v) Convert Decimal to Hexadecimal (a) 974510 (b) 2976.5410

Q: Use voltage divider rule to determine V2 and V1. * 16 N 54 1 E 80 V V: 36 N 18 N

A:

Q: Get the phase of the AC signal defined by c(t) = 2 sin (wt + 70°) %3D

A:

Q: Q 4. ... Write statement of maximum power transfer theorem with limitation & find the maximum power ...

A: Maximum power transfer theorem (MPTT):  Statement: MPTT states that the load resistance must be equa...

Q: A three-phase 50 Hz, 200 MVA, 220/66 kV transformer has a clock number of Yd11. The transformer wind...

A: We are authorized to answer three subparts at a time. Since you have not mentioned which part you ar...

Q: Find the output voltage vo (t) for the circuit shown in Figure 1. 6 H + 2 H Vo (1) v.(1)=24cos(4/...

A: Here, we have given an electrical circuit, having no. of components in series and parallel manner.  ...

Q: 19 -1 Q. For the matrix X = 0 -1 2. the eigen vector corresponding to eigen value a) (2,1,-1) b)(1,-...

A: Given matrix  X=1-110-11002The eigen value is λ=-2

Q: 400 Consider a closed-loop system with a zero-order hold. Consider G, (s) = - s2 + 400 Determine the...

A: Given   Gp(s)=400s2+400T=1 sec

Q: In this network, the switch K is closed at t = 0, after achieving a ady state while the switch was o...

A:

Q: 1. a) Use node voltage method to find vo in the circuit in Figure 1. b) Find the power absorbed by t...

A: Circuit is given as,

Q: V(vout) I(R2) Ons 0.85ns 0.90ns 0.95ns 1.00ns 1.05ns 1.10ns 1.15ns 1.20ns 1.25ns 1.30ns 1.35ns 1.40n...

A: a) delay time The time to reach 50% of steady state value is delay time For graph 1 Delay time = 1.6...

Q: 7- Find Fourier transform X(jw) of; (5) 1. fel < TI x(t) 0. T < Irl <Tf2

A: 7. xt=1 ,       t&lt;T10 ,       T1&lt;t&lt;T2          

Q: A sinusoidal voltage of 50 Hz has a maximum value of 282.8 volts. At what time measured from a negat...

A: I am attaching detailed solution image of this question.

Q: By using Boolean algebra simplify (A + B' +C) (AB + A' C')'

A:

Q: introduction an explanation about voltage regulation of an alternator

A:

Q: Find out the Laplace transform of the function x (t) = u(t – t,)

A: In this case, the Laplace transform of the following function is to be determined: xt=ut-t0

Q: Consider the combinational circuit shown 1. Derive the Boolean expressions for T1 through T4. Evalua...

A:

Q: 3. Can a series connection of two BIBO unstable systems ever be BIBO stable? What about a parallel c...

A:

Q: C. Use this graphic for Question 3: R, = 1.2 k2, R= 3.6 k2, R, = 3.2 k2, and V, = 12 V R1 +V1 1 V R2...

A:

Q: Describe how electric fields are similar to gravitational fields and how they differ. Explain it

A: Field- Field is defined as the area around magnet, coils, etc. in which the effect of them is experi...

Q: 134 Chapter 2 Resistive Circuits V1 5Ω V2 1 A 10 Ω 0.5i 20 Ω Figure P2.57

A:

Q: Refer to the Graphic B. What is the current through R1? 5.34 mA O 2.73 mA 6.23 mA 3.90 mA None of th...

A: Option a 5.34 mA Ue basic ohms law Current = voltage / resistance Here current through R1 is the tot...

Q: Find i and Vo in the circuit. * I 10 Q 24 Q 500 3 25 2 25Ω 15 V 20 Ω 30 Ω V. 60 NN Z 20 2

A:  Resistors 60 Ω and 20 Ω are in parallel. Their equivalent resistance is 20 X 6020 + 60 = 15 Ω.

Q: 24. A 3 phase, 4 – wire, 400 V symmetrical system supplies a Y – connected load having the following...

A:

Q: Design the circuit in the box to perform the function indicated in figure below Silicon diodes 10 V ...

