we 十

Q: For a soil sample in a natural condition, void ratio (e) is 0.67, degree of saturation (S) is 75%, G...

A: e=0.67 S=75% Gs=2.7

Q: A cylindrical buoy is 2 m in diameter and 2.5m long and weighs 22 kN. The specific weight of sea wat...

A:

Q: The assembly consists of three disks A, B, and C that are used to support the load of P. The load P ...

A: Stress=LoadArea σbearing=σbearing (allow) LoadBearing Area of disk A= Allowable bearing stress 328×1...

Q: A line has a magnetic bearing of S. 4° 30' E. in 1990 when the declination was 1° 30' E. What is the...

A:

Q: 2-17. The 150-lb force of Fig. P2-17 is the resultant of the two forces shown and the couple and two...

A:

Q: Soil mechanic

A: When,Liquid limit WLWL < 50% ⇒ LowWL > 50% ⇒ HighHere, L.L = 20%So, LowFor the sieve no. 10 va...

Q: Define tropopause.

A: The earth's atmosphere can be classified into four layers, Troposphere Stratosphere Mesosphere Exos...

Q: The ball ( D) has a mass of ( 15 kg ). If a force of (F = 80 N ) is applied horizontally to the ring...

A: The above problem is solved by using the static equilibrium equation like  ∑Fx=0 ,∑Fy=0 and with the...

Q: 4-102. Replace the loading system acting on the post by an equivalent resultant force and couple mom...

A: Hi there! since you have asked multiple questions, we will solve the first question for you. If you ...

Q: Help With My Homework Question Please. I will leave a thumbs up and good review! Thank you!

A: a) Soil A:-  Sand=20% Silt = 30% Clay = 50% Hence, the Classification according to U.S. Department ...

Q: Determine the bar force of member BD (in kN) of the truss shown if P- 10 kN and Q = 50 kN.

A: Given: The value of P is 10 kN. The value of Q is 50 kN. Consider the figure,

Q: Q/Consider steady, incompressible and flow through a reducer in a horizontal pipe where the diameter...

A: d1=20cm d2=10cm P1=150kPa P2=50kPa

Q: 24 MPa in tension and 30 MPa in compression. Determine the largest couple M that can be applied to t...

A:

Q: F4-20. Determine the resultant couple moment acting on the triangular plate. 200 lb 150 lb 4 ft 4 ft...

A:

Q: H.W.1: A rigid steel bar ABC is pinned at B and supported by two rods at A and C. There is no strain...

A:

Q: Determine the slope angle for an infinite slope that is made using a soil with no cohesion and havin...

A: given: internal friction = 300  FOS = 1.5  

Q: 400 시 4m 는 600 N 3m

A: using equilibrium equations we can find reactions at support 

Q: Q3) Determine the force in member CD of the loaded truss. 1 m F A 1 m B E 45° C 45° 2 kN 5 kN

A:

Q: A car traveled at a rate of 50 km/hr for 8 minutes and then at 25 km/hr for 7 min and finally at 20 ...

A:

Q: Q:: A quarter circle gate AB of 1.5 m radius and 3 m wide, hinge at B, find the vertical force F exe...

A:

Q: Three cables pull on the pipe such that they create a resultant force having a magnitude of ( 900 lb...

A:

Q: The tank is filled with water under pressure (19.62 kPa). The length of tank =2m. an empty cylinder ...

A: Step 1

Q: HOMEWORK Q/A two-dimensional flow field has velocities along the x and y directions given by u x2t a...

A:

Q: EX.1 A soil sample has a unit weight of (1.9gm/cc) and the water content=12%, if Gs=2.65, determine:...

A: NOTE : Since you have asked multiple questions, we will solve the first question for you. If you wan...

Q: Calculate DOl and identify the following structure as determinate, indeterminate, or unstable. Your ...

A: Determinate structure- When equilibrium equations      ∑FX=0,∑FY=0,∑M=0 are sufficient to determine ...

