What is the Thévenin equivalent source that drives the inductor in the given circuit? V1 is 3V @ two kHz without phase offset. Answer in ohms with two sig figs.

Q: Find the transfer function of the below mechanical system: Select one: O a. Ms? + K/ Bs O b. 1+ Ms?…

A: The solution is given below

Q: X1(s) Find the transfer function G(s) = F(s)

A: Open Loop System-A system having a input in the system which does not depends on the system output.…

Q: 3. Given the potential field, V = x²y + xy³ + xz², and a point P(-3, 0, 6). a) The potential field…

A: In this question we will find potential field value at given point , E and D ...Also volume charge…

Q: (1) Simplify the Boolean expression: ((B + C) + ĀD)(Ā+B) (C + D) (2) Draw the logic diagram…

A: CMOS: It is a semiconductor device that is a combination of the PMOS and NMOS circuits.

Q: Full the following blank (1110)Gray + (11010000)2- (11001101)Ex-3 = ( )16 %| O -17 O +11 O +69 O -14…

A: In this question,   We need to choose the correct options What is output of the given function?

Q: Draw the diagram of a SISO four-bit register. Assume that the content of the four-bit register is…

A:

Q: A 1500 square foot single-family, one-bath dwelling has a 12kW electric range and a 5.5 kW, 240volt…

A: Steps: Calculate Max VA for 1500 Square foot from the load calculation table Calculate load current…

Q: A fault current limiter as shown in the figure, has L1 = 1 mH and a total impedance of j10 Q. If the…

A: The given circuit is as shown below,

Q: In the figure the current in resistance 6 is ig = 1.38A and the resistances are R1 = R2 = R3 = 2.01…

A: In this question we will find battery emf E ...

Q: For the JFET amplifier circuit of Fig. 18-7, determine the lower- and higher-cutoff frequencies and…

A: The frequency response of the amplifier circuit can be obtained by using DC and AC analysis.

Q: a) Use Z-transform method to determine the output time sequence y(n) for the following impulse…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: What value of input resistance is needed in the given circuit to produce the given output voltage ?…

A:

Q: 45. A circuit has an impedance of (1-i 2) Q. The Susceptance of circuit is (i) 0.1 S (ii) 0.2 S (ii)…

A:

Q: オーズ 0<x<T (-1)"-1 sin nx 12) f(x) =- COs nx + 4 0<x<T (-1)"-1 13) f(x) =- 27-x COS nX R<x< 27

A:

Q: A 15 mH inductor is in series with a parallel combination of 80 ohm resistor and 20 microFarad…

A: This question belongs to circuit theory . It is based on the concept of relation between impedance…

Q: Time of charge and discharge in Capacitor represented by t = CR, therefore, what is the…

A: Time of charge and discharge in capacitor represented by t=CR, therefore, what is the corresponding…

Q: Full the following blank (1110)Gray + (11010000)2- (11001101)Ex-3 = ( )16 -17 -14 +69 +11 None of…

A: In this question,   We need to determine the following output in hexadecimal

Q: CP4.8 A negative feedback control system is depicted in Figure CP4.8. Suppose that our design…

A: Given, aGcs=k=2Open loop gain=10×2s+10=20s+10Closed loop gain=Gs1+Gs=20s+101+20s+10…

Q: In the series resonant circuit the minimum magnitude resonance impedance Z(n)min= Select one: O a.…

A: At resonance, the circuit behaves as purely resistive. The impedance in series RLC circuit is given…

Q: (a) Give three reasons why power protection is important. (b) Name three types of disturbances seen.

A:

Q: This waveform, is the current in Half- bridge With Purely capacitor Load .circuit lo T/2 lo True O…

A: To convert the DC input supply into AC, inverters are used.  The inverter can be single-phase or…

Q: Find the mechanical power output of the 185W, 110V, 60 Hz, single-phase induction motor whose…

A: It is given that:Xm=53.5Ω xm=Xm2=53.52=26.7Ωr2=R22=3.562=1.78Ω x2=X22=2.562=1.28Ωlet s=0.05

Q: USE 2 decimal places, no commas. Given: Voltage-divider biased, npn BJT with 1. VCC = 17V 2. R1 =…

A:

Q: (k) Determine the economical cross-sectional for a single phase transmission line, 1 km transmission…

A: For the 3 phase transmission line of 1 km and a voltage of 110 kV. Thus, the load cycle is, 6 hr 20…

Q: HiWO: Find the B function, freguerey of oscillation anl E or osaillation for the circait shown belo?…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 1) Estimate the shape of magnitude response of H(z). Take b=0.5. 2) What is the type of system…

A: Hz=1-b1+bZ-1, b=0.5given, Hz=0.51+0.5Z-11Hejω=1-0.51+0.5ejω=0.51+0.5ejω…

Q: Given the following MUX, what is the boolean expression of F?

A:

Q: rotational system, an inertia "J" is subjected to a given torque T(t).. find its transfer function…

A: We need to select correct option for given system

Q: HW2: Given the following system: y(n) =D 등y(n-1)-증y(n-2) + x(n) %3D | | 1) Determine the response of…

A: We need to find response for given system

Q: HW4C2 4. Using superposition. find the sinusoidal expression for the voltage ve for the network of…

A: To solve this question we use superposition principal.

Q: Question: Assume a system comprises 16 GB physical memory with B KB page/frame sie and the…

A: Virtual memory is a volatile memory . it store the temporary data . virtual memory used both the…

Q: • Part B R=42 k0. L- 330 mH. C= 31 aF, and e, - 19cos 8000L V in the circuit shown for t in seconds…

A: In this question we need to find a maximum power transfer to load

Q: (d) A non-liner load is connected to a 110 V, 50 Hz power supply. Determine whether the current of…

A: It is given that: V=110Vf=50Hzharmonic=3rd

Q: atts. a. I*2R(read I squared R) b. Elcosθ c. both a and b d. conjugate method   3. The product…

A: Through these questions the basic understanding of apparent power, real power and reactive power is…

Q: mechanical power output

A: Three Phase Induction machine- This Induction machine comprises of rotor and stator as it basic…

Q: Figure 19.5 R1 60.0 Q R2 90.0 O 1.0 V 9.0 V

A:

Q: etermine Ip&VDs of the circuit using transfer characteristic Ipss = 9mA 2.2kn Vp = -4.5V Self 1.8MN…

A:

Q: S3 S2 S1 SO 01 02 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1…

A: We need to find circuit of given truth table

Q: (a) Spectrometer uses a fiber optic cable to connect the lens and spectrometer (see figure below).…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: 1. A silicon p-n junction (Na = 106 cm and Na 4 x 106 em') is biased with Va = -3 V. Calculate the…

A:

Q: Ex. 22 : A conductor of length 0.3 m moves with uniform velocity of 10 m/s at right angles to a…

A:

Q: Consider the design of a T-network that transforms a 50 2 load impedance to 10 2. Suppose that the…

A: The given circuit is as shown below,

Q: + VCE L= 0.98 Pnp trancist 2-5 KA YBE =0.7Y 2V 18 Deter mine: a) IB, Ici JE b) VRE , VRC , vCE

A: PNP transistor: This is a transistor in which in the n-layer two p-layer material are doped and in…

Q: 10. Consider in Figure 6.43 the design of a T-network that transforms a 50 2 load impedance to 5 N:…

A: The circuit is as shown below,

Q: The switch in the circuit shown in the figure is its initial position for a very long time before it…

A: We need to analyse the given circuit

Q: iv) The equivalent capacitance, Ceq, for this circuti is: (a) 10 µF (b) 110 µF (c) 40 µF (d) 3.4 µF…

A: Given,

Q: +15V The transistor in the circuit has a B of 100 and exhibits a VBE of 0.7V at i = 2mA. Design the…

A: We need to find out the value of Rc and RE for given circuit

Q: Draw the bode plot for the given transfer function

A: Given Transfer function H(s)=10(3+s)s(s+2)(s2+s+2) We rewrite it by factoring into real poles &amp;…

Q: Home Work 15: A 3-phase, 6600 V, star-connected, synchronous motor draws a full-load current of 70 A…

A:

Q: What value of input resistance is needed in the given circuit to produce the given output voltage ?…

A:

Thevenin Theorem

Any linear circuit, no matter how complex, maybe simplified to an equivalent circuit utilizing only a single voltage source and series resistance coupled to a load, according to Thevenin's Theorem. The superposition principle says that all foundational equations must be linear, and the notion of "linear" is still the same (i.e., there should not be any exponentials or roots). This is particularly the case when operating with passive elements like resistors, inductors, and capacitors. However, some components (particularly some gaseous and semiconductor devices like tunnel diode, Schottky diode, transistors like BJT, MOSFET) are nonlinear, meaning their current resistance fluctuates with voltage and current. As a result, circuits made up of these parts are known as nonlinear circuits.