What is the maximum change in entropy and work that can be produced in a steady state flow process for 12 moles of nitrogen at 800K and 50 bar, if the ambient temperature and pressure are at 300K and 1.0133 bar. assuming nitrogen is an ideal gas.

Q: A liquid has a molar volume of 0.2 L/mol at 400 K and 4 bar. This liquid is compressed with a pump…

A: A. Work done by the pumpThe work done by the pump is given by the following formula:wheren is the…

Q: A compressor for the carbon dioxide compresses 2 m^3/min at 20 C and 500 kpa to 110 C and 4800 kpa…

A: Inlet volumetric flow rate, V1=2000m3minInlet temperature, T1=200C=293KInlet pressure, P1=500…

Q: Consider an ideal gas which is being throttled to pressure of 1 bar at a rate of 100 mol/s The…

A: Molar flow rate of an idea gas = 100 mol/sInitial pressure = 25 barFinal pressure (pressure at the…

Q: exit velocity and what is the cross-sectional area at the nozzle exit f

A:

Q: Q3/ A 1.5 m' tank initially contains 50% volume liquid water at 14 bar, if vapor only is bled from…

A: Adiabatic process: In thermodynamics, an adiabatic process is a process in which transferring heat…

Q: The change in entropy for the system is 800 k 600k 1200 kJ 800 kJ НЕ →1200 kJ 600 kJ 200 kJ 400 k…

A: Solution :     Given that The heat Q1=1200 kJ and Q2=800 kJ  enter the heat engine from reservoirs…

Q: Show that h,dx h 2hx=L 3DL dx 0,

A: When a fluid flows over a cod or heated surface (plate), temperature field is set up in the region…

Q: "Consider a heat engine with a piston chamber that has a diameter of 30 mm, a cold reservoir at 285…

A: Heat engine of diameter 30 mm Cold reservoir temperature= 285 K Hot reservoir temperature = 350 K…

Q: air is entering a compressor at 373.15K and 500kPa, it exits the compressor at 520K and 1200Kpa.…

A: Given :Air entering temperature of the compressor  Air entering pressure of the compressor Air exit…

Q: Estimate the volume of a compound in vapor phase using below methods. Fluid is at a state  with T =…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: Assume that 1 mole of water is at atmospheric pressure and a temperature of T = 22°C. Assume the…

A: Gibb's free energy change is related to change in pressure and temperature by following equation dG…

Q: What exists in a system that is at 1 atm and 175 K?

A: A phase diagram is a diagram or the graph that is drawn between Pressure and Temperature. It…

Q: 1.31 Refrigerant 22 vapor enters the compressor of a refrigera- tion system at an absolute pressure…

A: Absolute pressure of system = 0.1379 MPa Pressure at exit in gage = 1.93 MPa Atmospheric pressure =…

Q: A gasoline truck engine takes in 10,000 J of heat and delivers 2,000 J of mechanical work per cycle.…

A: write the relation of heat engine for work done, work done=QH-QL  ....(1) Given, work done=2000J…

Q: = heat transfer rate from the compressor in kW

A:

Q: ca gas Wi 2. Steam at 2500 kPa and 350° C enters a turbine and leaves at 10 kPa. The turbine…

A:

Q: The synthesis of ammonia proceeds according to the following reaction: N2 + 3H2 → 2NH3 In a given…

A: Given data: The reaction of ammonia synthesis:   N2 + 3H2 → 2NH3 N2 feed to the reactor = 4202 lb H2…

Q: The tank below in figure 1 has oil and water. An open ended U-tube manometer is attached near the…

A:

Q: 6.83. An equimolar mixture of methane and propane is discharged from a compressor at 5500 kPa and…

A: Introduction:- To raise a fluid's pressure, compressors are employed. The most common type of…

Q: For  each of the cases below, determine if the heat engine satisfies the first law and if it…

A: First law of thermodynamics: First law of thermodynamics represents the law of conservation of…

Q: Find the entropy change of an ideal gas undergoing an isothermal process from 2.00 atm to 0.60 atm…

A: Given data:- Isothermal process P1 = 2 atm P2 = 0.60 atm Find the entropy change of an ideal gas.

Q: Air enters a compressor operating at steady state at 1.05 bar, 300 K, with a volumetric flow rate of…

A:

Q: 1. If the atmospheric pressure is 101.325 kPa and the absolute pressure at the bottom of the tank as…

A: Given Data Atmospheric Pressure, PT= 101.325 kPa Pressure (absolute) at the bottom, PB = 250.50 kPa…

Q: For the given question and solution, for part (b), finding the work input  of the saturated vapour…

A: A compressor is used to compress steam at two different phase of steam.

Q: Q5/ A stream of hot water at 150 °F flowing at a rate of 409 Ib/min is to be produced by mixing…

A: The mass going into the system is equal to the mass going out of the system and the mass stored in…

Q: An engineer needs saturated steam at 100C with a flowrate of 550 kg/h from an ice block using the…

A:

Q: Q1: Steam flows through a device with a stagnation pressure of 900kpa, a stagnation temperature of…

A: Given: Stagnation pressure P0= 900 kpa Stagnation temperature T0= 371 °C Velocity= 275 m/s, Cp=…

Q: Q1:Air enters a diffuser at 200 m/s with a pressure of 80 kPa and a temperature of -20°C. It leaves…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which you…

Q: The vapor pressure of water at 27 K is 40 atm. If the volume of the container is doubled then, its…

A:

Q: 2. A system has heat capacity at constant volume C, = 0.042 T. The system is initially at 20OK and a…

A: A system have Heat capacity Cv=0.042T2 J/K System temperature T1=200K Thermal reservior…

Q: You have a steel cylinder with 10 L of oxygen, at 1.2 atm and 65 ° C. What will its temperature be…

A: GIVEN volume of steel cylinder = 10 L  initial pressure P1           = 1.2 atm initial temperature…

Q: An ideal internal combustion engine is operating using a fuel as working fluid with a specific…

A: Given data Specific capacity ratio=1.404 r=9 re=7 r=rexρ ρ=rre=97=1.286

Q: acetylene behaves ideally as it goes through an isentropic process from 6 bar to 2 bar. The initial…

A:

Q: An ideal gas that is heated at constant pressure enters the steady-flow heat exchanger at 343.15 K.…

A:

Q: A 1200 L vessel contains 85 gmol of nitrogen. The vessel can withstand 25 kPa above atmospheric…

A: Given, Volume of Vessel V = 1200 L = 1200 × 10-3  m3 Mass of Nitrogen m = 85 gmol Maximum Pressure…

Q: Given what you know about thermodynamics, the energy balance equations that you have learned, etc.…

A:

Q: Find (integrating) the compressor work expression according to the Pvn interchange and express the…

A:

Q: 6. You have a block of Copper (mass: 10 kg, temp: 800 K) and water of mass 100 kg, temp: 290 K. What…

A:

Q: Case Study: Two AES exchangers in series have difficulty heating a process stream from 50°C to 90°C…

A: To increase or decrease the temperature of the fluid, we will make this fluid run through the heat…

Q: An Inventor claims to have developed a refrigeration unit which maintains the refrigerated space at…

A: