V₂ +1 t=0 Xww R₁ VI ww R₂ C₁ 12

Q: Three loads are in parallel take the following currents: i1 = 10 sin 314t; i2 = 20 sin (314t - 45º);…

A: Reference needed to add vector quantities So conversation is needed

Q: are connected in series across a supply of 250V. When the supply frequency is 50Hz, the current in…

A:

Q: How does the current through the inductor relate to the voltage across the inductor when the input…

A: As per barltbey guidelines for more than one question asked only first is to be answered please…

Q: A 100-mH inductor is connected in parallel to the series connection of a variable resistor R and a…

A:

Q: Q2/ For the network shown in figure (Q:), the switch has been open for a long time before closing at…

A:

Q: 6-37 Find a single equivalent element for each circuit in SS Figure P6-37. 1.0 uF 6.8 μF 75 ΜΗ -m 25…

A:

Q: Consider an LR circuit with a resistor and capacitor. The resistor has a resistance of 10.5 ohms and…

A: In this question we need to find the current in the circuit 3.5 ms after the switch is closed in…

Q: Consider a capacitor C discharging through a resistor R, as shown in the figure. a. After how many…

A: Resistors absorb active power and dissipate it in the form of active power. If Capacitor present in…

Q: The current through a 10-mH inductor is 10e-12 A. Find the voltage and the power at t = 2 s. The…

A:

Q: The voltage applied to the 622mH inductor is given by v(t)= 15est volt and IL (0)=0. Calculate the…

A:

Q: The space between the plates of a parallel-plate capacitor is filled with two slabs of linear…

A: Because of our policy only first three questions will be answered. Given: The dielectric constants…

Q: A 15 uF capacitor is charged to a potential of 110 V. The capacitor then discharged through a…

A: Given: Capacitance of capacitor, C=15  μF Capacitor charged to potential, Vc=110 V Resistors in…

Q: Design a transient state circuit using a capacitor, an inductor, and a resistance in which the…

A: We have given Design a transient state circuit using a capacitor, an inductor and a resistance in…

Q: A sinusoidal current of amplitude 10 A and frequency of 10 kHz is applied and allowed to flow…

A: If i(t) A is the time varying current flowing through an inductor of inductance L H, then the…

Q: 4. The capacitor in the figure below has capacitance C = 0.1F. The waveform of the current i flowing…

A: Given data: The value of the capacitance is, C=0.1 F. The initial voltage of the capacitor is, v0=0…

Q: A 20-µF capacitor is connected in parallel to the series connection of a variable resistor R and a…

A: Given that,A series connection of variable resistor and inductor is connected in parallel connection…

Q: A 100-mH inductor is connected in parallel to the series connection of a variable resistor R and a…

A:

Q: The switch in the circuit of figure (2) is closed at t=0, the initial value of the capacitor voltage…

A: Given circuit shown

Q: Open at l-0 A coil and a capacitor have been connected in parallel to a 12 V DC source for a long…

A: Basic problem on netwroks. Look below for the solution

Q: The capacitance specified in the circuit below is limited to 1-10nF. find the capacitance and RL…

A: XL=ωLXL=2π×10×103×30×10-3XL=1884.95 ΩXC=1ωCXC=12π×10×103×4×10-9XC=1052π×4XC=3978.87 Ω

Q: A resistor with resistance R and a capacitor with capacitance C are connected in series to an AC…

A: The objective of the question is to find the amplitude of the total current in a series RC circuit…

Q: An RC circuit has an emf of 5 V, a resistance of 10 ohms, a capacitance of 10 – 2 F, and initially a…

A:

Q: . The capacitor in the figure below has capacitance C = 0.1F. The waveform of the current i flowing…

A: Given: Waveform of i(t). C=0.1 F To find: a) Sketch and find v(t) for t≥0 assuming V(0)=0 V b)…

Q: circuit with no voltage source and the resistance of the air between the capacitor plates. On a cold…

A:

Q: Suppose that we have two 100-μF capacitors. One is charged to an initial voltage of 50 V, and the…

A: Given data, The value of capacitor C1 = 100 μF. The value of capacitor C2 = 100 μF. The value of…

Q: series RL circuit consisting of a single resistor a single inductor is being supplied by a 20 volt…

A: In this question we will find inductance value in series RL circuit...

Q: An RC circuit has an emfof 100 volts, a resistance of 5 ohms, a capacitance of 0.02 farad, and an…

A: To solve the above question, one should understand the behavior of the inductor and capacitor in the…

Q: D2.6.Three infinite uniform sheets of charge are located in free space as follows: 3 nC/m at z =-4,…

A: "Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: An RLC circuit is composed of Land What is the power factor if XL = Xc in an RLC circuit? An…

A:

Q: Rs L Rp Suppose you want to make fabrication of a capacitor by technique making a thin layer. The…

A: We convert the circuit element in the frequency-domain as…

Q: + L R V.

A: The expression for the current flowing from the resistor is given as:

Q: a) What is the maximum current at any time in the circuit? b) Write Equation of capacitor voltage in…

A: A capacitor is an electronic component that stores electrical energy in an electric field. It…

Q: of 2µF capacita

A: When the capacitance are connected in the series, the charge flowing in the capacitors are the same…

Q: and An RLC circuit is composed of_ What is the power factor if XL = Xç in an RLC circuit? An…

A:

Q: The figure below shows a simple RC circuit with a 3.10-μF capacitor, a 3.60-M resistor, a 9.00-V…

A: Given Data:A transient RC series circuit with,Battery voltage To Find:At  after the switch is…

Q: Given the following image of a practical inductor, what is true? Practical HEFF inductor Rpc RAC L…

A:

Q: An RL circuit has an emf given (in volts) by 4 cos t, a resistance of 100 ohms, an inductance of 4…

A: In this question,  Find the time t if current I= 2A reach at first time.  I= V/Z

Q: at time zero a 90uF capacitor with an initial charge of 15uC is connected across a 120 ohms…

A: In this question,  We need to determine the time if capacitor gets fully discharge.  We know time…

Q: Which of the following statements about inductors is correct?   When an inductor and a capacitor…

A: Inductor: It is a two terminal passive electrical component. When electric current flows through an…

Q: citor (C=2.6uF) is connected in series with an inductor to make a single lop circuit. A graph of the…

A: Oscillation is nothing but a variation of any parameters to and froth, and the period corresponds to…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.