Answered: What are the two main synchronization…

Engineering

Computer Science

What are the two main synchronization problems that can occur during message transmission? (max of 3 lines)

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Related questions

Q: . Which of the following is a characteristic of unshielded twisted-pair cabling? (Choose all that…

A: This mcq is related to network cables.

Q: Give out alteast 5 differences of synchronous TDM and statistical TDM

A: The Answer is

Q: Enumerate solutions to decrease propagation delay.

A: Enumerate solutions to decrease propagation delay.

Q: How many faults can a parity bit detect in a message?

A: A parity bit is a simple error-detection mechanism used in data transmission. It is an extra bit…

Q: Please offer a brief justification for your answer to each of the following questions. The…

A: Explanation: SR: It is a selective repeat technique that is used in the OSI model's data link layer…

Q: Synchronous transmission is often used on both point-to-point and multipoint circuits *

A: I Have answered this question in step 2.

Q: How do serialization techniques factor in redundancy and error correction for data transmission in…

A: - We need to talk about how serialization techniques factor in redundancy and error correction for…

Q: a) For the following two cases between the transmitter and receiver in a wireless network, compute…

A: To connect with a receiver or other devices in a wireless network, a transmitter is a device that…

Q: H.W: If the bandwidth of PAM system not exceed 4kHz is used to transmit voice signal sampled at…

A: PAM (Pulse Amplitude Modulation) involves varying the amplitude of pulses in accordance with…

Q: GSM time slot is 577 s (microseconds) in duration and includes far more than a snapsho signal

A: The answer is

Q: In synchronous transmission, 5 eight bit characters are included in 30 eight bit information…

A: To find the bit rate of receiver.

Q: In On- Off keying, the carrier signal is transmitted with signal value 1 and '0' indicates O No…

A: In On-Off keying, the carrier signal is transmitted with signal value '1' and '0' indicates: No…

Q: TCP utilises sliding windows for flow control. a) With the aid of a time sequence diagram,…

A: ANSWER: TCP flow control and the sliding window: Transmission Control Protocol (TCP) involves a…

Q: The term 'duplex' refers to the ability of the data receiving stations to echo back a confirming…

A: Communication in a Computer Network refers to the exchange of data and information between devices…

Q: In a synchronous communication

A: According to the question we need to tell: In synchronous communication, the clock frequency of the…

Q: Please provide illustrations of synchronous and isochronous connections?

A: The connections used while transmitting data are crucial in preserving the accuracy and…

Q: Please offer a brief justification for your answer to each of the following questions. The…

A: It is a selective repetition technique used in the OSI model's data connection layer to ensure the…

Q: (a) Find CRC code for message bits to be transmitted which is 11001110 with generator value 1011…

A: There are multiple questions. Here solving only the first question. If you want to solve the second…

Q: Q2) A DMS sends a message with alphabet size equal to 6 symbols at 100 symbols/secs. Symbol k is…

A: According to the information given:- We have to calculate the information rate and the transmission…

Q: Which of the following was NOT a design goal of the Internet? Provide reliable communication.…

A: Which of the following was NOT a design goal of the Internet? Provide reliable communication.…

Q: In Token Ring, Which of the following is not a transceiver function ? a. Transmission and receipt of…

A: Here given in the question In Token Ring, Which of the following is not a transceiver function…

Q: How do synchronous and isochronous connections vary, and what do you see as the advantages and…

A: Synchronous and isochronous connections are two different approaches to data…

Q: Select the statement that is false. UTP cable is unshielded. Twisting two pairs of wires results in…

A: The twists in the wire reduces the crosstalk but the number of twists increases doesn't reduce cross…

Q: (a) As a test engineer in SONNY factory, you need to test and simplify the logic circuit as shown in…

Q: What exactly are synchronizing transmissions?

A: Definition: Transferring data in precisely scheduled chunks is referred to as simultaneous. These…

Q: What is the signal to send through the medium if the sequence of bits to carry is 1110010101 - if…

A: We need to find the signal to be sent for the given sequence using Differential Manchester encoding.…

Q: 1a) What are three advantages of VLANs? 1b) What is the difference between legacy inter-VLAN routing…

A: Virtual Local Area Networks (VLANs) play a crucial role in modern network management, allowing for…

Q: Calculate the utization of a 100 m long 100 Mbps coaxial CSMACO system that transmits 10 Kb packets.…

A: Given that, Distance= 100 m Bandwidth= 100 Mbps Length of packet= 10 KB Propagation speed= 2*108…

Q: hexadecimal are 08 and 06. Obtain the checksum. (b)Explain in detail each field of IPv6 header

A: a) The checksum is an error detection mechanism that is used to identify problems in transferred…

Question

What are the two main synchronization problems that can occur during message transmission? (max of 3 lines)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Introduction:

VIEW

Step 2: Explanation:

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

210. Which of the following statements is correct ? a. Protocol converters are usually operated in b. Protocol converters are the same as TDMs c. Protocol converters are the same as multiplexers d. Protocol converters are usually not operated in pairs
5. (True or False) Based on the light coupling requirements of the operator's network, the 5G backhaul network and the 4G backhaul network are completely isolated, and no interconnection is required. True False 6. (True or False) In the 5G NR, the modulation mode is 256QAM for the physical uplink control channel PUCCH. True False 7. (True or False) If the EPC+ of the Option 3 of the 5G networking solution adopts the NFV-based cloud architecture, it can be upgraded to 5GC that supports Option 2 networking. True Flase
Do comparison of Transmission and Propagation delays.
14. The signal to noise ratio on your phone line is 1000:1 and your modem attempts 7000 symbols per second, with each symbol representing 6 bits. a) What is the data rate that your modem is attempting? b) If the bandwidth on the line is 3000 Hz, what is the maximum theoretical data rate? c) Check all three limits, show your work. exceeded? Which of the three limits were
5) How many characters per second can be transmitted over a 1200-baud line in each of the following modes? (Assume a character code of eight bits.) a. Synchronous serial transmission. b. Asynchronous serial transmission with two stop bits. c. Asynchronous serial transmission with one stop bit.
(e) SSUET Network gateway, & Mbps, packet size 1000 bytes, Arrival rate of 125 packets/sec. What is the probability of overflow with only 12 buffers? – How many buffers are needed to keep packet loss to 1 in 1,000,000?
Imagine the length of a cable is 2500 metres. If the speed of propagation in a thick co-axial cable is 60% of the speed of light, how long does it take for a bit to travel from the beginning to the end of the cable? Ignore any propagation delay in the equipment. (Speed of light c = 3 x 108 metres / sec)
Because synchronous transmission always uses the same block size, the receiver always knows when one block finishes and another starts. a. true b. false
Can you please explain how to get this?
I need the answer as soon as possible