What is Electric vehicle communication controller?

Q: Simplify

A: Given equation is shown below:

Q: What will he output of Y(s)?

A: This given system represents parallel connection with same input. In given figure, two blocks have…

Q: Four q=2.00 nC point charges are located at P1(0.00, -2.00, 0.00)m, P2(0.00, 2.00, 0.00)m, P3(0.00,…

A:

Q: Consider the circuit below. The power supplied by the 9 V source is 281.3 mW. Determine the resistor…

A:

Q: V₁ w 4Ω 1₂ Μ 4 Ω 4V 5Ω Va 5A

A:

Q: The network shown in Fig. P10.18 consists of a balanced 120 V (rms) Y-source connected in a positive…

A: From the given data,Here,  Ohm,  Ohm,  Ohm.To find: Find the phase voltages at the load: Find the…

Q: 50 V Ⓒ 512 -WM-

A:

Q: Draw the equivalent circuit of D.C. shunt motor, then write the equation for Ia, If and Te at steady…

A:

Q: b) For the following transfer functions. Write the dynamic equations (state equations and output…

A:

Q: VT 50 V Ť S1 Figure 2 R1 8.2kchm C1 0.01 uF 3.1. the time constant 3.2 the capacitor voltage 100 µs…

A: In this question, we need to determine the time constant, voltage across capacitor and draw the…

Q: Suppose that you have an electric flux density D = 4yax + 4xay. The amount of flux through a surface…

A:

Q: V2 1Vpk 7.34kHz 0 Vec -Vec Vec U1A -Vcc LM324N U2A LM324N U3A R7 m 20k LM324N C7 H C21nF 3nF C4 HH…

A: In an oscilloscope there is 3 terminal [A, B, and Ext Trig], These three terminal has two…

Q: lo (s) in terms of R, ZL, the impedance of the inductor Vs(s) a) Determine the transfer function…

A:

Q: A JFET Common Source amplifier with the following characteristics: 1. A voltage gain range from 15 V…

A: Given:

Q: 9.17 Generate Bode magnitude and phase plots (straight-line approximations) for the following…

A: “Since you have posted question with multiple sub parts, we will provide the solution only to the…

Q: Define the concept of "harmonic distortion" in power systems. What are the sources of harmonics, and…

A: Harmonic distortion refers to the presence of additional frequency components, known as harmonics,…

Q: Question # 3: F. From T(s) in Question # 2, use Routh Hurwitz method to make Routh table and find…

A: Given:

Q: Fill in the blanks with a suitable describing for the following 1. Active component of no load…

A: Active component of no load current of transformer is ___________Answer   :-  2-5% of full load…

Q: The network shown in Fig. P10.19 consists of a balanced 120 V (rms) Δ(delta)-source connected in a…

A:

Q: Use Laplace transform to find v(t) for t>0. The forcing function is defined as e^-2t u(t) V.

A: The circuit diagram,.

Q: (a) (b) Given a discrete-time signal x[n] as: n x[n] = (u[n + 1] - (3)¹u[_n − 1] Determine the…

A: Given:

Q: PROBLEM 2. Calculate the resonance frequency of this circuit if we know Q10. Use C=91 nF, L=2.2 mH,…

A:

Q: For the circuit shown in Figure 3, determine and sketch its voltage-current (v-i) characteristic.…

A: Given:Required:We need to plot the v-i characteristics of the diode. Diodes are assumed to be ideal.

Q: 220 /0° Vrms + 220 /-120° Vrms + 220 /120° Vrms + 2 Ω 2 Ω 2 Ω (8 + j2) Ω (8 + j2) Ω (8 + j2) Ω -ON

A: Given Data:Balanced, three phase, star-star connected source-load circuit with,Phase voltage (abc…

Q: A periodic signal r(t) is given graphically below -2 -1 1 0 2 t 1. Determine the angular frequency…

A:

Q: Determine the value of V (pay attention to the polarity shown)

A: For the given circuit the value of voltage VL needs to be calculated and the same can be calculated…

Q: a. Find the voltages v and v1.

