What is the approximate pH at the equivalence point of the titration curve shown below?ABA. O Less than 7B. About 7C. O Greater than 7CVolume titrant added (mL)

Approach to solving the question:The given graph is a titration curve. Titration curves have…

Answered: What is the approximate pH at the…

Chemistry: Principles and Practice

3rd Edition

ISBN:9780534420123

Author:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Publisher:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Chapter16: Reactions Between Acids And Bases

Section: Chapter Questions

Problem 16.59QE

See similar textbooks

Similar questions

The weak base ethanolamine. HOCH2CH2NH2, can be titrated with HCl. HOCH2CH2NH2(aq)+H3O+(aq)HOCH2CH2NH3+(aq)+H2O(l) Assume you have 25.0 mL of a 0.010 M solution of ethanolamine and titrate it with 0.0095 M HCl. (Kb for ethanolamine is 3.2 107.) (a) What is the pH of the ethanolamine solution before the titration begins? (b) What is the pH at the equivalence point? (c) What is the pH at the halfway point of the titration? (d) Which indicator in Figure 17.11 would be the best choice to detect the equivalence point? (e) Calculate the pH of the solution after adding 5.00, 10.0, 20.0, and 30.0 mL of the acid. (f) Combine the information in parts (a), (b), (c), and (e), and plot an approximate titration curve.
Consider the titration of 100.0 mL of 0.100 M HCN by 0.100 M KOH at 25C. (Ka for HCN = 6.2 1010.) a. Calculate the pH after 0.0 mL of KOH has been added. b. Calculate the pH after 50.0 mL of KOH has been added. c. Calculate the pH after 75.0 mL of KOH has been added. d. Calculate the pH at the equivalence point. e. Calculate the pH after 125 mL of KOH has been added.
Consider the nanoscale-level representations for Question 110 of the titration of the aqueous weak acid HX with aqueous NaOH, the titrant. Water molecules and Na+ ions are omitted for clarity. Which diagram corresponds to the situation: After a very small volume of titrant has been added to the initial HX solution? When enough titrant has been added to take the solution just past the equivalence point? Halfway to the equivalence point? At the equivalence point? Nanoscale representations for Question 110.
Cyanic acid (HOCN) is a weak acid with AL, = 3.5 X IO-4. Consider the titration of 25.0 inL of 0.125 M HOCN with 0.125 M NaOH. Calculate the pH of the solution at each of the following points. Before any NaOH has been added. .After 12.5 mL of NaOH has been added. After 23.0 inL of NaOH has been added. .After 27.0 mL of KOH have been added. Use your calculator or a spreadsheet to plot the titration curve, and use your graph to estimate the pH at the equivalence point.
When 40.00 mL of a weak monoprotic acid solution is titrated with 0.100-M NaOH, the equivalence point is reached when 35.00 mL base has been added. After 20.00 mL NaOH solution has been added, the titration mixture has a pH of 5.75. Calculate the ionization constant of the acid.
A 0.4000 M solution of nitric acid is used to titrate 50.00 mL of 0.237 M barium hydroxide. (Assume that volumes are additive.) (a) Write a balanced net ionic equation for the reaction that takes place during titration. (b) What are the species present at the equivalence point? (c) What volume of nitric acid is required to reach the equivalence point? (d) What is the pH of the solution before any HNO3 is added? (e) What is the pH of the solution halfway to the equivalence point? (f) What is the pH of the solution at the equivalence point?
A 0.2481 M solution of KOH is used to titrate 30.00 mL of 0.269 M hydrobromic acid. Assume that volumes are additive. (a) Write a balanced net ionic equation for the reaction that takes place during the titration. (b) What are the species present at the equivalence point? (c) What volume of KOH is required to reach the equivalence point? (d) What is the pH of the solution 1. before any KOH is added? 2. halfway to the equivalence point? 3. at the equivalence point?
A buffer solution with it pH of 12.00 consists of Na3PO4 and Na2HPO4. The volume of solution is 200.0 mL. (a) Which component of the buffer is present in a larger amount? (b) If the concentration of Na3PO4 is 0.400 M, what mass of Na2HPO4 is present? (c) Which component of the buffer must be added to change the pH to 12.25? What mass of that component is required?
Potassium hydrogen phthalate, known as KHP (molar mass = 204.22 g/mol), can be obtained in high purity and is used to determine the concentration of solutions of strong bases by the reaction HP(aq)+OH(aq)H2O(l)+P2(aq) If a typical titration experiment begins with approximately 0.5 g KHP and has a final volume of about 100 mL, what is an appropriate indicator to use? The pKa for HP is 5.51.
A buffer solution is prepared by dissolving 1.50 g each of benzoic acid, C6H5CO2H, and sodium benzoate, NaC6H5CO2, in 150.0 mL of solution. (a) What is the pH of this buffer solution? (b) Which buffer component must be added, and in what quantity, to change the pH to 4.00? (c) What quantity of 2.0 M NaOH or 2.0 M HCl must be added to the buffer to change the pH to 4.00?
Marble is almost pure CaCO3. Acid rain has a devastating effect on marble statuary left outdoors. Assume that the reaction which occurs is CoCO3(s)+ H+(aq)Ca2+(aq)+HCO3(aq) Neglecting all other competing equilibria and using Tables 15.1 and 13.2, calculate (a) K for the reaction. (b) the molar solubility of CaCO3 in pure water. (c) the molar solubility of CaCO3 in acid rainwater with a pH of 4.00.
Consider the titration of 100.0 mL of 0.200 M HONH2 by 0.100 M HCI. (Kb for HONH2 = 1.1 108.) a. Calculate the pH after 0.0 mL of HCl has been added. b. Calculate the pH after 25.0 mL of HCl has been added. c. Calculate the pH after 70.0 mL of HCl has been added. d. Calculate the pH at the equivalence point. e. Calculate the pH after 300.0 mL of HCl has been added. f. At what volume of HCl added does the pH = 6.04?

Recommended textbooks for you

Chemistry: Principles and Practice

Chemistry

ISBN:

9780534420123

Author:

Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Publisher:

Cengage Learning

Chemistry: The Molecular Science

Chemistry

ISBN:

9781285199047

Author:

John W. Moore, Conrad L. Stanitski

Publisher:

Cengage Learning

Chemistry for Engineering Students

Chemistry

ISBN:

9781337398909

Author:

Lawrence S. Brown, Tom Holme

Publisher:

Cengage Learning

Chemistry: Principles and Practice

Chemistry

ISBN:

9780534420123

Author:

Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Publisher:

Cengage Learning

Chemistry: The Molecular Science

Chemistry

ISBN:

9781285199047

Author:

John W. Moore, Conrad L. Stanitski

Publisher:

Cengage Learning

Chemistry for Engineering Students

Chemistry

ISBN:

9781337398909

Author:

Lawrence S. Brown, Tom Holme

Publisher:

Cengage Learning

Fundamentals Of Analytical Chemistry

Chemistry

ISBN:

9781285640686

Author:

Skoog

Publisher:

Cengage

Chemistry & Chemical Reactivity

Chemistry

ISBN:

9781337399074

Author:

John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:

Cengage Learning

Chemistry & Chemical Reactivity

Chemistry

ISBN:

9781133949640

Author:

John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

What is the approximate pH at the equivalence point of the titration curve shown below? A B A. O Less than 7 B. About 7 C. O Greater than 7 C Volume titrant added (mL)