What are the basic five stages of the RISC pipeline, and explain the functions of each stage

Q: We need to generate a PWM signal with frequency of 2 KHz, and duty cycle of 20%. The clock frequency…

A: According to the question, we need to generate a PWM signal with a frequency of 2 KHz, and a duty…

Q: Q2) Write an assembly code to move the contents of memory location 0600H to BX register then to CX…

A: Write assembly code for given statements

Q: xplain the role of stack register in 8086 microprocessor. Subject is Introduction to Embedded…

A: Use of stack register in 8086 microprocessor :-  A stack register is used to hold the information…

Q: Group V Q1) List the main internal elements of a microcontroller. And explain the function of each…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: (i) Draw the block diagram for getting controlled AC output voltage from AC input voltage.   (ii)…

A: Part (i): The circuit diagram for the single-phase full-wave AC controller is given by:

Q: The input waveform shown in the figure below is applied to an inverter, which is used to operate a…

A: The input waveform shown in the figure below is applied to an inverter, which is used to operate a…

Q: Evaluate the following statements: i. R13 is traditionally used as the stack pointer and retaining…

A: The registers R13, R14, and R15 of ARM processors use as: R13 work as a stack pointer and stores…

Q: Which statement is not true for a source encoder? a. reduces the size of the data b. Converts…

A: The source encoder uses the following rules: The source encoder is liable for compacting the…

Q: 4) Suppose we have a 4-stage Johnson's counter, and its content is initially 1001. What is the…

A:

Q: What is interface. What is program block and module block.

A: To verify a design we write verification module and  test bench to check that it meet specification.…

Q: 1- What does the VoH parameter of a logic IC refer to? a) The highest permissible output voltage. b)…

A: VOH  parameter of a logic IC refers to " The lowest output voltage recognized as logic 1 ".

Q: Option 4: 50,250,350,550

A:

Q: Discuss the key characteristics of Unipolar Logic Families and Bipolar Logic Families. What points…

A: The digital integrated circuits are designed using bipolar devices or Metal Oxide Semiconductor…

Q: digital electronics 2 In which option is the logic circuit equivalent of the RTL circuit given in…

A: Given :    Here they have mentioned the the sister transistor logic circuit.     From the given…

Q: The no. of turns in secondary winding is more than that of primary winding. The output voltage is…

A: The no. of turns in secondary winding is more than that of primary winding. The output voltage is…

Q: electrical engineering what is the function of inverter ?

A: Inverter : A converter known as an inverter transforms DC energy (from a battery or storage battery)…

Q: Q4) What is the term "Complex Instruction Set Computer(CISC)" mean in the Microcontroller…

A: CISK ( Complex Instruction Set Computer) & RISK ( Reduced Instruction Set Computer) are two…

Q: Output voltage of an inverter is controlled by multiple pulse modulation technique. If the peak…

A: Given- Peak value of reference voltage Vr = 4 V, Peak value of carrier voltage Vc = 6 V, To Find-…

Q: Find the RMS voltage expression of output phase voltage of a balanced three-phase square wave…

A: Balanced three-phase square wave inverter: Consider a 3-phase voltage source inverter (VSI) feeding…

Q: 2-bit by 2-bit binary multiplier using ROM VHDL code

A: A multiplier is an electrical circuit that multiplies two binary integers in digital electronics,…

Q: For a microprocessor similar to ATmega328p an 8 bit ADC uses a VREF= 3.3 V. When an analog read is…

A: We need to find out input voltage for given output .

Q: 4) Design and draw these memory units with their control circuits. Explain operations. a) A single…

A: As per the rules we can answer only one question, please post the remaining questions as the…

Q: Give me right solution otherwise leave it. A voltage signal with a range of zero to 115 V. is to be…

A: We know formula for resolution .

Q: List and describe two AVR instructions. As part of your description make sure that you list the…

A: In the year 1997, AVR 8-bit microcontroller platform was first released. This type of…

Q: The efficiency of the inverters is high because of the control signal frequency is very high.…

A: High switching frequency will cause on the load harmonics. Harmonics can defects on the sinusoidal…

Q: show the classification of semiconductor memories.

A: Please refer the attached images for the complete answer..

Q: Explain the program memory structure of 8051 microcontroller.

A: 8051 microcontroller is designed in the year of 1981 by INTEL. It is an 8-bit microcontroller, have…

Q: Discuss 5 differences between standard microprocessors and microcontrollers b)Describe the RISC…

A: In first questions deals with standard microprocessors and microcontrollers, the second deals with…

Q: Write a simple complete program with LOOP instruction for 8086 microprocessor, and explain the…

A: Loop instruction comes under the iteration control instructions. It's objective is to achieve…

Q: To interface 1.5us access time memory chip with 5MHZ CLK 8086 processor, need to insert wait states.…

A: fclk = 5 MHz Tclk = 1/ fclk = 0.2 microsec t= n×Tclk 1.5 us = n×0.2 us n = 7.5 8086 allows upto 3…

Q: * Include memory elements and combinational circuit Sequential network Integrated circuit O…

A: Includes memory element and combination circuit

Speed control of motor

Speed control by DC motor-speed controller is required to realize variable speed drive. Whenever a motor drives a particular load, it is called drive, and variable speed drive refers to a load requiring variable speed. All this is obtained by a DC motor speed controller.