Vin (t) R$ www a ip(t) Np:Ns + Up (t): ell ● is(t) + v₂(t) I ww RL For the above transformer circuit, given the following: Vin (1)-190sin(2x600) V R$ 100 RL 300 No Na - 2:5 determine Req ab to the right of the (a,b) terminals. Just enter your answer without units as your submitted answer rounded to the nearest single digit decimal. For e if you determine Req,ab-36.53 Ohms, then just enter 36.5 as your submitted answer.

I need answer within 20 minutes please please with my best wishes

Draw the block diagram and explain the basic components of Numeric relay

Design a fritzining scheme for sign language translator glove should include breadboard, hc-05 bluetooth, adxl335, 5xflex sensors, 10k resistors and arduino nano. Please explain detailed connections i am new about arduino and breadboard connections.

Refer to the National Electrical Code® or the working drawings when necessary. Where applicable, responses should be written in complete sentences. For problems 1 and 2, six luminaires, similar to Style E used in the Commercial Building, are to be installed in a room that is 12 ft x 18 ft (~3.7 m x ~5.5 m) with a 9 ft (2.8 m) floor-to-ceiling height. The spacing ratio for the luminaire is 1:0. 1. The maximum distance that the luminaires can be separated and achieve uniform illuminance is ft ( m). For problems 2-5, two luminaires, 8 ft (2.5 m) and 4 ft (1.2 m) in length with dimensions as shown in Figure 15-7, are to be installed in tandem (end to end). The end of the long luminaire is to be 2 ft (600 mm) from the wall. 2. The center of the outlet box should be roughed in at ft ( m) from the wall. 3. The first support should be installed at the wall. ft ( m) from 4. The second support should be installed at from the wall. ft ( m) 5. The final support should be installed at the wall. ft…

i need the answer quickly

5. Labeling the pin numbers of 7432 IC

Electronic Question(SV) What is procedural Hook up?

Please help with full explanation:

Answer the questions below. (Insert the numerical value only, do not use ,+, *, or) The Relative error for your answer should be less than 0.01, which means if the answer was 50, then the error should not exceed 50°0.01= +0.5! if the answer was 230, then the error should not exceed 230°0.01= ±2.3! if the answer was 2.31467 10^-3, then you should enter this value: 0.00231467, not this 0.0023 !!! Given the system shown, if L=0.275H and C=0.4F, then the value of R that yield 15% overshoot is (the output is the current through the inductor): ohm io(t) i(t) ↑ R . the value of the natural frequency is: rad/sec The value of the damping ratio is: