What can be concluded from the computed average percent error with reference to the tolerance of the resistors? ResistMeasuredTheoreticalPercentageErrorMeasuredorResistanceResistanceResistance(Analog)(Digital)100 Q(Color Coded)1000 +5%A0%B200 Q2000+5%0%C300 Q300015%0%400 24000+5%0%500 Q5000+5%0%Average Percent Error =0%

Reporting an observed value with zero error is abnormal. Error is inherent in an experiment.

Answered: What can be concluded from the computed…

Science

Physics

What can be concluded from the computed average percent error with reference to the tolerance of the resistors

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

a) Develop circuit diagram of SR latch using NAND gates on circuit maker. b) Fill a truth table below for developed SR latch in part (a) S R 1 1 1 1 +
Please asap
Problem2:. Consider the circuits shown below. (a) Write the equation for current using the junction rule. (b) Write two equations using loop rule (c) Use these equations to find I₁, I2, and I3? (b) What is the power dissipated across each resistor (1²R)? V₁ = 24 V 12 R₂ = 62 R₁ = 80 ½ 13 R₂=402 + ₂10 V
In a potentiometer experiment e.m.f. of a cell is balanced by a length of 150 cm on the potentiometer wire. When the cell is shunted by 10 resistance, the balancing length is 90 cm. Then find internal resistance of cell.
The wattage of a resistor is the maximum power a resistor can safely dissipate. If two resistors R1 = 25 Ohms and R2 = 44 Ohms, each having a wattage of 13 W are connected in series, the maximum voltage that can be applied across the combination without exceeding the wattage of either resistor is equal to ____ V.
What would happen to the temperature and the resistivity value of a wire if the current were very large?
A lead was connected to the battery first with a 2 ohm resistor and then with an 8 ohm resistor. The power released in this case in the external circuit is the same. Find the internal resistance of the battery. What is the efficiency of the battery in both cases?
Needs Complete typed solution with 100 % accuracy.
A metallic wire is stretched from original length of 1 m to 5 m. If the original cross-sectional area is 4 square millimeters and original resistance is 6 ohms, determine the new resistance (in ohms) of the metallic wire. Assume the volume of the wire is preserved. NOTE: Express your final answers accurate to four decimal places; avoid rounding off intermediate values in the solutions to avoid deviation due to rounding-off within the solution.
Three resistors are in series R₁ = 14ohms, R₂ = 17ohms & R, = 20 ohms. Calculate the equivalent resistance The same three resistors are now connected in parallel, what is the equivalent resistance?
Assuming a constant temperature coefficient of resistivity, what is the maximum percent decrease in the resistance of a constantan wire starting at 20.0oC ?
draw the solution uc (t) of the RC when RC =t=1 and the input u(t) is a unit step HE diferencial para este ca