A: Silicon diode- Silicon diode is a diode which have both charge polarity and allow current to pass th...

Q: Two shunt generators A and B operate in parallel and their load characteristic s may be taken as s...

A: It is given that: EgA=240 VVA=220 VIA=200 AEgB=245 VVB=220 VIB=150 ACommon load supply=300 A

Q: Calculate the total power when three identical resistances each of 10 Q are connected wye when conne...

A:

Q: S3-1. Consider the following network. For Vin a positive step from 0 to 3 V at t= 0, plot the t depe...

A: Given the circuit network as shown below: For Vin a positive step from 0 to 3 V at t=0, we need to ...

Q: A particular 15 kHz modulation tone results in a peak frequency deviation of 75 kHz. What is the mod...

A:

Q: A 3-phase, delta-connected alternator supplies a wye connected load, each phase of which has a resis...

A: I am attaching detailed solution image of this question.

Q: Fill in the blanks with the colors of the resistors corresponding to their values

A: The color-coding in the resistor is used to identify the value of the resistor along with the tolera...

Q: find the AREA bounded by a cylind rical aoordineste P=2m 6= 0+2 Lelom b. 号r m C.

A: The solution is given below. 

Q: Q5. The diode is considered shorted when both anode and cathode has a) Low resistance b) High resist...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: a 3.2 52 b 502 1002 Wr 3.23 20 d e W- 252 7503 - f

A:

Q: Vcc +10 V Rc 10 kn Rg 100 kn Boc = 100 0.7 V Fig3.

A: The given circuit diagram is shown below:

Q: R R 400 Volts Y Y B B.

A: The given circuit diagram is shown below: It is given that: VL=400 VIL=50∠-30° A  

Q: Find V in the circuit below. 10V 12VO -8-

A:                             Since the polarity of VT is not shown, it assumed as shown in Fig. 1.

Q: |39

A:         XOR gates in digital logic are used for producing outputs when two inputs are not the same t...

Q: Problem 6. A d.c. circuit comprises three closed loops. Applying Kirchhoff's laws to the closed loop...

A: Determinants Method There are three methods of solving equations. The determinants method is a squar...

Q: A three-phase uncontrolled bridge rectifier delivers power to a resistive load of 102. The output vo...

A: It is given that: RL=10 ΩVo=400 V

Q: Question 8 For the cascaded CE and CC amplifier configuration as shown below, Vcc +15 V RC 1.5 k2 R ...

A:

Q: (b) Why sinusoidal wave is widely used? Calculate real power, reactive power, apparent power, power ...

A:

Q: determine:IBQ,ICQ,IEQ,VCEQ,VB,VC,VBC

A:

Q: A voltage V = 230 sin(377t +30) volts supplies power to a coil with 10 ohms resistance and 100 mH in...

A:

Q: Solve for Vo. 2 ka 10 V 1.2 ka Si 20 V 2kQ 4.7k -2 V (a) (b) a. Vo=Blank 1V b.Vo=Blank 2 V Blank 1 A...

A:

Q: 1. Refer to Graphic A. The total resistance of the circuit is most near.

A: This question belongs to circuit theory . It is based on the concept of calculation of total resista...

Q: FIND THE CURRENTS AND voltages in the CIRcuiT SHOW 2Ω 4Ω + 5 V 3 V + +

A: Given circuit shown 

Q: 1202 202 13R

A:

Q: 3. Determine Vo for each netuerk for the ilp shawn. Vi 3V Vig - 8v 2:2Ki si

A: Given: Input voltage shown, And a circuit To find: Output voltage

Q: Find the branch voltages V1 to V4. + + MESH 1 MESH 3 3 V V1 V2 2 V + + + + 1+ V3 4 V V4 5 V MESH 2 M...

A: Apply kVL in each mesh then find the voltages V1 to V4. According to KVL sum of the voltages in clos...

Q: R R ER ER R R R R 12V R

A: Resistance: It is the property of a material that resists the flow of current.

Code Conversion

The method or technique used to convert code from one format to another is termed code conversion. Code conversions are most commonly used in computers, digital electronics, microprocessors, etc.