What is the energy collected from the sun in watts /area as measured in the pyranometer. O a. solar battery O b. irradiance O c. solar inverter O d. voltage
Q: A 1 lbm/s fluid enters a machine at 170 m/s. 800 kPa, and with a specific volume of 0.3 m³/kg. The…
A: Determine workdone by the fluid?
Q: Two bulbs A and B contain air and are connected together as shown below. Determine the difference in…
A: in given question lets assume PA at A point and PB at B now consider the left side tube section of…
Q: A manometer is attached to a water tank, as shown in the given figure. Find the height of the free…
A:
Q: 7. What is the potential energy of the 100-N block? 3 2 m Datum a. 50 J b. 100 J
A: Weight of the block = mg = 100 N . Height above datum = h =2 m . The potential energy depends upon…
Q: 3. The motor unit A is used to elevate the 300-kg cylinder at a constant rate of 2 m/s. If the power…
A:
Q: To determine the density of a liquid experimentally in a laboratory, you have 0.078 kg empty…
A: Given data, Mass of graduated cylinder = 0.078 kg Mass of cylinder + liquid = 0.2755 kg Volume of…
Q: Find the energy required to increase the room temperature of a coffee in a cup to a temperature of…
A: A type of elastic collision in which two objects of equal mass initially move in the same direction…
Q: 7. What is the unit of power absorbed in a fluid? a) Ampere b) Volt/m c) kgm²s³ d) kg/m
A: Unit of power is a Watt. This is in accordance with the SI unit. The International system of units…
Q: Ug Two similar round bars A and Bare each 30 cm long and loaded as shown in the given figure. The…
A:
Q: DETERMINATION of HEAT of SOLUTION by SOLUBILITY METHOD Experimental data are given as follows,…
A:
Q: LABORATORY ACTIVITY APPLICATION OF BERNOULLI’S THEOREM QUESTIONS: 1. What method does the apparatus…
A:
Q: A power nozzle throws a jet of water which is 30 mm in diameter at a velocity of 40 m/s. What is the…
A: Given data: Diameter of nozzle=30 mm Velocity=40 m/s It is asked to find the power exerted by…
Q: Two bulbs A and B contain air and are connected together as shown below. Determine the difference in…
A:
Q: A glass of lukewarm milk is suggested for people who cannot sleep. Milk at 52 degrees Celsius can be…
A:
Q: A heat pump supplies heat energy to a house at the rate of 140,000 kJ/h when the house is maintained…
A: It is required to determine the maximum Coefficient Of Performance for air. We know that, 0oC = 273…
Q: A domestic refrigerator is loaded with food and the door closed. During a certain period the machine…
A: The first law of thermodynamics explains that energy can neither be created nor destroyed. heat is…
Q: A certain brand of hotdog cooker works by applying a potential difference of 146 V across opposite…
A: Given data; Potential difference, V=146 V Current, i=12.8 A H=60.8 KJ
Q: The Energy Efficiency Rating (EER) of an air-conditioning unit is defined asthe ratio of the heat…
A: Given data, Heat removed by one ton of A.C = 12,000 Btu/h Energy used = 2410 Watts. Capacity of A.C…
Q: For the 11 cm diameter suction pipe leading to a pump in the figure, the pressure at point A in the…
A: Given data: Suction pipe diameter=11 cm =0.11 m Pressure at point A in the suction pipe is a vacuum…
Q: Velocity of car=3 m/s mass of car-4 kg Find kinetic energy
A: Mass of the car = 4Kg velocity of the car = 3m/s
Q: Assume 40% of the light emitted by a 1000 W metal halide lamp (110,000 lm) illuminates a surface…
A: Given Data: Utilisation factor, Uf = 40% =0.4 Luminous flux, ϕ= 110000 lm Diameter of illuminated…
Q: An engine absorbs 100 J and rejects 60 J in each cycle. (a) What is its efficiency? (b) If each…
A: Given: The energy absorbs by the engine is 100 J. The energy released by the engine is 60 J. The…
Q: 2. With an initial pressure of 30x105 Pa and constant operating temperature of 200°K in a 40 m³-tank…
A: Given data:- Initial pressure =30×105 Pa Operating temperature =200°K Volume of tank =40 m3 Length…
Q: It is connected to a tank in the form of a U- type mercury manometer. Since the G liquid has a…
A:
Q: Determine the luminous efficacy of the following lamps having comparable illumination outputs: a. A…
A: Given data : the following lamps having comparable illumination outputs:a. A 300 W incandescent lamp…
Q: Which of the following statements is INCORRECT? O Evaporation from an open water surface is usually…
A: Evaporation from open surface is estimated by pan evaporation. In evaporation Water changes into…
Q: Discuss the implications of difference in the EROI or efficiency for electric and hydrogen car
A: this question is asking about comparison of efficiency for electric cars and hydrogen cars :
Q: One of the most common appliances used on a daily basis is the hair dryer. A hair dryer is basically…
A: Given :
Q: O a. Solar energy O b. Wind energy O c. Mechanical energy O d. Kinetic energy
A: On roof mounting systems are related to solar energy
Q: 88.18 liters of a distinct liquid weig ermine its density ( D0 liter = 1 m3
A: Given data- Mass(m) = 417.91kg Volume(V)= 388.18 lit 1 m³ = 1000 lit Volume(V)= 388.18 lit =…
Q: Q: The tank in Figure is closed at top and contains air at pressure PA. Calculate the value of PA of…
A:
Q: calcujate the reading of o barometer în mm of mercury 97.9 kPa corres ponding to an atmospheric…
A:
Q: 2. A parallel-plate capacitor initially has a capacitance of 100 F. What will be the capacitance if…
A:
Q: The inside temperature of an oven is maintained at 230° C while the kitchen air temperature is 25° C…
A: The measure of hotness or coolness of a body is characterized as temperature. It is expressed in…
Q: A 400-kg satellite was placed in a circular orbit 1500 km above the surface of the earth. At this…
A: Given data, Mass, m = 400 kg Velocity, v = 25.6 x 10³ km/h Acceleration of gravity = 6.43 m/s² To…
Q: Find the kinetic energy of a bullet of mass 5.00 g traveling at a speed of 305 m/s. Find
A: This question is related with solid mechanics . In this question we are provided with value of mass…
Q: A small electric immersion heater is used to heat 71 g of water for a cup of instant coffee. The…
A: The given data is as follows: Mass of water=71 gPower=63 wattsInitial temperature=19∘CFinal…
Q: Work done by an engine in 6 sec is 1000 joules. What is the power generated by the engine in watt?…
A:
Q: When t= 30 minutes, the temperature of the object is unknown.
A:
Q: An incandescent lamp filament has area 40 mm' and operates at a temperature of 1127°C. Assume that…
A:
Q: a metal is heated up to 500 degree celsius. it is then exposed to a room temperature of 38 degree…
A:
Q: Gasoline has a specific weight of 7000 N/m^3. Which nearly gives its mass in kilograms when poured…
A:
Q: 3) A body at an unknown temperature is placed in a room with constant temperature of 30 °F. If after…
A: Given; Room temperature=30°F After 10minute temperature of body =0°F After 20 minutes temperature of…
Q: Problem 14.15 A jet plane which weighs 29.43 kN and having a wing area of 20 m flies at a velocity…
A:
Q: Determine the properties of propane in gaseous state with the help of generalized compressibility…
A: Temperature at specific volume = 0.006 m3/kg Pressure = 7 Mpa ⇒From Ideal gas law
Q: Elev. 6 m Elev. Sm Air pressure - 30 kP. Oil (18 - 082) Elev. 2 m Water Elev. Om 1.00 m Mercury (1g…
A:
Q: FLUID MECHANICS: THE ENERGY EQUATION: The attached image shows a common consumer product called a…
A: Recall that density of water is function of temperature i.e. it varies with temperature.Density of…
Step by step
Solved in 2 steps
- In a parallel electrical circuit, the total current is the sum of the individualcurrents. An air conditioner has a blower and a compressor that are wired ina parallel circuit. The blower draws 1.042 amperes and the compressor draws11.95 amperes of current. When both are operating, what is the total currentdrawn?4. An incandescent lamp has a tungsten filament whose resistance is 96 ohm at its operating temperature of 2900°C. Calculate the filament resistance when the lamp is disconnected from the electric source under which conditions the temperature is 24°C.Determine the luminous efficacy of the following lamps having comparable illumination outputs:a. A 300 W incandescent lamp that emits 5820 lmb. Two 32 W linear fluorescent lamps that emit 2950 lm per lamp in a luminaire that consumes 70 W including the ballastsc. A 70 W metal halide lamp that consumes 88 W, including the ballast and emits 5500 lm
- Calculate the change in 5 m long copper wire when its temperature changesby 60º C.1. An unknown lamp placed 6m from a photometer screen provides the same illuminance as a 90 cd lamp placed 4 m from the screen. What is the candlepower of the unknown lamp? 2. The illuminance of a room 20 ft x 15 ft is being designed. The illuminance required is 50 footcandles. What is the total required lumens output of the lamp assuming room and luminaire efficiency of 42%?e Q2/ Calculate the angle made by beam radiation with normal to a fiat plate collector on December 5, at 9.15 AM. solar time for a location at 28° 35' N. The collector is tilted at an angle of latitude plus 6°, with the horizontal and is pointing due south. Cal NOT :-May be using equations: Z 20 L h L 1- cos OT = cos (-ß) cos 6 cos + sin (4- ß) sin 8- B_ 528
- A tungsten lamp filament has a temperature of 20.5 degrees Celsius and a resistance of 500 ohms when taking normal working current. Calculate the resistance of the filament when it has a temperature of 25 degrees Celsius. RTC at 0 degree Celsius is 0.005/°C. * Your answer4. Assume that half of the light emitted by a 100 W incandescent lamp (1750 lumens) illuminates a 100 ft2 surface. a. Determine the average illuminance of the surface in foot-candles. b. Determine the average illuminance of the surface in lux. c. What would the average illuminance be if only half of the light illuminated the surface?i) What is a photovoltaic cell? ii) A certain solar cell type has an output capability of 0.5 A at 0.4Volts. A series / parallel solar array has been designed of such cells with 80 parallel strings and each string has 1500 cells in series. Calculate: (i) Voltage capability (ii) Current capability and (iii) Power output capability of the array.
- Which of the following best describes a Venturi Meter? an opening having a closed perimeter in a wall or partition used for measuring flow of fluids are flow measurement instruments which use a converging section of pipe it can be used to measure fluid flow velocity by converting Kinetic Energy to Potential an opening in a dam or other Ohydraulic structure to control the passage of water Trapezoidal weir with side slope of 1 horizontal to 4 vertical Suttro Weir V-Notch Weir Cipoletti Weir Contracted Weir2. A parallel-plate capacitor initially has a capacitance of 100 F. What will be the capacitance if the distance between the plates is doubled?Give 6 applications of battery to civil engineering field and explain.