Using the diagram above: Circuit is powered by 4 AA batteries each in series that are 1.5 V. The capacitor is C=50 mF when the switch makes contact on the left that is charged through the resistor that is. R1-10 ohm Switch in contact on the right, the capacitor discharges through the flashbulb with a A resistance of 1m2 that produces light. 1. How much energy would the capacitor store when the capacitor is fully charged.?( Please give answer in joules 2 significant digits.) 2. If we started with 0% of energy; and If the switch were to be then on the left how long would it take for the capacitor to reach the maximum energy of 90%? (please give answer in seconds by 2 sig figs)

Using the diagram above: Circuit is powered by 4 AA batteries each in series that are 1.5 V. The capacitor is C=50 mF when the switch makes contact on the left that is charged through the resistor that is. R1-10 ohm Switch in contact on the right, the capacitor discharges through the flashbulb with a A resistance of 1m2 that produces light. 1. How much energy would the capacitor store when the capacitor is fully charged.?( Please give answer in joules 2 significant digits.) 2. If we started with 0% of energy; and If the switch were to be then on the left how long would it take for the capacitor to reach the maximum energy of 90%? (please give answer in seconds by 2 sig figs)

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

If three resistors connected in series to a battery. Suppose R, carries a current of 8A, R, has a resistance of 7.50, and R; dissipates 80W of power. What is the voltage across Ry and Resistance of Ry ? 1. Voitage (in V) across R3 = and 2. Resistance (in ) of R: =
A solar cell, 2.5 cm squared, has an output of 350 mA at 0.90 V when exposed to full sunlight. A solar panel that delivers at least 1.2 A of current at an emf of at least 133 V to an external load is needed. Solve 2A and 2B. 2A) How many cells will you need to create the panel? Question 13 2B) How big a panel will you need, in square meters?
Answer the following 1. A voltage of 120V generates an IR drop across two resistors connected in series. If the voltage drop across R1 is 30V, what is the voltage drop across R2, in Volts? a) 80 b) 40 c) 100 d) 90 2. Three resistors R1, R2 and R3 of 20, 40 and 60 ohms are connected in parallel through the 120 V power line. What is the total current in the power line? a) 10A b) 12A c) 11A d) 15A 3. Resistors in a circuit are generally used to: a) increase the flow of the current b) decrease the flow of current c) avoid overvoltage d) decrease the power in the circuit
Both circuits have a 12V battery and three 3-ohm resistors, but they are connected very differently. The series circuit on the left shows the three resistors in series. The parallel circuit on the right shows the three resistors in parallel. Select all the statements below that are true. Select 3: 27.3 new circuit.JPG Group of answer choices In the left series circuit, the equivalent resistance is 1 ohm. In the right parallel circuit, voltage across each resistor is the same. Both circuits dissipate the same amount of power. In the right parallel circuit, the equivalent resistance is 9 ohm. In the left series circuit, current is the same through all resistors. In the right parallel circuit, the equivalent resistance is 1 ohm.
m 2R R 3. The new symbol you see in the diagram at the left is a multicell battery (like a 9V), which is made up of a number of smaller single cell batteries (like a 1.5V). Let's say its total voltage is V. A. Which resistor takes the most voltage? B. What is the total resistance? C. In variables, what is the current in the circuit? D. How does the voltage used by the 2R compare with R? E. In variables, what is the voltage used by the 2R resistor?
In the schematic below two batteries are in series and drive current through the circuit as shown. The first resistor has a voltage drop AV1= 2 V, the middle resistor has a resistance of R = 69 Q, and the last resistor has a voltage drop AV2 = 1.1 V. Given these parameters, what is the magnitude of current flowing through the circuit in milli-amps (mA)? Giver your answer to 3 significant figures. 3.0 V 4.5 V AV.
Please illustrate the problems. Only need the diagrams/ illustrations and not the answers In a given fluid, positive ions, each with three excess protons, move towards right at a steady rate of 4.5 x 1019 ions per minute and negative ions, each with two excess electron, move towards left at a steady rate of 2.5 x 1020 ions per minute. Determine the current directed to the right.An electric circuit has a battery with an EMF of 1.50 V. Its positive terminal is connected to its negative terminal by a copper wire in a circular loop having a radius of 0.500 m. Solve for the drift velocity in the wire if there is one free electron per copper atom.
The system of resistors shown in figure 1 has an effective resistance of 1.50. Calculate the resistance R of the upper resistor. Figure 1: A system of resistors.
Solve the following: 1. A certain light bulb has a resistance of 150 when lighted. How much current will flow through it when connected across a 220 V, its normal operating voltage? Draw the circuit schematic diagram>Fin 2. Find the potential difference (Emf) in a certain electric circuit with current flowing at 18 ampere and a floor Polisher connected with resistance of 12 ? 3. A 12 volts battery operates a 15 ohms digital scale for 5.2 minutes. a) Find the current flowing b) the charges Transferred with the given time. 4. What is the resistance of a conductor at 50° C if its resistance at 0°C is 1 ohm and the temperature coefficient of resistance of 9.8 x 10-³/°C 5. A silver wire has a resistance of 2.3 at 0°C and a temperature coefficient of resistance of 3.75 x 10-³/°C. What is final temperature when the final resistance is 3.8 ohms. ? 6. Complete the table: Electric Circuit and Ohm's Law V, Volts 8 volts 20 volts 10 Volts 36 volts I, Ampere 2.8 mA 40A 130mA R, ohms 156 02 25 ΚΩ…
A 0.7-F capacitor is connected in series with a 9-ohm resistor. If the connection is energized from an 11-V DC source, determine the voltage (in volts) across the resistor at t = 2.75 ms. The initial charge is 175 mC. Express your answers accurate to four decimal places. No need to put the units. Do not put spaces.
A charge of 0.060 mC flowed through a wire for 2.4 s. What was the current in this wire? answer in microamperes. how do you calculate this? I converted mC to C and I divided it by 2.4 s and I converted to amperes. i don't know if I did the conversions right or anything can someone clarify
A 0.7-F capacitor is connected in series with a 9-ohm resistor. If the connection is energized from an 11-V DC source, determine the voltage (in volts) across the resistor at t = 2.75 ms. The initial charge is 175 mC. Express your answers accurate to four decimal places. Also show how the figure below is a differential equation describing the circuit? Let q be the amount of charge in the circuit at any time t. Show full solution. dq 11 a = 63 10 dt