Voltage (V) 120 100 80 40 20 0 0 30 Time (us) The load must be predominantly resistive. The average current in the load is 1.0A. The RMS current in the load is approximately 1.414A. The load must be predominantly inductive. The resistive part of the load is 200ohms. The average current in the load is 0.6A. The resistive part of the load is 50ohms. Voltage across load 10 20 40 50 60 Current (A) 2 1.5 0.5 0 10 Current through load 20 30 Time (us) 40 50 60

Voltage (V) 120 100 80 40 20 0 0 30 Time (us) The load must be predominantly resistive. The average current in the load is 1.0A. The RMS current in the load is approximately 1.414A. The load must be predominantly inductive. The resistive part of the load is 200ohms. The average current in the load is 0.6A. The resistive part of the load is 50ohms. Voltage across load 10 20 40 50 60 Current (A) 2 1.5 0.5 0 10 Current through load 20 30 Time (us) 40 50 60

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter7: Symmetrical Faults

Section: Chapter Questions

Problem 7.21MCQ

See similar textbooks

Similar questions

The step down DC chopper uses DC source voltage V(dc) = 200 V and resistive load impedance of 10 ohm. The duty cycle is 0.4 the voltage drop across the switch may be taken as zero, Calculate : (a) Average and RMS value of output voltage. (b) Average and RMS value of output current.
what is the use of DC/DC tension converter DC/DC booster MT3608
Combination circuit what is PT? RT? IT? Voltage Across each load?
Write down the Kirchhoff rule for the circuits.
In a buck converter, what are the benefits and disadvantages if the changes of duty cycle is drastic i.e, fast system response? How about when duty cycle changes slowly i.e, slow system response?
a) The transformer has a turns ratio of 9.45, what is the dc load voltage considering the ripple voltage? b) The transformer has a turns ratio of 9.45, what is the dc load voltage without considering the ripple voltage?in 2 decimal places.
What is the difference between OLTC and transformers
Electrical Engineering How to measure the electric field intensity at 2m away from a Parallel coupled microstrip lines in HFSS?
1- spark gaps testing method is applicable for testing 2- the electrical circuit that we use to measure high voltages and is not affected by frequency change 3- We can say high voltages if exceed ------------ V (Alternating voltages) 4- Transient voltages which are caused over voltages be in two forms 5- High voltages can be generated for testing in three ways ------
Q5. For the following center tapped transformer, show the waveform across each half of the secondary winding and across R, when a 100 V peak sine wave is applied to the primarywinding. What is the PIV rating must the diodeshave? (Use constant voltage drop model for the Silicon diode) D IN4001 OV 10 kN IN4001 DELL
DC-AC Circuits Approximately, how long does it take the circuit to have a current near 5A upon closing of the switch? 5V 5H O A. 25 seconds B. 5 seconds O C. 1 second D. O second O E. 0.2 seconds
circuit question