A: Given circuit is shown below:R= 4 kohms

Q: Tuesday, March 7 2023 8:45 PM G/Find the Trans Fer Function, for the signs GA G₂ -H₁ (e) B Gy Gy -H₂

A: Given Data:A signal flow graph with,Input  andOutput To Find:Transfer function.

Q: Use Logic.ly to implement the shown (picture provided) 4-bits adder. Verify the logic behavior of…

A: According to the question, we need to explain the working of 4-bit parallel adder circuit.

Q: Drill 7.1 Calculate the cutoff frequency for the first four modes of WR90 waveguide. (Answer: f =…

A: To find:Cutoff frequency for first four modes of WR90 waveguide.Note:WR90 waveguide has dimensions…

Q: Q4. A continuous-time LTI system is described by the following differential equation: (dy(t) / dt)…

A: 4.

Q: The transfer function of a system is S e 500 given by G (s) s+500 = The input to the system is x(t)…

A: Given information is shown below:

Q: Suppose an Electric Flux Density in the space is given by: D = 10.p.sino a (C/m²). Determine the…

A:

Q: b) Prove that the ramp error constant for the second-order system is Wn 25

A: The block diagram for the second-order system will be,

Q: Change the MOD-8 counter in Figure to a MOD-16 counter, and connect the MSB to the multiplexer E…

A: According to the question, we need to change MOD-8 counter in Figure to a MOD-16 counter, and…

Q: 4. a) Design the operational amplifier circuit of Figure Q4a to have an input resistance of 20 k2…

A:

Q: A communication sensor of mass M on a spacecraft is modelled as shown below. Let K= 112.5 N/m, C =…

A: For a communication sensor on a spacecraft, the following values are given:mass M=0.5 kg,damping…

Q: Constants of Free Space: Velocity of light c=3×10³ (m/s), Permittivity=8.854x10-¹2 or 10/367 (F/m),…

A:

Q: Simplify using kmap only text

A: Given equation is shown below:

Q: [Q1] (A) A 100-hp 440V, 0.8 leading power factor, delta connected S.M has an armature resistance of…

A:

Q: CP3 for a dipole antennd of 3m long IgA determine Power radiation, radiation resistance directivity…

A: For the dipole antenna of  long .Determine the power radiation and radiation resistance.a) If, the…

Q: Given the following two-port network Vs ww www 1 www 113 + >², 2 a. Determine the y parameters. b.…

A: The circuit isWe need to find a. The Y-parameters.b. V2(s) for vs(t)=10 u(t).

Q: Now we will use this knowledge of the code structure to make an LED Blink! Refer to Task 2 (page 7)…

A: We need to calculate the smallest resistor value.The Red LED has a forward voltage of  Volts.The…

Q: P3 for a dipole antennd of 3m long Jo=gA determine Power radiation, radiation resistance directivity…

A:

Q: Q6: The periodic pulsed waveform shown is applied to the RL circuit. Derive the first three nonzero…

A: Given:Required:We need to derive the first three non-zero terms in the Fourier series.

Q: Demonstrate whether the following systems are causal, invariant and linear. c. x[n]y[n] = kx[n] d.…

A: Since you have not mentioned which part of question you are looking for, so we are answering two…

Q: 9.17 Generate Bode magnitude and phase plots (straight-line approximations) for the following…

A:

Q: Explain the fundamental differences between open-loop and closed-loop control systems. Provide…

A: Open-Loop Control System:An open-loop control system is a type of control system where the control…

Q: use a D flip-flop to implement synchronous counter for counting only odd numbers less than ten

A:

Q: What do you mean by zero shifting by partial removal of a pole? Explain its significance with…

A: What do you mean by zero shifting by partial removal of a pole? Explain its significance with…