Q: Q1:- A steel cylinder floats on water, find the relative density of cylinder if the depth of submerg...

A: Given: The value of h is 70 mm. Consider the figure,

Q: I’m stuck please help me! I will leave thumbs up! Show work so i can understand please!

A:

Q: Q:/Gage A shown in Figure No (2) reads 4 (Bar). Find the reading of Gage B. If the value of PA is no...

A: PA = 4 Bar = 4×105  N/m2                 (1 Bar = 105  N/m2 )To find:PB = ? NOTE : Since you have as...

Q: If force F is to have a component along the N, determine the magnitude of F de of its component F, a...

A: Solution:  Given data Fu=6 kN Angle B=105° Angle C=30°(Angle sum property)  

Q: 60 N 0.75 m 1m 90 N

A:

Q: HOMEWORK Draw S.F.D. and B.M.D. for Beam JZ below by using the Moment Distribution Method. 14.1 kN/m...

A:

Q: Q3/ For the beam and loading shown, determine the maximum normal stress due to bending. 150 kN 150 k...

A:

Q: How can we prevent and control house fires accident caused by electricity or the long-term use of si...

A: House fires accident caused by electricity; Understanding the common causes, warning signs and an ap...

Q: F4-9. Determine the resultant moment produced by the forces about point O. F2 = 200 lb 6 ft 6 ft |30...

A: Consider the figure,

Q: H.W: determine the magnitude of the resultant and the direction measured from the horizontal line. 8...

A: Direction Of force FA  is not given Assume Direction of force FA  from vertical is 50°Then foce on j...

Q: A soil strata can be described as 6 metersof sandunderlain by 4 meters of clay with the water table ...

A: Solution: Given Data: As per the diagram Effective stress at the middle of the clay layers will be ...

Q: In road pavement design, the standard vehicle axel is defined as an axel with two single wheels as s...

A: The vertical stress increment in soils due to point load on the surface is given by, ∆σ=Qz2Ip Where ...

Q: A surveyor runs a line N35° 30’ 30”E from A to B, the length of AB being 1246.50 feet. From B, he ru...

A: In the triangle, while calculating the angle and the length of the side a, b, c, and angle of three ...

Q: I need help in 10 meintes please

A: Given data Line load Circular load Strip load I ll use Boussinessq's equations to solve it.

Q: Compute the bearing, azimuth and interior angles of a five-sided closed polygon whose angles to the ...

A:

Q: Qu 800N De lermine the direction aned S0ON magnitude of the resultant of the four 620N the forces sh...

A:

Q: For the footings shown in figure, calculate the increase in stress at point (A) at the depth of (3 m...

A: Vertical stress in soil: The vertical stress due to the different cross-sections of loading is measu...

Q: can someone answer this question? thank you

A: According to AASHTO HL 93 losding is load combination of truck Axeles1 st (front) axel is sibjected ...

Q: 3. A soil layer consists of 4 meters of sand underlying 5 meters of clay. The water table is nat- ur...

A:

Q: Q3:find the moment force of the system shown on point A. F = 375 lb F = 500 lb -8 ft- 6 ft -5 ft Gro...

A:

Q: Discuss Drilling Techniques in Competent Soils

A: Drilling is a cutting process that uses a drill bit to cut or enlarge a hole of circular cross secti...

Q: Need explanation

A: The term magnitude is defined as the distance or quantity. it shows the direction or size that is ab...

Q: Q4) Let vector A = 5i+2j , vector B = -3i-5j, and %3D vector E = (2A) + (3B) . (a) Write vector E in...

A:

Q: 10.87 What power must be supplied by the pump to the flow if water (T = 20°C) is pumped through the ...

A: Bernoulli's Equation: It states that the sum of potential energy, kinetic energy, and other pressure...

Q: EX.No.2: A beam with an inverted tee-shaped Cross Sechia Carries a uniform distributed load of 5 kN/...

A: