What is the purpose of installing a bell to a residential building?

Q: In what way is the fault study helpful to analyze faults on a power system?

A: The explanation is as follows.

Q: Explain, with the aid of a sketch, the Relay.

A: Power system has currents flowing through transmission lines. These current should be within limits.…

Q: Function of circuit breaker!

A: A mechanical device called a circuit breaker is made to shut or open contact members, which closes…

Q: Type UF cable, buried underground, fed from a 15-ampere, ground-fault circuit interrupter at a…

A: As stated by National Electric Code(NEC),the maximum cover of UF cable or the maximum burial depth…

Q: Differentiate between straight-through cable and Crossover cable

A: Straight-through cable- It is a type of twisted pair cable that are the most commonly used. It is…

Q: What is the load for 100 15A/20A, 125v duplex receptacles in a non-dwelling occupancy after applying…

A: NEC Table 220.44 gives demand factor for Non Dwelling receptacle.

Q: A Double Circuit Iransmission System will alwa have six cables or conductors suspended on the…

A: A double -circuit transmission line refers to the arrangement in which a total of six conductors are…

Q: what is the standing wave of a 75 ohm connected to 50 ohm transmission line?

A: The characteristic impedance is Z0=50 ohms.  The load impedance is, ZL=75 ohms The standing wave…

Q: Which button is used to cut the component in LTspice program?

A: Electrical circuits are designed for various experiments. The circuit is first run on a circuit…

Q: A service disconnection means must be installed adjacent to, within sight of, and no more than…

A: According to question we have to discuss about A service disconnection means must be installed…

Q: What's the difference between regulated and unregulated redundancy?

A: regulated redundancy is better tan unregulated redundancy due to following differences

Q: Type UF cable, buried underground, fed from a 15-ampere, ground-fault circuit interrupter at a…

A:

Q: Define interlocking in electrical systems. What is it's significance?

A: According to the given question, it is required to define interlocking in electrical systems along…

Q: The sequence of the positive sequence network is ………………………. To the faulty network

A: Fill in the blanks with appropriate words: This is based on the fault.    The sequence of the…

Q: Label the parts of Lattice Steel Towers.

A: Lattice Steel Tower Lattice steel tower means an independent standing perpendicular steel tower.…

Q: 1-DO you need a repeater station if we used optical cable under the sea level? And why?

A: If we used optical cable under sea level then there is a chance that it lose or reduce its signal.…

Q: draw a block diagram of the jumpers connected to the front panel of a computer system unit

A:

Q: In Single Busbar System with Bus Sectionalization, any two sections of the Busbar are connected via…

A: Choose the given Statment is it true or false?  The Statment:- In Single Busbar System with Bus…

Q: True or False: We can use BLOG term in 66 blocks to remember the wire order, and remember to start…

A:

Q: Which statements are correct regarding the picture?

A: Image shows Airbus electrical system.

Q: With the aim of a schematic, explain the principle of high impedance busbar protection.

A: High impedance bus bar protection requires High impedance CT with high knee point voltage and the…

Q: draw a schematic diagram of the jumpers connected to the front panel of a computer system unit.

A: Jumpers allow the computer to shut down the electrical circuit, allowing electricity to flow to…

Q: rating of a OCPD reads 25 KA as the interrupting capacity of the unit - a short circuit beyond that…

A: In this solution we discuss about shot circuit capacity of CB's.

Q: need the answer as soon as po

A:

Q: Name three common sources of interference.

A: Signals are a means of communication. Electrical signals are transmitted between sending point and…

Q: Correct and detailed answer will be Upvoted else downvoted. Thank you!

A: According to question: As there two voltage sources of different frequencies of 4rad/s and 8rad/s…

Q: Go straight a head and at the * traffic lights

A: Go straight ahead and turn at the traffic lights.

Q: Q.12 What provides branch-circuit protection, and where is it located? Select one: A. BREAKERS…

A: 12.  A fuse is an electrical gadget used to shield the circuit from overcurrent. It comprises a…

Q: A passenger arriving in a new town wishes to go from the station to a hotel located 10km away on a…

A: Given that  Distance from station to hotel is 10 km  Distance travelled is 23 km  Time taken to…

Q: How to connect and disconnect the circuit breaker and disconnector respectively, and explain why?

A: A circuit breaker is a kind of electrical switch which is used to protect an electrical circuit from…

Q: draw sequence diagram for circuit-breaker example

A: The circuit breaker is a device that can make or break the circuit during the fault. The above…

Q: 14. Which of the following types of grounding system should be installed in a patient care area? A.…

A: A power station is to provide electricity to a huge number of people. Different customer’s power…

Q: Q3: What is a synchronous circuit?

A: I hope you asking synchronous circuit in terms of digital circuits, you have not stated it so I am…

Q: 11. Which of the following is the drawback for cordless telephones?

A: The correct option along with the explanation is provided in the following section.

Q: What is the minimum height of electrical service entrance

A: The Minimum Height for an Electric Service Meter is actually specified by the local electric utility…

Q: Make sure Vrl and Irl are about as equal to the measured values (please answer it)! It's not for a…

A:

Q: When installing a surge arrester at the service of less than 1000 volts, the grounding conductor…

A: Equipment Grounding Conductor (EGC) – A conductive path that 's a component of a decent ground-fault…

Q: Which statement is correct

A:

Q: Determine the maximum number of lighting outlets for 15, 20, 25 and 30 circuit breaker.

A:

Q: MCCB, is Miniature Case Circuit Breaker. Select one: True

A: MCCB useful for protection against short circuit faults.

Q: The contractor is controlled by?

A: According to the question we have to discuss the contractor is controlled by.

Q: is used for measuring the insulation properties of electrical cables and equipment's.

A: Fill the blank ....... Is used to measure the insulation properties of electric cable.

Q: what is the unique feature fore fire alarm system by arduino?

A: FIRE ALARM SYSTEM USING ARDUINO: In a fire alarm system using Arduino, an IR-based flame sensor…

Q: Please answer very soon will give rating surely

A: Let the current flow according to the given rating be i.

Q: Please provide Handwritten answer Question: NEC Reference  Answer   __________ __________ _____ is…

A: Although,  Patient equipment grounding point is used ,to the eliminate  the electromagnetic…

Q: Draw the block diagram of staircase ramp type digita oitmeter and explain the same.

A: consider the given question;

Q: No plagarism please! Correct and detailed answer will be Upvoted else downvoted. Thank you!

A: As per the guidelines of Bartleby we supposed to answer first three subparts of the question for…

RTD (Resistance Temperature Detector)

A resistance temperature detector is a passive electronic device or a sensor. The name itself suggests that it is related to resistance, temperature, and detection. Similarly, its resistance changes when there is a temperature change; the resistance increases when the temperature of the RTD device increases or vice-versa. It is also known as a resistance thermometer. Its working is similar to the thermocouple.