What force (in N) must be exerted on the master cylinder of a hydraulic lift to support the weight of a 2000 kg car (a large car) resting on the slave cylinder? The master cylinder has a 1.50 cm diameter, while the slave has a 24.0 cm diameter. __________ N

A hydraulic piston has two surfaces which can move when a force is applied to them. On the left side, the piston surface is circular with a cross-sectional radius of 10 cm and on the right side it is square with a side of length 30 cm. A. If I push on the left side with 100 N of force, what total force will be exerted by the fluid in the piston on the right side? B. If I displace the piston on the left side by 18 cm, how far will the right surface move?

X A 1m tall cylinder is filled with half water and half oil. What is the total pressure (in Pa) at the base of the cylinder? Density of water is 1000 kg/m^3 and density of oil is 900 kg/m^3. * 40,000 5,000 9,000 9,500 Correct answer

A water hose with cross sectional area of 4.00 cm2 is used by a gardener to fill a 30.0 liter bucket. (1 L = 1000 cm3). The gardener notices that it takes 1.00 min to fill the bucket. What is the volume flow rate of the hose?

A car of mass 800 Kg is hoisted on the large cylinder of a hydraulic press. The area of the large piston is 0.35 m2 and the area of the small piston is 0.025 m2. The force needed on the small piston to raise the car is: 109760 Newton 57 N 560 N 11200 N Next Page Page 10 of 10 Submit Quiz 9 of 10 questions saved MacBook Ain

Two metal blocks are attached by a cable as shown in Figure P10.50 and are floating near the surface of a lake. If the volumes are V1 = 3 m3 and V2 = 1.23 m3 , what is the total buoyant force on the two blocks?

A force of 120.0 N is applied to 2.000 cm diameter piston, which is in contact with a closed container of water (density of water = 1,000 kg/m3). A second piston, with a diameter of 25.00 cm and at the same height as the first piston, is also in contact with the water. What force does the water pressure exert on the second piston?   Multiple Choice   10,450 N.   8,450 N.   18,750 N.   9,150 N.   9,500 N.

The small piston of a hydraulic lift (see figure below) has a radius of r1= 1.00 cm, and its large piston has a radius of r2=9.45 cm. What downward force of magnitude F1 must be applied to the small piston for the lift to raise a load of mass 1500 kg? Answer: N.

A dump truck uses a hydraulic cylinder, as the drawing illustrates. When activated by the operator, a pump injects hydraulic oil into the cylinder at an absolute pressure of 2.91 x 106 Pa and drives the output plunger, which has a radius of 0.180 m. Assuming the plunger remains perpendicular to the floor of the load bed, find the torque that the plunger creates about the axis identified in the drawing. 3.50 m Output plunger Axis Load bed Input for hydraulic oil