recognize that it represents a/an O A. step-up transformer. O B. inverter. C. bridge rectifier. OD. thermal relay.
What are some of the benefits and drawbacks of considering system engineering to be a distinct profession from electrical engineering and software engineering?
Explain with details with diagram. Related too ( Book: Electronic instrumentation and measurement ) (Topic:PMMC) Solve fast.
In a rectifier circuit , DC output voltage and RMS output voltage is 0.3 V & 0.49 V respectively. The form factor of this circuit is ___________________. a. 1.63 b. 3.27 c. 0.61 d. 1.17
I have an assignment of topic: construction of DC Machine I need to write theory discussion with some figures
Discuss the role of power electronics and applications? Draw a power electronic circuit interface between source and load?