What is an A/D converter with Voltage-to-Frequency Conversion (VFC)?  What is the working principle?

Q: Draw and derive the relation between input and output voltage of buck-boost converter in terms of…

A:

Q: The dc converter in the next figure has a resistive load, R = 15 and input voltage, Vs = 240 V. When…

A:

Q: Calculate the the Output Voltage of a non-inverting op-amp with the following parameters Rf =…

A: Features of Op amp High CMRR High gain High input impedence  Low output impedence  Noise rejection

Q: If I want to design a buck converter, what factors will affect my switching frequency selection?…

A:

Q: For Steady-State Operation​ o​ f Boost DC-DC Converter Compare between control characteristics of…

A: Boost converter:-  initially the switch is closed hence the current for half of duty cycle will flow…

Q: In Steady-State Operation​ o​ f Buck DC-DC Converter Explain how the switching frequency component…

A: Steady-state operation of Buck DC-DC converter: A buck converter (step-down converter) could also…

Q: Ex) A standard two-junction thermocouple configuration is being used to measure the temperature in a…

A: solution is as follows

Q: Explain and fill in the table below with how VOUT differs between the two circuits in figures 2.1…

A: The given circuits areFigure(a)Figure(b)

Q: In .................. mode of operation, fully controlled converter will keep a delay angle range…

A: average value of output voltage can be controlled by controlling the delay angle of thyristor.

Q: The major disadvantage of the R/2nR DAC is the difference of the maximum and minimum output…

A: The explanation is as follows.

Q: Describe the principle of superposition in Electrical Engineering and Circuit Analysis.

A: To describe: The principle of superposition in Electrical Engineering and Circuit Analysis.

Q: 8- Auto transformer is used in tuned amplifier to (transform low impedance of transistor input,…

A: 8.) In amplifier transformer is connected instead of collector load which serves as inter stage…

Q: Discuss current to voltage converter circuit using OP-AMP.

A: Operational Amplifier is direct coupled high gain amplifier. The  OP-AMP is multi terminal device.…

Q: Write about two applications for a series circuit, (Think about the different electronics at home or…

A:

Q: Define form factor and peak factor.

A: Form factor is the ratio of RMS value of the signal to the average value of the signal.

Q: Calculate the output impedance for small-signal equivalent circuit. (R1=10 k2, r. =10 k2) ER, Rat O…

A: By drawing the small signal model of the given common emitter amplifier we can able to find the…

Q: 11. An SCR turn-off requires * anode current falls below holding current. reverse voltage is applied…

A: 17. An SCR turn off requires  a. Anode current falls below holding current. b. Reverse voltage is…

Q: C)Buck DC-DC Converter

A:

Q: In the DC/DC Buck Converter shown below, all the components are ideal. Redraw the circuit and show…

A:

Q: 4. The average power consumed by resistance is equal to .. in non- sinusoidal input signal. *

A: Average power consumed by a resistance

Q: Hello, I was wondering how it could be either a buck or a boost considering the output voltage is…

A: There are three types of converters, Buck converter Boost converter Buck-boost converter

Q: Q3( (A) Consider you have to analyze a Step-Down DC convertor having the following parameters: Input…

A: "Since you have posted a question with multiple questions, we will provide the solution only to the…

Q: Implement a buck converter with a PID controller and a voltage divider sensing unit using analog…

A:

Q: 1- Draw a one-phase bridge type Full Wave Uncontrolled AC/DC converter circuit, explain the working…

A:

Q: You are hired as a technical consultant to model, design and analyze an efficient DC-DC buck…

A: Vin=15V=VSD=V0Vin=1015=0.67Pout= 5watt =V0I0I0=5/10=0.5APout= 200watt =V0I0I0=200/20=10A=ILavgIn…

Q: the given comparator and input signal V, draw the output waveform w.r.t the sinewave input signal…

A:

Q: (B) For the mechanical system in figure (4). Drive the transfer function Y(s)/F(s) KI M K2 Figure…

A: we need to find out transfer function for the given mechanical system.

Q: Q1) Give the equation of the output voltage V, in function of the input voltage given in the figure…

A: given that input voltage wave form to the differentiator circuit is   output voltage Vo is…

Q: In a three phase (50Hz) full converter, the ripple frequency in output voltage?

A: Given: A three-phase full converter frequency, f = 50 Hz.

Q: (c)A Buck-boost converter with an input voltage varying in a range from 9V to 15V. For each input…

A: It is given that: Vs=12 VD=0.6Po=5 W

Q: In series compensation, if the series applied voltage is in quadrature with the liner current: A.…

A: Given voltage across the series compensator is in quadrature with line current (i.e. 90 degrees ),…

Q: It has a simple structure II. Its efficiency is more than 90% III. It only requires one transistor.…

A: Given: η>90% One transistor.

Q: Calculate the total offset voltage for the circuit shown below for op-amp specification values of…

A:

Q: Draw a one-phase bridge type Full Wave Uncontrolled AC/DC converter circuit, explain the working…

A:

Q: Design a buck converter and a resistive load operating in CCM mode with the following…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: select one quickly Dual slope integrating A/D converter presents ........ slopes at the output of…

A: Need to find the correct option

Differential amplifier

There are two amplifying stages with common degeneration in a differential amplifier.