What does a HYSYS fluids package represent thermodynamically

Q: An oil burner nozzle is labeled 60°. This is the angle from straight ahead tothe direction that the…

A: Paper is placed 12 inches from the nozzle.  the oil burner is labeled at 600C, The Schematic of the…

Q: Write the energy balance for the material in a closed container, neglecting potential and kinetic…

A: Energy conservation law states that the total energy of the system and the surroundings can neither…

Q: A 10mm diameter tungsten cylindrical bar should fit a 9.988mm hole contained in a steel plate.…

A:

Q: 16. What is the unit of resistance in SI? O w O W/K O m-K/W O W/m^2-K O K/W

A: Asked;  SI unit of resistance

Q: It is said that inlet gas takes 5-6 turns in Cyclone Separator.Justify the statement.

A:

Q: In general, why should the operating pressure be high and the operating temperature be low for an…

A: The reason for the high pressure and low temperature for the absorption process is to be mentioned…

Q: B/ Define the Schmidt number, Prandtl number and Reynolds number and clear up the relation for each…

A: The Schmidt number (Sc), Prandtl number (Pr), and Reynolds number (Re) are dimensionless variables…

Q: For multicomponent distillation,under what conditions is the pinch point located at the…

A: The condition at which pinch point is located at the location of feed is to be mentioned.

Q: A valve chokes refrigerant 134a from 0.7 mPa to 160 kpa. Determine the temperature released by the…

A:

Q: Why do some evaporators operate under vacuum? How is the vacuum produced?

A: The reason for operation of some evaporators under vacuum is to be mentioned along with the method…

Q: Cone has top and bottom diameters of 10 and 20 cm and a height of 10 cm. Calculate the shape factor…

A:

Q: 4. Draw the (211) plane on a standard set of x,y,z coordinates.

A: To visualize the (211) plane in a standard set of x, y, z coordinates, we can represent it as a 2D…

Q: What is the wet-bulb temperature? How is it measured? How does it differ from the dry-bulb…

A: The wet-bulb temperature and dry bulb temperature is to be defined along with the way to measure the…

Q: Ethanol (CH3CH2OH), the intoxicant in alcoholic beverages, is also used to make other organic…

A: Mass of ethanol that yields 35.9 g diethyl ether is me = 50 g The molar mass of ethanol is 46 g/mol…

Q: What is the thermal Diffusivity. Write down the factors effecting it.

A: Thermal Diffusivity Thermal Diffusivity is defined as the ratio of heat conducted to heat stored.…

Q: Viscosity varies with temperature according to which of the graphs below?

A: How does viscosity vary with temperature?

Q: On Mars, people live in domes. The outside of the dome walls are made of aluminium. However, the…

A:

Q: Discuss about Momentum and heat transfer operation with examples

A: Momentum transfer - In general, transfer of momentum from one molecules to other molecules due to…

Q: discuss any one horizon sand mill in Oil & Paint Technology

A: A Horizontal Bead (Sand) Mill is a type of grinding machine that is used to disperse and grind…

Q: Temperature measurement is done using a mercury thermometer; which is protected by a thermowell.…

A: The order of mercury thermometer is to be mentioned with detailed analysis.

Q: Sketch the (220) plane for CaF2

A: x y z INDICES 2 2 0 RECIPROCAL  1/2 1/2 1/0 INTERCEPT 1/2 1/2 ∞

Q: Please discuss "Drilling problems related to drilling fluid rheological property"

A: Drilling muds or fluid is sued as carrier of rocks produced during the oil and gas drilling…

Q: Reynolds analogy is preferred over Chilton-Colburn analogy. O True False Depends on Sh O Only for…

A: Chilton Coulburn analogy is widely successful analogy used for estimating mass transfer…

Q: Q/ explain about effect wettability on 1- Saturation 2- Porosity 3- Relative permeability 4-…

A: To Explain The effect of wettability on saturation, porosity, relative permeability and capillary…

Q: mm diameter glass tube is inserted into an open glass of water (contact angle between the tube and…

A:

Q: Explain analogy between heat and momentum transfer

A: The most widely accepted analogy between Heat, mass and momentum transfer is Chilton-Colburn…

Q: Sketch the cross flow induced-draft cooling tower and illustrate all its parts.

A: Induced draft cooling towers Induced draft cooling towers are of two types based on the nature of…

Q: sphericity

A:

Q: With the help of a neat drawing of a condenser, discuss its design procedure with the important…

A: condenser and its design

Q: Represents and describes by means of a diagram the main parts of the evaporation equipment.

A: Evaporation  It is the process of concentrating the stream by removing water. The process is energy…

Q: The first step in the production of nitric acid from ammonia involves the oxidation of NH3. 4 NH3…

A: The oxidation reaction of ammonia is given.

Q: What are the materials specifications of internal floating roof storage tank?

A: The materials specifications of the internal floating roof storage tank are to be mentioned.

Q: Which of the following is not a unit of surface tension? * All choices are units of surface tension.…

A: Ans d) poise is not a unit of surface tension

Q: temperature at a depth of 7.5 cm 4 min after the surface temperature is changed

A: Heat transfer is the phenomenon in which heat or energy is transferred from the higher body…

Q: Explain the difference (in concept or definition) between boundary layer thickness and thermal…

A: To answer difference (in concept or definition) between boundary layer thickness and thermal…

Q: Describe laminar and turbulent regimes of fluidization

A: The turbulent fluidization regime is happened in between the bubbling and fast fluidization flow…

Q: Using Figure, determine the following properties of the magnetic material: remanance, saturation…

A: The remanence (Br)  is calculated as the measure of remaining magnetization if the driving field is…